1. Break down Lance rack Cut one of each of these for each rack
(drawings not to scale)
31”
25” 2” 3” 1” 3” 2”
Top Separator
3-1/2”
31”
25” 3” 2”
3-1/2”
Rear Brace
32-1/2”
26-1/2” ½” 3” ½” 2”
3-1/2”
Base Holder

2. Cut two these (as shown) for each rack Side View
66” or whatever is appropriate for the height you want 2”
The top holes (between red and blue) are not the same.
10o
Back Legs
Front Legs
It is best (but not absolutely necessary) to angle cut the bottom to sit flat on the ground
24” (or whatever fits your dimensions – leg length and angle of tilt)
Side Brace 3”

3. If you don’t want the side braces angled, you can lengthen the rear brace tenons and insert a spacer block (the thickness of the legs) between the back legs and the side brace.
Front View
Top View

4. Lay out to measure and mark
After cutting all the holes and assembling the rack, mark the sides of each outer board along the tenons so you know where the pegs need to go.
10o slope by offsetting top 11-½” from bottom
1. Mark this hole on the rear leg
Drill peg hole centers slightly outside of leg edge line
11-1/2”
10o
65”
66”
2. Measure side brace length and mark these holes on the side braces
3. Mark this cut-off line