1. AS-Interface Communication Solution for Discrete Devices
Day 2 Training - Technical
Sept. 18, 2008
AS-Interface Communication Solution for Discrete Devices
Process Networking (B)

2. Day 2 Training - Technical
Sept. 18, 2008
AS-i Benefits
Ideally Suited for On/Off Valves
Up to 124 Field Devices per Master/Gateway
Simple Electronics for Reliable Robust Performance
Power & Data Over 2-Wire Unshielded CableFree Choice of Network Topology
Robust Performance in Severe Environments
Easy to Install Providing Greatest Cost Savings With Least Complexity
Complements Higher Level Networks
Process Networking (B)

3. AS-Interface Benefits
Day 2 Training - Sales
Sept. 18, 2008
AS-Interface Benefits
Readily Adaptable to most DCS/PLC/PC
Use Standard Hazardous Area Wiring
Minimal Training, Easy to Understand and Install
Network can be pre-assembled and tested prior to on-site arrival
Process Networking (B)

4. AS-Interface vs. Conventional
Day 2 Training - Technical
Sept. 18, 2008
AS-Interface vs. Conventional
Conventional AS-Interface
Valve Monitor & Solenoid $ $ 610
Conduit & Wiring $ $ 300
I/O (Cnvntnl); Gateway (AS-i) $ $ 100
Power Supply $ $ 50
Installation Labor $ $ 200
Total Installed Cost $1, $1,260
Installation Savings of $ per valve or 34%!!!
Process Networking (B)

5. AS-I Saves Money! AS-Interface Cuts Project costs by:
Day 2 Training - Sales
Sept. 18, 2008
AS-I Saves Money!
AS-Interface Cuts Project costs by:
Eliminating I/O Cards
Saving Cabinet space
Drastically Reducing Required Cable and Conduit
Process Networking (B)

6. AS-I Saves Time! AS-Interface Cuts Project time by:
Day 2 Training - Sales
Sept. 18, 2008
AS-I Saves Time!
AS-Interface Cuts Project time by:
Reducing Engineering time
Reducing Installation time due to:
Wiring
Labeling
Commissioning
Testing
Process Networking (B)

7. AS-Interface Origins
Standard Introduced by Sensor Manufacturers in 1994 (Turck, P+F, Efector, Siemens and Others)
Ideally Suited for Integration into Proximity Sensors
Designed for Mission Critical Applications
Over 13,000,000 Installed Field Devices
AS-i accepted World-Wide
- CENELEC EN Standard
- IEC Standard

8. AS-Interface Signal Exceptional Noise Immunity
Performs Reliably Even in Strenuous Environments
Maximum Scan Time of 5 milliseconds for 31 devices (.125 milliseconds/device for discrete; multiple scans for analog or 4 x .125 milliseconds = .5 milliseconds)

9. AS-i Addressing Each Field Device Has a Defined Address
Day 2 Training - Sales
Sept. 18, 2008
AS-i Addressing
Each Field Device Has a Defined Address
Field Device Addressed Off Line with Hand Held
Field Device Addressed On Line by Master
Addresses are Unique on Each String (Set of Devices on One Master)
Standard addressed from 1 to 31; Extended addressing 1a to 31a & 1b to 31b (62 devices!)
Process Networking (B)

10. AS-Interface Topologies
Linear with Spur
Power
Supply
Master
Tree
Power
Supply
Master

11. AS-Interface Topologies
Ring
Power
Supply
Master

12. AS-Interface Network Higher Level Bus Power Supply Master/Gateway
Day 2 Training - Sales
Sept. 18, 2008
AS-Interface Network
Higher Level Bus
Power Supply
Master/Gateway
AS-Interface Bus
Slave (Field Device)
Power Supply
Repeater
Process Networking (B)

13. StoneL AS-I Gateways Durable Stainless Steel Housing Graphical display
Duplicate address detection
Available in: - Profibus DP - Modbus - DeviceNet - Ethernet And more
ETL approved for Class I Div 2 in Nema 4 enclosure

14. Networking AS-Interface
Day 2 Training - Sales
Sept. 18, 2008
Networking AS-Interface
PLC/DCS with DeviceNet,
Profibus or Modbus Scanner
Controller
ProfibusDP, DeviceNet,
Modbus, Modbus+
Emerson DeltaV
Foxboro
Modicon
Yokogawa
GE Fanuc
Omron
Allen Bradley
Cutler Hammer
Honeywell
Moore
…And many more
Gateway
AS-I Power Supply
To AS-I Network
Process Networking (B)

15. StoneL PLC AS-I Masters
PLC AS-I Master for Allen Bradley SLC dual channel
AS-I Master for Allen Bradley CompactLogix / MicroLogix
AS-I Master for Allen Bradley ControlLogix – Dual Channel

16. Networking AS-i PLC/DCS with AS-i Scanner Allen Bradley Siemens
Day 2 Training - Sales
Sept. 18, 2008
Networking AS-i
PLC/DCS with AS-i Scanner
Allen Bradley
Siemens
Emerson DeltaV
Modicon
SquareD
GE Fanuc
Wago
Beckhoff
Omron
Mitsubishi
AS-I Power Supply
To AS-I Network
(No Gateway Required)
Process Networking (B)

17. StoneL AS-I Power Supplies
Day 2 Training - Sales
Sept. 18, 2008
StoneL AS-I Power Supplies
Power Supplies
Provide Voltage and Current to AS-Interface Network (30.5VDC ) (Decoupled to Prevent Signal Interference)
Available in 2.8 and 8.0 Amp and Dual Channel 4.0 Amp
1 required for each AS-I network and 1 for each repeater
2.8 Amp FM & CSA Approved for Class 1 Division 2 Hazardous locations
Process Networking (B)

18. StoneL AS-I Power Conditioners
Day 2 Training - Sales
Sept. 18, 2008
StoneL AS-I Power Conditioners
Power Conditioners
Provides the data decoupling functions
Useful for Networks where redundant power supply is desired
Can enable user to power multiple networks from a single
AS-I Power supply
Useful for remote placement of power supply
Process Networking (B)

19. AS-Interface Network Power
Day 2 Training - Sales
Sept. 18, 2008
AS-Interface Network Power
Power Conditioner
Application examples
Process Networking (B)

20. StoneL AS-I Network Extension Tools
Day 2 Training - Sales
Sept. 18, 2008
StoneL AS-I Network Extension Tools
Repeater
Allows extension of network by 100m (328ft)
Requires additional power supply
Can be remote mounted in FieldRack enclosure
Allows devices on both sides of the repeater
No more than 2 repeaters in series (total of 300m or 984ft)
Process Networking (B)

21. AS-Interface with Repeater
Power
Supply
Master
Repeater

22. StoneL AS-I Extension Tools
Day 2 Training - Sales
Sept. 18, 2008
StoneL AS-I Extension Tools
AS-I Network Terminator
Extend AS-I Networks beyond 100m
Passive termination improves signal quality
Cannot use loop topology
AS-I Network Tuner
Active Adjustable Termination improves signal quality
Process Networking (B)

23. StoneL AS-I Wiring 2 Wire Unshielded - Untwisted 16 Gauge (2x1.5mm2)
Length of 100 meters (330 feet)
Additional Length of 100 Meters per Repeater (Maximum of 2 Repeaters)
Total Length of 300 meters or 984 feet

24. StoneL AS-I Wiring Aids
Direct mount Protected & Passive Drop Connectors
- Drop Leg Fault Protection
- Easy Wiring
- Direct mount type for JM or in customer’s enclosure
Disconnect Switch Tee
- Drop Leg Fault Protection Standard
- De-energize drop leg Quickly & Conveniently

25. AS-Interface Drop Connectors
Day 2 Training - Sales
Sept. 18, 2008
AS-Interface Drop Connectors
Passive Double Drop, (1-2) - Multi Drop, DIN (1-4, 1-6)
Protected mA, Single Drop (1-1) Multi Drop, DIN (1-4, 1-6)
Switched Protected mA, Single Drop (1-1) Multi Switched Drop, DIN (1-4, 1-6)
Process Networking (B)

26. AS-Interface Drop Connectors
Day 2 Training - Sales
Sept. 18, 2008
AS-Interface Drop Connectors
New Din Rail mount Drop connector
- Six (6) Device Drops Passive Protected Switched
- LED indicates
- Bus Power
- Drop Power
- Drop Short Circuit
- Drop Leg Fault Protection - Din Rail mount
- De-energize individual drops
Process Networking (B)

27. StoneL AS-I Wiring Aids
Junction Module (JM)
- Rated for Class I & II, Div 1 & 2; No Seal-offs
- Houses Tees or Disconnect Switch
- Lock-Out Tag Out Feature on Disconnect Switch

28. AS-Interface Wiring Aids
Day 2 Training - Sales
Sept. 18, 2008
AS-Interface Wiring Aids
FieldBlock (FN)
- Anodized Aluminum Enclosure is Durable and Corrosion Proof
- Suitable for use in heavy wash down and submersible applications with NEMA 4, 4X and 6 ratings
- Multiple Connector or Cable Gland Options Conveniently Interface with Flexible Wiring Systems
- Compact Design Minimizes Space Requirements
Process Networking (B)

29. AS-Interface Wiring Aids
Day 2 Training - Sales
Sept. 18, 2008
AS-Interface Wiring Aids
Bus Protection Module (BPM)
Drop short circuit protection
- Field device will be disconnected from the network,
network will not be affected.
Trunk short circuit protection
- Bus offline temporarily but the BPM will isolate the
short and disconnect it from the bus.
- On-board LEDs indicate the problem and location
Direct mount to Axiom
Process Networking (B)

30. AS-Interface Wiring Aids
Day 2 Training - Sales
Sept. 18, 2008
AS-Interface Wiring Aids
Master Bus Protection Module (MBPM)
Connects the Master / Gateway to the ring
Same Function as the BPM
DIN Rail Mount
Process Networking (B)

31. AS-Interface Wiring Aids
Day 2 Training - Sales
Sept. 18, 2008
AS-Interface Wiring Aids
Bus Protection Module (BPM)
Requires Ring Topology
Limited to 15 Devices per ring
Best with “Fail In Last Position” pneumatic actuated valves
Master BPM
Power
Supply
Master
Process Networking (B)

32. AS-Interface Wiring Aids
Day 2 Training - Sales
Sept. 18, 2008
AS-Interface Wiring Aids
Bus Protection Module (BPM)
- Trunk shorts are detected by BPM and segment is isolated
- Network remains fully functional
Short Circuit
Master BPM
Power
Supply
Master
Process Networking (B)

33. StoneL AS-I Handheld Addressing Unit
- Simple operation
- Low cost
- Convenient for use in the Shop or in the Field

34. StoneL AS-I VCTs Valve Communication Terminal 4DI/2DO
Day 2 Training - Sales
Sept. 18, 2008
StoneL AS-I VCTs
Valve Communication Terminal
4DI/2DO
- 2 Integral Proximity Sensors (DI) with LED Indication
- 2 Auxiliary inputs (DI)
- 2 Solenoid Outputs (4 Watts Total Power)
AS-Interface Watchdog
Process Networking (B)

35. StoneL AS-I I/O Modules
Day 2 Training - Sales
Sept. 18, 2008
StoneL AS-I I/O Modules
Discrete I/O Modules
4DI / 4DO Module with solenoid outputs (4Watts total)
4DI / 4DO Module with 2 relay outputs
Available in JM or FieldBlock Enclosures
Available in JM with Integral Solenoid Valve
Process Networking (B)

36. StoneL AS-I Analog Modules
Day 2 Training - Sales
Sept. 18, 2008
StoneL AS-I Analog Modules
Analog Input Modules
4 Analog Inputs (4-20mA) or (4) Thermocouple Inputs
16 bit resolution .1%
LED Indication (Power Status and Input Status)
Din Rail mount available in IP20 or IP65
Requires AS-I 2.1 version Master!
Analog Output Modules
4 Analog Outputs (0-20mA)
Process Networking (B)

37. StoneL AS-I Commissioning Kit
Commission Devices (Set Address)
Commission Networks (Configure addresses, test communication)
Troubleshoot and Diagnose Network Problems
Test AS-Interface Devices (Read Inputs, Force Outputs)
A Must for Bench Testing AS-i VCT’s

38. AS-i Network Layout and Design Tips
Buy 100m Spools of Wire . Use this to confirm that your network does not exceed 100m
Use Repeaters to Extend cable length
Use passive drop connectors for branching circuits
Use Short circuit protection for field devices
Remember, only 1 AS-I device per protected drop.

39. Application Questions
What is the maximum number of AS-I devices that can be connected to a Gateway?
What is the maximum length of an AS-I network?
StoneL offers short circuit protection devices for AS- Interface. At what current do they trip?
I want to use a AS-I Dual Channel gateway to Control/Monitor 46 VCTs, I will need 2 repeaters on each channel to reach all of my devices. How many AS-I power supplies will I need?

40. AS-Interface Communication Solution for Discrete Devices
Day 2 Training - Technical
Sept. 18, 2008
AS-Interface Communication Solution for Discrete Devices
Process Networking (B)