Presentation is loading. Please wait.

Presentation is loading. Please wait.

Effect of Rack Server Population on Temperatures in Data Centers CEETHERM Data Center Laboratory G.W. Woodruff School of Mechanical Engineering Georgia.

Published byAllen Cross Modified over 8 years ago

Similar presentations

Presentation on theme: "Effect of Rack Server Population on Temperatures in Data Centers CEETHERM Data Center Laboratory G.W. Woodruff School of Mechanical Engineering Georgia."— Presentation transcript:

1 Effect of Rack Server Population on Temperatures in Data Centers CEETHERM Data Center Laboratory G.W. Woodruff School of Mechanical Engineering Georgia Institute of Technology Atlanta, GA 30332-0405 Yogendra.Joshi@me.gatech.edu 404-385-2810 Rajat Ghosh, Vikneshan Sundaralingam, Yogendra Joshi Collaborators: Pramod kumar, Vaibhav Arghode, Steven Isaacs.

2 Outline Problem Statement. Methodology –Experiments. –Computational fluid dynamics (CFD) analysis. Results. Conclusions. May 30-June 1 Ghosh, Joshi: ITherm 2012 2

3 Problem Statements Characterize rack-level air temperatures for a full-capacity server rack. Estimate effect of rack server population on air temperatures in a data center. Estimate effect of server location on its CPU temperature and average fan speed. May 30-June 1 Ghosh, Joshi: ITherm 2012 3

4 Experimental Setup May 30-June 1 Ghosh, Joshi: ITherm 2012 4 Measurement Uncertainty: –Temperature: –Flowrate: –Length: A data center with 10 server racks arranged in a 5x2 architecture. Raised floor plenum supply and overhead plenum return. Alternating cold-aisle/ hot-aisle. CRAC-1 is only active CRAC –

5 Test Rack May 30-June 1 Ghosh, Joshi: ITherm 2012 5 Server rack (consists of 42 1-U server and headnode) with heterogeneous heat load ranging from 240 W to 0 W.

6 Containment System May 30-June 1 Ghosh, Joshi: ITherm 2012 6 Isolate airflow into the test rack. Cooling Air from Plenum Test Rack Hot Aisle Containment Cold Aisle Containment Perforated Tile Hot Exhaust Air Exhaust Plane

7 Thermocouple Grid May 30-June 1 Ghosh, Joshi: ITherm 2012 7 600 x z x y Steel Frame Thermocouple Tube Grid: 21 T-type copper- constantan thermocouples made from 28 gauge (0.9 mm diameter) wire. Response time: 28 ms x-axis: Parallel to rack width. y-axis: Parallel to tiles. z-axis: parallel to rack height.

8 Experimental Procedure 1.Deploy the rack-level containment. 2.Vary the server population in the test rack (N=42, 32, 22,12) and measure air temperatures in cold and hot aisles. 3.Vary the location of a server stack and measure temperatures of CPUs and speeds of fans inside servers. May 30-June 1 Ghosh, Joshi: ITherm 2012 8

9 Server Population as Parameter May 30-June 1 Ghosh, Joshi: ITherm 2012 9

10 Varying Position of a Server Stack May 30-June 1 Ghosh, Joshi: ITherm 2012 10

11 CFD Simulation May 30-June 1 Ghosh, Joshi: ITherm 2012 11 x-dimension: 2.46 m y-dimension: 0.60 m Z-dimension: 1.95 m 1-U server: 1m x 0.6 m x0.4 m Server fan: Tile: Velocity inlet with 0.8 m/s to match 639 CFM (0.3 m 3 /s) supply Exhaust: Pressure outlet Server inlet and outlet: Porous jump Grid number: 1.4 millions for grid- independent solution

12 Transient CRAC Supply Air Temperature May 30-June 1 Ghosh, Joshi: ITherm 2012 12 CRAC-1 has return air temperature control. Variable supply air temperature –Mean=12.2 0 C. Std. Dev.=0.9 0 C.

13 Cold Aisle Temperature Variation May 30-June 1 Ghosh, Joshi: ITherm 2012 13 With height in the cold aisle, average temperature varies irregularly. N=42

14 Hot Aisle Temperature Variation May 30-June 1 Ghosh, Joshi: ITherm 2012 14 With height in the hot aisle, average temperature varies irregularly. N=42

15 CFD-predicted Airflow May 30-June 1 Ghosh, Joshi: ITherm 2012 15 Recirculation in the airflow explains irregular pattern of air temperatures in the cold and hot aisles. N=42

16 Temperature Difference Variation May 30-June 1 Ghosh, Joshi: ITherm 2012 16 Temperature difference increases with height. N=42

17 Average Temperature in Exhaust Plane May 30-June 1 Ghosh, Joshi: ITherm 2012 17 Average temperature in the exhaust plane increases with server population.

18 Effect of Server Population on Temperature Difference May 30-June 1 Ghosh, Joshi: ITherm 2012 18 For all heights, temperature difference increases with server number.

19 Effect of Containment May 30-June 1 Ghosh, Joshi: ITherm 2012 19 The containment system reduces average temperature in the cold aisle - Blocks hot air recirculating from other parts of the room.

20 Effect of Server Location May 30-June 1 Ghosh, Joshi: ITherm 2012 20 Keeping server stack near the highest possible location is more energy- efficient practice in this case -Lowest CPU temperature. -Lowest average server fan speed.

21 Conclusion Rack-level temperature field (average temperatures in cold and hot aisles; and average temperature difference between cold and hot aisles) is characterized for a full capacity server rack (N=42). –Air recirculation thorough the void affects convective temperature field. Rack server population has a significant impact on air temperatures –Temperature difference across the rack increases with the server population in the test rack. Recommended best practice for filling out a server stack in an empty stack –Sever stack should be placed at the highest possible location. May 30-June 1 Ghosh, Joshi: ITherm 2012 21

22 Acknowledgement The authors acknowledge support for this work from IBM Corporation, with Dr. Hendrik Hamann as the Technical Monitor. Acknowledgements are also due to the United States Department of Energy as the source of primary funds. Additional support from the National Science Foundation award CRI 0958514 enabled the acquisition of some of the test equipment utilized. May 30-June 1 Ghosh, Joshi: ITherm 2012 22

23 Questions? May 30-June 1 Ghosh, Joshi: ITherm 2012 23

Download ppt "Effect of Rack Server Population on Temperatures in Data Centers CEETHERM Data Center Laboratory G.W. Woodruff School of Mechanical Engineering Georgia."

Similar presentations

CFD ANALYSIS OF CROSS FLOW AIR TO AIR TUBE TYPE HEAT EXCHANGER

CFD ANALYSIS OF CROSS FLOW AIR TO AIR TUBE TYPE HEAT EXCHANGER
Data Center Design Issues Bill Tschudi, LBNL

Data Center Design Issues Bill Tschudi, LBNL
Clair Christofersen Mentor – Aaron Andersen August 2, 2012

Clair Christofersen Mentor – Aaron Andersen August 2, 2012
Matt Warner Future Facilities Proactive Airflow Management in Data Centre Operation - using CFD simulation to improve resilience, energy efficiency and.

Matt Warner Future Facilities Proactive Airflow Management in Data Centre Operation - using CFD simulation to improve resilience, energy efficiency and.
Bridging the Gap Between Statistics and Engineering Statistical calibration of CFD simulations in Urban street canyons with Experimental data Liora Malki-Epshtein.

Bridging the Gap Between Statistics and Engineering Statistical calibration of CFD simulations in Urban street canyons with Experimental data Liora Malki-Epshtein.
The Role of Controls for Indoor Air Quality Kent W. Peterson, PE, Fellow ASHRAE P2S Engineering, Inc. Mid Columbia ASHRAE Chapter.

The Role of Controls for Indoor Air Quality Kent W. Peterson, PE, Fellow ASHRAE P2S Engineering, Inc. Mid Columbia ASHRAE Chapter.
Using Copper Water Loop Heat Pipes to Efficiently Cool CPUs and GPUs Stephen Fried President Passive Thermal Technology, Inc.

Using Copper Water Loop Heat Pipes to Efficiently Cool CPUs and GPUs Stephen Fried President Passive Thermal Technology, Inc.
1 * Other names and brands may be claimed as the property of others. Copyright © 2010, Intel Corporation. Data Center Efficiency with Optimized Cooling.

1 * Other names and brands may be claimed as the property of others. Copyright © 2010, Intel Corporation. Data Center Efficiency with Optimized Cooling.
Improving and Trouble Shooting Cleanroom HVAC System Designs By George Ting-Kwo Lei, Ph.D. Fluid Dynamics Solutions, Inc. Clackamas, Oregon.

Improving and Trouble Shooting Cleanroom HVAC System Designs By George Ting-Kwo Lei, Ph.D. Fluid Dynamics Solutions, Inc. Clackamas, Oregon.
Data Center Controls Mark Hydeman, P.E., FASHRAE Taylor Engineering, LLC mhydeman@taylor-engineering.com.

Data Center Controls Mark Hydeman, P.E., FASHRAE Taylor Engineering, LLC
Using Computational Fluid Dynamics (CFD) for improving cooling system efficiency for Data centers Data Centre Best Practises Workshop 17 th March 2009.

Using Computational Fluid Dynamics (CFD) for improving cooling system efficiency for Data centers Data Centre Best Practises Workshop 17 th March 2009.
Cooling Product Positioning

Cooling Product Positioning
Cloud Computing Data Centers Dr. Sanjay P. Ahuja, Ph.D. 2010-14 FIS Distinguished Professor of Computer Science School of Computing, UNF.

Cloud Computing Data Centers Dr. Sanjay P. Ahuja, Ph.D FIS Distinguished Professor of Computer Science School of Computing, UNF.
Experimental and Numerical Study of the Effect of Geometric Parameters on Liquid Single-Phase Pressure Drop in Micro- Scale Pin-Fin Arrays Valerie Pezzullo,

Experimental and Numerical Study of the Effect of Geometric Parameters on Liquid Single-Phase Pressure Drop in Micro- Scale Pin-Fin Arrays Valerie Pezzullo,
Project Motivation: Opportunity to explore building efficiency technology and the engineering design process Improving the thermal efficiency will save.

Project Motivation: Opportunity to explore building efficiency technology and the engineering design process Improving the thermal efficiency will save.
VIACOM Data Center Optimization Project

VIACOM Data Center Optimization Project
Utility-Function-Driven Energy- Efficient Cooling in Data Centers Authors: Rajarshi Das, Jeffrey Kephart, Jonathan Lenchner, Hendrik Hamamn IBM Thomas.

Utility-Function-Driven Energy- Efficient Cooling in Data Centers Authors: Rajarshi Das, Jeffrey Kephart, Jonathan Lenchner, Hendrik Hamamn IBM Thomas.
K. Nazridoust, G. Ahmadi, and D. H

K. Nazridoust, G. Ahmadi, and D. H
Simulation of Air-Cooling for the Gear Unit in Pump and Turbine Generator Systems M. Fujino* and T. Sakamoto** *Information Technology Center, Nippon Institute.

Simulation of Air-Cooling for the Gear Unit in Pump and Turbine Generator Systems M. Fujino* and T. Sakamoto** *Information Technology Center, Nippon Institute.
MuCool Absorber Review meeting FermiLab, Chicago 21 – 22 February 2003 Fluid Flow and Convective Heat Transfer Modelling by Wing Lau & Stephanie Yang Oxford.

MuCool Absorber Review meeting FermiLab, Chicago 21 – 22 February 2003 Fluid Flow and Convective Heat Transfer Modelling by Wing Lau & Stephanie Yang Oxford.

Similar presentations

Ads by Google