2. Mechanical Losses in An Engine P M V Subbarao Professor Mechanical Engineering Department Estimation of Curse….. One-Third of Car Fuel Consumption Is Due to Friction Loss !!!

3. Science Daily (Jan. 12, 2012) No less than one third of a car's fuel consumption is spent in overcoming friction. This friction loss has a direct impact on both fuel consumption and emissions. New technology can reduce friction by anything from 10% to 80% in various components of a car, according to a joint study by VTT Technical Research Centre of Finland and Argonne National Laboratory (ANL) in USA. It should thus be possible to reduce car's fuel consumption and emissions by 18% within the next 5 to 10 years and up to 61% within 15 to 25 years.

4. Performance of US Vehicles

5. Future Targets for LCVs

6. The Cyclic Integral k=1:for two-stroke cycle k=2:for four-stroke cycle

7. Frictional Limit of A Thermodynamic Cycle Integration of Real p-V diagram of an engine cycle will give net indicated work output per cycle. This is only an indicative work output. Only a fraction is available for use. Actual work output available for use is called as engine brake work output. Any thermodynamic cycle can be implemented as an engine. Thermodynamic model generates indicated work output and engine generates brake work output. Any thermodynamic concept is said to be practically feasible, only when engine brake power is positive and significant with respect to physical size of the engine. The difference between indicative work output and brake work output is defined as Frictional Work. The value of brake or frictional work is practically accepted as significant by comparing to the size of the engine.

8. Friction Loss As the internal parts of an engine move, they rub against each other and lose energy due to friction. The drain of power is the piston rubbing against the cylinder walls. As power output and spin rate increase, the losses due to friction account for a larger portion of the engine's gross output. This is why efficiency falls off above the "sweet spot". Oil is circulated in the engine to reduce friction, but the primary goal is to reduce wear to an acceptable level. Until recently, engine design did not go to great lengths to further reduce friction and as a result improve efficiency. Ironically, friction becomes more of a problem as engines get smaller. So, when we make an engine smaller to address the partial power problem, we give up some of the gain to increased friction losses.

9. Distribution of Fuel Power

10. Fuel energy distribution for a medium size passenger car during an urban cycle

11. Classification of Mechanical Losses Internal combustion engines involve mechanical losses due to relative motions among the components such as Piston, crank and valve trains or bearings. A mechanical efficiency of internal combustion engine (ICE) is 0% at idling and about 90% at high operating load. At the early stage of design, mechanical losses optimization is always a difficult task. A model for simulation of mechanical losses and their extrapolation from the known point is required for estimation of mechanical losses.

12. Distribution of Mechanical Losses

13. Effect of Speed & Size on Component of Friction

14. Major Components of IC Engine Friction Crank Shaft Friction Reciprocating Friction Valve train Friction Auxiliary component friction

15. A Stribeck curve :Fundamental Idea to Reduce Friction & Wear

16. Challenges in Implementing Optimal Lubrication

17. Anatomy of Piston Assembly