1. HTS Solenoid Punch: Team Supercool

2. The Story So Far http://www.mundogym.com.ar/Secciones/Deportes/fo tos/boxeo/box-punch.jpg

3. The Story So Far Used HTS tape to make a punch Selected radius of solenoid based on measurements Designed and built apparatus Wrapped HTS tape Attempted to Connect Leads

4. Apparatus Dimensions 3” high with ¾” thick base 5” O.D. with ½” thick walls < 1 ¼” Inner diameter to slide PVC over 15/16” Through hole for punch

5. Critical Current

6. Apparatus Construction

8. HTS Tape Wrapping For a 2.5” diameter 1.5 m tape 2” length 2” length 60 m tape should be 80” Our solenoid is 6” tall -> 13 layers tall -> 13 layers

9. Final Assembly

10. The Outlet

11. Tests Inner magnetic field with Magnetometer Critical Current Self-Field limitations (voltmeter and Magnetometer) Force Compare to results from copper solenoid

12. Immediate Goals Use propane torch to solder power leads Experiment with aspect ratio Insulate with Kapton tape Heat conduction calculations for Helium Build final sized apparatus

13. Connecting Power Leads

14. Final Design Flat disk of Al from original ingot Two large diameter tubes attached to bottom disk Lid

15. Final Design

16. Schedule

17. Questions?