1. ATM Technologies

2. Asynchronous Transfer Mode (ATM) Designed by phone companies Single technology meant to handle –Voice –Video –Data Intended as LAN or WAN Goal: replacement for Internet

3. ATM Characteristics End-to-end (application to application) Connection-oriented interface: –Establish “connection” –Send data –Close connection Performance guarantees (statistical) Uses cell switching

4. ATM Design Issues Different traffic has different demands Variable packet size introduces more jitter (variance in delivery time) Even sending at a constant rate, contention can result jitter Small packets incur less jitter and delay, but less efficient Large packets more efficient, delay and jitter is more serious (packet loss)

5. ATM Cell  Fixed size packet (for highest speed electronics)  Size chosen as compromise between voice (small) and data (large)  5 octet header  48 octet payload  Note: size not optimal for any application

6. ATM Cell Header

7. ATM Cell Format Flow control is used for local flow control (user-to- network only) Flow control doesn't appear in network-to-network interface Example: it can be used to provide different priorities of a cell VPI/VCI together provides identification of the cell connection (more later) Payload type indicates the type of the cell (e.g. user data cell, segment cell) PRIO: one bit Cell Loss Priority whether or not the cell can be dropped

8. ATM Switch Building block of ATM network Connections to –Computer –Other ATM switches Accepts and forwards cells

9. Cell Forwarding  Performed directly by hardware  Incoming cell sent to an outgoing interface  Uses label in cell  Motivation: highest speed

10. Label Switching ATM connection identified with 24-bit binary value Known as Virtual Path Identifier/Virtual Channel Identifier (VPI/VCI) –VPI -- 8 bit long, specifies the path the VC follows through the network –VCI – 16 bit long, specifies a single VC within a path VPI/VCI rewritten at each switch

11. Example Of VPI/VCI Rewriting Sender uses VPI/VCI 3 Receiver uses VPI/VCI 6 Intermediate VPI/VCIs are established within each switch

12. How To Set Up VPI/VCI Entries Permanent Virtual Circuits (PVC) and Switched Virtual Circuits (SVC) PVC –Similar to leased line, an entry is permanently set as long as fee is paid –A permanent path is established between two points of connection –An organization may have multiple connection (VPI/VCI) to the Internet

13. How To Set Up VPI/VCI Entries SVC –VCs are established and terminated as needed –To request a connection, the sender send a message to the switch –The switch assigns an available slot for the connection –Each pair of the switches negotiate in turn –The connection reaches the receiver –The connection is established

14. Example Of Switched Network Network makes connection on demand

15. Connection Multiplexing Typical computer has one physical connection to network All logical connections multiplexed over physical interconnection Data transferred must include connection identifier (VPI/VCI)

16. Illustration Of ATM VC Switch maps VPI/VCI –17 to 12 –96 to 8

17. ATM Quality Of Service Specified when connection established Endpoint specifies –Type of data transfer –Throughput desired –Maximum packet burst size –Maximum delay tolerated

18. Type Of Data Transfer Constant bit rate (CBR) –Example: audio Variable bit rate (VBR) –Example: video with adaptive encoding Available bit rate (ABR) –Example: data Unspecified bit rate (UBR) Each type has detailed parameters (e.g., mean, max, burst duration)

19. Sending Data Over ATM Uses ATM Adaptation Layer 5 (AAL5) Accepts and delivers large, variable-size packets AAL5 divides into cells for transmission Called segmentation and reassembly

20. Issues More expensive than traditional LAN technology More connection setup time Cell tax (header/data ~= 10%) Need to specify service requirement at the connection, some may not know which to specify Lack of efficient broadcast Complexity of QoS (Quality of Service): one can specify the request, but hard to enforce it Assumption of homogeneity