1. Bream Plus lid closing problem
Date :- 27/05/2011
Model :- Bream Plus
Capacity :- 7.5Kg
WMVT75BPCH-CNS
Problem :- Lid not getting close easily and needs pressure to close the lid.
Analysis :- Positive Warpage observed at the centre of the lid. Which getting stucked during closing with front panel.

2. Bream Plus lid closing problem
Date :- 27/05/2011
Immediate counter action for 550 Nos.
1mm thick washer added below the front panel screw, to inclined the panel by 1mm.
Permanent counter action
Option 1 :- Supporting rib to be provided at the centre of the lid to avoid any kind of warpage.
Procedure
Step 3:- Add 1mm thk. Washer below the panel & tight the screw and fixed the cap.
After Rework :- 1mm gap observed between body B & front panel at locks area.
Step 1:- Remove Both LH & RH screw cap
Step 2:- Remove the screw
1mm thk washer
Lid is coming in front of this gap after closing so there is no chances of spread water getting inside on the panel
Additional supporting rib to be provided
Additional supporting rib to be provided
Rib height to be increased
Option 2 :- Thickness 1~1.5mm to be reduced from the from the front wall of lid.