1. July 2010
Project: IEEE P Working Group for Wireless Personal Area Networks (WPANs)
Submission Title: Proposal for Radio Specification Comments Resolutions #1310, #1323
Date Submitted: 16 September, 2010
Source: Steve Jillings
Company: Semtech Corporation
Address []
Re: []
Abstract: []
Purpose: []
Notice: This document has been prepared to assist the IEEE P It is offered as a basis for discussion and is not binding on the contributing individual(s) or organization(s). The material in this document is subject to change in form and content after further study. The contributor(s) reserve(s) the right to add, amend or withdraw material contained herein.
Release: The contributor acknowledges and accepts that this contribution becomes the property of IEEE and may be made publicly available by P
Steve Jillings (Semtech)

2. Comments To be Resolved
July 2010
Comments To be Resolved
Radio Specification
#1310
Comment:
Add comment to indicate that radio specifications may be superseded or values as required by the relevant regulatory authority
Proposed Resolution:
Accept in Principle
Steve Jillings (Semtech)

3. Comments To be Resolved
July 2010
Comments To be Resolved
Radio Specification
#1310 (continued)
Proposed Resolution:
Add the following paragraph to the end of MR-FSK radio specification (6.12a4):
It is the responsibility of the implementer to verify and ensure that the device is in compliance with all regulatory requirements in the geographic region where the device is deployed or sold.
Conformance with this standard does not guarantee compliance with the relevant regulatory requirements which may apply.
Steve Jillings (Semtech)

4. Comments To be Resolved
July 2010
Comments To be Resolved
Radio Specification
#1323
Comment:
Provide a table with required sensitivity per data rate. Coded and uncoded
Proposed Resolution:
Accept in Principle
Add comment at end of 6.12a.5
If FEC is implemented, the value of S0 shall be -84 dBm
Steve Jillings (Semtech)

5. doc.: IEEE 802.15-<doc#>
<month year>
doc.: IEEE <doc#>
July 2010
Background
Table 75f of the draft standard currently defines the MR-FSK radio specification in terms of a single generic:
Steve Jillings (Semtech)
<author>, <company>

6. Comments To be Resolved
July 2010
Comments To be Resolved
Radio Specification
#1308, 1311, 1369
Comments:
Relating to Radio Specification Table (Table 75f in the draft standard)
Proposed Resolution:
To be covered by document xxxx-xx-004g (Siebert et al)
Steve Jillings (Semtech)

7. Proposed Resolution: Channel Switch Time Definition
July 2010
Proposed Resolution:
Channel Switch Time Definition
Channel switch time is a transmitter parameter and is defined as the time taken for a transmitter on channel A to exit that channel and the time to enter channel B and be ready to transmit on that channel, both of which are co-resident in a single band defined in Table 1
The channel switching time shall be < 500s
Steve Jillings (Semtech)