1. TMP112 Calibration

2. Slope 1 (Max) Slope 2 (Max) Slope 3 (Max) Slope 1 (Min) Slope 2 (Min) Slope 3 (Min) The slope regions below were created from characterization data. We assure that if a device has positive temperature error it will have a slope no greater than the maximum slope in each temperature region. We assure that if a device has negative temperature error it will have a slope no less than the minimum slope in each temperature region. The more negative the temperature error the flatter the slope across temperature.

3. If a device has the maximum slopes across temperature than calibrating at T = 25 o C will improve the temperature error across temperature. This is shown below. Device 1 before calibration Device 1 after calibration