Download presentation
Presentation is loading. Please wait.
Published byJarred Akehurst Modified over 9 years ago
1
Induction Mr. Lombardi
2
Induction The term “induction” applies to the pathway for fuel and air to enter the combustion chamber. Including: – Carburetion – Fuel Injection – Manifolds
3
Carburetors Rely on the Venturi Vacuum principle Rated in CFM 3 Common Styles – 1 Barrel – 2 Barrel – 4 Barrel (square bore/spread bore)
4
Venturi Vacuum
5
1 Barrel (200 – 400 CFM)
6
2 Barrel (350 – 500 CFM)
7
4 Barrel (400 – 1150 CFM)
8
Square Bore Vs. Spread Bore
9
First Fuel Injection In 1910, Adams Farwell pioneered a non-carbureted fuel system called fuel injection, refined and adopted for diesel engines. But it wasn't until after World War II that thought was given to putting it on spark-ignited gasoline engines.
10
Typical Injector
11
Fuel Injection Fuel injection atomizes the fuel by forcibly pumping it through a small nozzle under high pressure (15-90 psi). – Throttle Body Injection – Port Fuel Injection
12
Throttle Body Injection 1 or 2 Injectors for engine
13
Port Fuel Injection An injector per cylinder aimed at the port opening.
14
Direct Injection An injector per cylinder spraying inside the cylinder.
15
Intake Manifold “Wet” for Carbureted applications “Dry” for Injected applications Older manifolds were made from Cast Iron Modern manifolds are made from Aluminum Future manifolds will almost always be made of plastic (vinyl, phenolic resin, etc.)
16
Carbureted Intake Manifold
17
Injected Intake Manifold
Similar presentations
© 2024 SlidePlayer.com Inc.
All rights reserved.