1. Are Your Employees Qualified?By
Quad States Instructors Group
This sample is provided for informational purposes only and should not be relied on as legal advice. The sample cannot and does not address the unique facts and circumstances of your specific situation and should not be relied on for your particular transaction. QSI, Inc. makes no claims, promises, or guarantees about the accuracy, completeness, or adequacy of any information contained in the samples. Therefore, you should not use the sample without first obtaining the advice of your business attorney. Finally, nothing contained in this sample should be construed to constitute a recommendation or endorsement of QSI, Inc.
QUAD STATE INSTRUCTORS, INC. , 2016
2016

2. QUAD STATE INSTRUCTORS, INC.
29 CFR
It is not uncommon for boards of directors, CEO’s, GM’s and others to take tours of new or existing substations and other facilities
This raised the question, can these people safely enter (according to the rules) these locations, just to “Take a Tour or look around”?
2016
QUAD STATE INSTRUCTORS, INC.

3. QUAD STATE INSTRUCTORS, INC.
29 CFR
In doing so, each cooperative must ask itself two questions
Do employees/ or others at your cooperative enter secure areas, such as substations, switchyards, generating stations, or open pad-mounted equipment?
Are all of these people qualified to enter substations, switchyards, generating stations, pad-mounted equipment?
2016
QUAD STATE INSTRUCTORS, INC.

4. Electric Power Generation, Transmission & Distribution
When the standard was published
It created some confusion concerning the rules and caused many questions to be asked
Review Federal OSHA interpretations
Reviewing these OSHA interpretation letters revealed a situation that each cooperative should investigate to ensure compliance with
2016
QUAD STATE INSTRUCTORS, INC.

5. QUAD STATE INSTRUCTORS, INC.
Interpretations
Three refer directly to this question
June 23rd, 1997
June 9th, 1999
May 17th, 2002
2016
QUAD STATE INSTRUCTORS, INC.

6. Where are Qualified Workers Required
“Cleanup operations at electric power generation, transmission, and distribution facilities are not covered by , unless one of the following conditions is met:
(2) The operation is performed in rooms or spaces that contain exposed energized parts or electric power generation, transmission, or distribution equipment.
2016
QUAD STATE INSTRUCTORS, INC.

7. QUAD STATE INSTRUCTORS, INC.
Why are they required
Electric power generating stations and transmission and distribution substations typically have areas containing energized electric lines and equipment.
Unless the energized lines or equipment are guarded sufficiently, it is unsafe for unqualified persons to enter these spaces.
2016
QUAD STATE INSTRUCTORS, INC.

8. QUAD STATE INSTRUCTORS, INC.
Why are they required
With exceptions, electric power generating stations and transmission and distribution substations are restricted to entry by qualified persons.
In order for them to be qualified, they must be trained.
2016
QUAD STATE INSTRUCTORS, INC.

9. QUAD STATE INSTRUCTORS, INC.
What kind of training
Paragraphs (u)(i)(A) through (C) and (v)(i)(A) through (C) set forth the conditions for spaces within substations and generating stations, respectively, under which unqualified persons may not enter.
Section (u) Substations
Section (v) Power Generation
2016
QUAD STATE INSTRUCTORS, INC.

10. What has to be in the training
These “qualified” (non-electrical) employees must have the following training:
(1) They must know what is safe to touch and what is not safe to touch in the specific areas they will be entering (paragraph (a)(2)(ii)(A));
(2) They must know what the maximum voltage of the area is (paragraph (a)(2)(ii)(B));
2016
QUAD STATE INSTRUCTORS, INC.

11. What has to be in the training?
(3) They must know the minimum approach distances for the maximum voltage within the area (paragraph (a)(2)(ii)(c)); and
(4) They must be trained in the recognition and proper use of electrical protective equipment that will be used to provide protection for them and in the work practices necessary for performing their specific work assignments within an area.
2016
QUAD STATE INSTRUCTORS, INC.

12. QUAD STATE INSTRUCTORS, INC.
Anything else?
Until these “qualified employees” have demonstrated proficiency in the work practices involved, they are considered to be employees undergoing on-the-job training and must be under the direct supervision of a qualified employee (qualified person) at all times.
According to the definition of “qualified employee (qualified person)”, the employee also must have demonstrated an ability to perform the work safely at his or her level of training.
2016
QUAD STATE INSTRUCTORS, INC.

13. QUAD STATE INSTRUCTORS, INC.
Is there more?
It is expected that an orientation familiarizing the employee with the safety fundamentals given here will be conducted before an employee undergoing training is allowed to enter a restricted area.
2016
QUAD STATE INSTRUCTORS, INC.

14. OK, but do I need to train everyone?
An employee must have the training required by paragraph (a)(2)(ii) of section in order to be considered a qualified person.
A qualified employee is defined as one who is knowledgeable in the construction and operation of the electric power generation, transmission, and distribution equipment involved in his or her job, along with the associated hazards.
2016
QUAD STATE INSTRUCTORS, INC.

15. QUAD STATE INSTRUCTORS, INC.
What about lineman?
Having power line workers go through an apprenticeship training program may not provide all the training required under paragraph (a)(2)(ii).
The employer must ensure that the program used includes all applicable training elements required under paragraph (a)(2)(ii) and work practices throughout
2016
QUAD STATE INSTRUCTORS, INC.

16. How extensive of training?
Would an in-house basic electrical safety training program covering (a)(2)(i) and (a)(2)(ii) for the expected conditions in the switchyards be sufficient training in order to perform the tours when escorted by a utility representative?
While the training for these employees must meet paragraph (a)(2)(ii), such training need not be as comprehensive as the training provided normally to a qualified electrical worker.
2016
QUAD STATE INSTRUCTORS, INC.

17. QUAD STATE INSTRUCTORS, INC.
What does all this mean?
Each cooperative should provide or ensure that all employees entering these locations have this training or have had it during an apprenticeship or previous training.
That the employee is knowledgeable and proficient to perform their work in these locations.
OSHA also states that the training requirements the list in the two previous interpretations are “the minimum acceptable training”.
2016
QUAD STATE INSTRUCTORS, INC.

18. QUAD STATE INSTRUCTORS, INC.
What to do!
Develop and provide employees a training class that covers all of the basics and also some electrical fundamentals.
Take trainee’s on field trips to a substation to point out different equipment, energized conductors, possible hazards and more.
Open various pad-mounted equipment for visual inspections
2016
QUAD STATE INSTRUCTORS, INC.

19. QUAD STATE INSTRUCTORS, INC.
What to do!
At the end of the training, each student is given a test to verify knowledge about the training they just received.
Each employee is required to demonstrate proficiency in the safety procedures and practices they learned in class.
Supervisors should be the person that is in charge of verifying the proficiency.
2016
QUAD STATE INSTRUCTORS, INC.

20. QUAD STATE INSTRUCTORS, INC.
Questions?
2016
QUAD STATE INSTRUCTORS, INC.