1. How to Make an Ethernet CAT5 RJ45 Crossover Cable

2. Ethernet Cabling (CAT5)
Required Equipment
Scissors
Ethernet Cabling (CAT5)
Crimping tool
2 RJ45 plugs
Cable tester

3. Making the Cable
Strip about 1,5cm of cabling shield from both ends – use the round area on the crimping tool
Untangle the wire
Arrange the wires in this order: white/green stripe, green, white/orange stripe, white/brown stripe and brown (A side)
Arrange the wires in this order: white/orange stripe, orange, white/green stripe, blue solid, white/blue tripe, green solid, white / brown stripe(B side)

4. Crimping
When you’ve got the order correct, bunch them together in a line. If you have some that stick up beyond the others, use the crimping tool to crop them back to a uniform level.

5. Crimping Continued
The hardest part is placing these into the RJ45 plug without messing up the order. Hold the plug with the clip side facing away from you; the gold pins should be facing towards you.

6. Crimping
When the wires are sitting tightly in the plug, insert in into the end of your crimping tool and push down .

7. Result – the light where out of sync indicating the crossover