1. Remote set-up instructions Life is meant to be interactive!

2. Turn the remote on Press and hold down the MENU key for a few seconds.  Be certain 2 AA batteries are correctly installed in the back of your remote. (screw is optional)  Battery Indicator only appears when battery is low and needing replacement.

3. The remote may ask you to enter in a Session ID.

4. Enter in the Session ID provided by the instructor Type in the Session ID on the keypad… …and press the Send button.

5. The remote will try connecting to the instructor’s receiver…

6. When prompted… …then press ‘Send’ Type in your ID #...

7. Did you make sure your student ID was entered correctly before pushing send?

8. If the User ID has been entered correctly, Qwizdom will be displayed when the remote connects to the active receiver. If a question is posed, the LCD will display the answer choices, or a blank screen for numeric input

9. If the remote displays: ‘Denied’  User ID may have been incorrectly entered  The User ID entered does not match the one in the class roster  User ID and information has not yet been added to the class roster Press and hold down the MENU button to turn off the remote and start over.

10. If the remote displays: ‘No Net’ The remote cannot find the receiver. (it may be looking for the receiver in your last class) To change the Session ID: Press MENU Press the Right arrow 2x Sess. ID should be on the screen Press Send Press Yes if prompted to change session ID

11. This Q4 student remote diagram can be found at www.qwizdom.com/q4 For questions, please contact support@qwizdom.com

12. Enjoy the use of Qwizdom!