1. Template as part of temporary Services Support
extending from outside TE bulkhead by 200mm
temporary position
of clip whilst sealing
Octant
template
behind
services
60mm approx.
Clip to template
60mm approx.
grommet in
TE bulkhead B6 B5 B4 B3

2. addition to the main services support to which connector
A template is needed in
addition to the main services
support to which connector
boxes are fastened
360 degs.
Services
support
Services
Support
template
TE bulkhead

3. fasten LMTs to template)
Quadrant Services Support Template
eg one octant of quadrant A1 with
12 LMT sets,4 fibre sets and
one DCS bunch all in ‘grommet
modularity’ 24 23 22 21 20 19 18 17 16 15 14 13
R outside
TE bulkhead
Labelled lines marked on
Template indicate LMT route
Slots in template
for LMT clips (which
fasten LMTs to template)
Fibre bunch fastening to
template
Fix to
services
support
DCS bunch fastening to
template

4. Template made of Al sheet – marked with LMT positions etc for octant

5. LMTs clipped to template with clips away from bulkhead for sealing
access between tapes

6. LMTs clipped to template close to bulkhead for sealing in grommets

7. Template with LMTs and one fibre bunch attached – tie threaded through holes