1. Membrane Potentiometer Carrier – Assembly Diagrams
MMSC1000-1
MMSC1000-1
MMSC1000
Step 1
Step 2
1-1/4”
2.0”
MMSC1000-2
3/4”
Apply a thin layer of rubber
cement between the outer
edge and the dotted lines.
Note: favor the outer edge of
MMSC It is important
that no cement enters the
keep out zone when
MMSC and -2 are mated.
Only enough cement is required
to hold the pieces together
during attachment to the carrier
garment.
Allow cement to air dry per
manufacturer’s instructions. =
Keep Out Zone
1/8” Max

2. Membrane Potentiometer Carrier – Assembly Diagrams
1/8”
Step 3
1/4”
Install carrier flap locking
snaps as depicted at right.
Note: it is important that a clean
Center hole is cut prior to snap
Installation to avoid tearing of the
Rubber membrane carrier material.
1-1/4”
MMSC1000
1.0”
Keep Out Zone
1/8”

3. Membrane Potentiometer Carrier – Assembly Diagrams
Completed Carrier
(membrane shown installed
For reference)
Connector
Removable
Flexible Membrane
Potentiometer