1. U3e-L11 March 17, 2008 CLASSWORK CUT WITH BAND SAW CUT WITH SCISSORS CUT WITH HACKSAW

2. Note: Use a dowel to eject the waste from the pipe tool. Make the ½” diameter holes with the pipe tool. Motor Design, Design Drawings, and Lesson Courtesy of Fred Nastvogel stem.fnastvogel@comcast.net

3. Motor Design, Design Drawings, and Lesson Courtesy of Fred Nastvogel stem.fnastvogel@comcast.net

4. Orthogonal Views of Product SKETCH and LABEL Motor Design, Design Drawings, and Lesson Courtesy of Fred Nastvogel stem.fnastvogel@comcast.net

5. U3e-L8 Orthogonal Views of Product SKETCH and LABEL Motor Design, Design Drawings, and Lesson Courtesy of Fred Nastvogel stem.fnastvogel@comcast.net

6. Draft the given shapes on paper. Be precise with your measurements and your drawings. Cut out shapes and discard all paper scraps. CLASSWORK 2 DRAWINGS 1 DRAWING Diameter=¼” Motor Design, Design Drawings, and Lesson Courtesy of Fred Nastvogel stem.fnastvogel@comcast.net