1. Lecture 4: Operational Amplifiers
What can you do with infinite gain?
Introduction to Engineering Electronics
STOLEN FROM K. A. Connor
11/7/2018

2. Introduction to Engineering Electronics
Some History
Fairchild
0.60 Inches
1964: The First Linear IC
The µA702 Op-Amp
12 Transistors
Designer: Bob Widlar
1965: A Best-Seller
The µA709 Op-Amp
14 Transistors
Designer: Bob Widlar
Introduction to Engineering Electronics
STOLEN FROM K. A. Connor
11/7/2018

3. 2 Minute Quiz Name_______ Section________ Date_________
What is the voltage measured by the blue probe?
Introduction to Engineering Electronics
STOLEN FROM K. A. Connor
11/7/2018

4. What can you do with infinite gain?
The goal of amplifier designers: huge gain.
What are the problems and opportunities associated with infinite gain?
First, we need a model.
Introduction to Engineering Electronics
STOLEN FROM K. A. Connor
11/7/2018

5. Introduction to Engineering Electronics
Op-Amp
Introduction to Engineering Electronics
STOLEN FROM K. A. Connor
11/7/2018

6. Introduction to Engineering Electronics
Ideal Op-Amp Model
Gain is infinite
Input resistance is infinite
Output resistance is zero
Input voltage is zero
Input current is zero
Introduction to Engineering Electronics
STOLEN FROM K. A. Connor
11/7/2018

7. Ideal Op-Amp Continued
Bandwidth is also infinite. Thus, an ideal op-amp works the same at all frequencies.
Introduction to Engineering Electronics
STOLEN FROM K. A. Connor
11/7/2018

8. Introduction to Engineering Electronics
Feedback
Like most engineered systems, the op-amp uses feedback to realize its potential value.
Feedback comes in two forms
Positive Feedback
Negative Feedback
It seems like positive feedback might be best, but negative feedback makes the op-amp work
Introduction to Engineering Electronics
STOLEN FROM K. A. Connor
11/7/2018

9. Feedback Examples From a Zoology Course
You just ate a Krispy Kreme donut and your blood glucose levels are on the rise. In response to this rise, the pancreas is releasing insulin into the blood stream stimulating storage of glucose. As a result, blood glucose levels begin to drop. Is this an example of positive or negative feedback?
A woman is in labor, pressure receptors in the birth canal send messages to her brain that result in increased contraction of the uterus and increased pressure in the birth canal. Is this positive or negative feedback?
Introduction to Engineering Electronics
STOLEN FROM K. A. Connor
11/7/2018

10. Feedback: Valve Example
As the water nears the specified level, the valve is closed.
Negative feedback is most commonly used to control systems.
Introduction to Engineering Electronics
STOLEN FROM K. A. Connor
11/7/2018

11. Golden Rules for Op-Amps
The output attempts to do whatever is necessary to make the voltage difference between the two inputs zero. (Negative Feedback is Required)
The inputs draw no current.
Introduction to Engineering Electronics
STOLEN FROM K. A. Connor
11/7/2018

12. Positive and Negative Feedback
Connecting the output to the positive input is positive feedback
Connecting the output to the negative input is negative feedback
Introduction to Engineering Electronics
STOLEN FROM K. A. Connor
11/7/2018

13. Op-Amp Configurations
Buffer or Voltage Follower
No voltage difference between the output and the input
Draws no current, so it puts no load on the source
Used to isolate sources from loads
Introduction to Engineering Electronics
STOLEN FROM K. A. Connor
11/7/2018

14. Op-Amp ConfigurationsV2
Non-Inverting Amplifier
No voltage difference between inputs
Resistors act like voltage divider
Introduction to Engineering Electronics
STOLEN FROM K. A. Connor
11/7/2018

15. Op-Amp Configurations
Non-Inverting Amplifier Continued
Combining the two equations for the voltages gives us the relationship between input and output
Note that this formula uses different variables in the lab write up
Introduction to Engineering Electronics
STOLEN FROM K. A. Connor
11/7/2018

16. Op-Amp ConfigurationsV2
Inverting Op-Amp
Current through R1 equals the current through Rf
No current in the inputs
The voltage at both inputs is zero
Introduction to Engineering Electronics
STOLEN FROM K. A. Connor
11/7/2018

17. Op-Amp Configurations
Inverting Op-Amp Continued
Current through R1
Current through Rf
Introduction to Engineering Electronics
STOLEN FROM K. A. Connor
11/7/2018

18. 2 Minute Quiz Name______ Section_______ Date________
What is the voltage measured by the green probe?
Introduction to Engineering Electronics
STOLEN FROM K. A. Connor
11/7/2018

19. Op-Amp Configurations
Why the minus sign for the current through Rf?
The convention for Ohm’s Law is that the current flows from the high voltage to the low voltage for a resistor
Here the current flows from the low voltage (ground) to the high voltage (VO)
Introduction to Engineering Electronics
STOLEN FROM K. A. Connor
11/7/2018

20. Op-Amp Configurations
Inverting Op-Amp Continued
The current through R1 must equal the current through R2 since there is no current in the inputs.
Combining the two equations for the currents
Introduction to Engineering Electronics
STOLEN FROM K. A. Connor
11/7/2018

21. Op-Amp Configurations
Inverting Summing Amplifier
Each input resistor contributes to the current.
Introduction to Engineering Electronics
STOLEN FROM K. A. Connor
11/7/2018

22. Op-Amps: Practical Issues
Op-Amps require power
741 requires plus and minus 15V
Others may require only positive or both positive and negative voltages
Output voltage is limited to
Usually filter capacitors are connected to power to reduce noise
Introduction to Engineering Electronics
STOLEN FROM K. A. Connor
11/7/2018

23. Op-Amps: Practical Issues
Note: Literally a Black Box
We use real op-amps: 741
Note the pin connections for the IC
Introduction to Engineering Electronics
STOLEN FROM K. A. Connor
11/7/2018

24. Op-Amps: Practical Issues
Note the pins (not all are used)
Extra resistor corrects offset problem
Introduction to Engineering Electronics
STOLEN FROM K. A. Connor
11/7/2018

25. Introduction to Engineering Electronics
ICs come in many types of packages. We will use the 8-pin, dual-in-line or DIP package
Note the other offset nulling circuit
Introduction to Engineering Electronics
STOLEN FROM K. A. Connor
11/7/2018

26. Where Will You See This Information Next?
Op-amps: Many Courses Including
ECSE-2010 Electric Circuits
ECSE-2050 Analog Electronics
Feedback and Control
ENGR-2350 Embedded Control
ECSE-4440 Control Systems Engineering
ECSE-496x Control Systems Design
Introduction to Engineering Electronics
STOLEN FROM K. A. Connor
11/7/2018

27. Introduction to Engineering Electronics
Embedded Control
Studio Classroom
Introduction to Engineering Electronics
STOLEN FROM K. A. Connor
11/7/2018

28. Introduction to Engineering Electronics
Introduction to Engineering Electronics
STOLEN FROM K. A. Connor
11/7/2018

29. Feedback and Control Example
The inverted pendulum is like balancing a baseball bat
Introduction to Engineering Electronics
STOLEN FROM K. A. Connor
11/7/2018

30. Inverted Pendulum Experiment
Introduction to Engineering Electronics
STOLEN FROM K. A. Connor
11/7/2018

31. Introduction to Engineering Electronics
Magnetic Levitation
Trains can magnetically fly over a roadbed with position sustained by some kind of control system
Our next lab is on maglev
Introduction to Engineering Electronics
STOLEN FROM K. A. Connor
11/7/2018

32. More Magnetic Levitation
Introduction to Engineering Electronics
STOLEN FROM K. A. Connor
11/7/2018

33. 2 Minute Quiz Name_______ Section________ Date__________
What is the voltage measured by the red probe?
Introduction to Engineering Electronics
STOLEN FROM K. A. Connor
11/7/2018

34. Introduction to Engineering Electronics
Answers
The green probe: 10V
The red probe: 1V
The blue probe: 0V
Voltage Divider:
Introduction to Engineering Electronics
STOLEN FROM K. A. Connor
11/7/2018

35. Introduction to Engineering Electronics
Engineering Ethics
Electrical and Computer Engineers do not usually face immediate ethical issues involving public health and safety
System control is one of many exceptions
From the IEEE Code of Ethics
We agree to accept responsibility in making engineering decisions consistent with the safety, health and welfare of the public, and to disclose promptly factors that might endanger the public or the environment;
Introduction to Engineering Electronics
STOLEN FROM K. A. Connor
11/7/2018