1. Electronic Game

2. This is what the board looks like on the copper side…
This is what the board looks like on the copper side…. This is where you solder.

3. This gives you an idea where each of the components is to go
This gives you an idea where each of the components is to go. ALL components must be placed on this side.

4. Resistors
100R
BROWN BLACK BROWN
10K
BROWN BLACK ORANGE
There is ONE 10K resistor, and SEVEN that are 100. (These are marked as ‘R’ on the board, one for each LED)

5. Chip holder (Dil socket Duel in line)
Carefully fit the Dil socket
Ensure the notch is facing the correct way
Use masking tape to hold it in place
Very carefully solder the Dil sockets 8 legs

6. SWITCHES
The push to make and the slide switch go into position – both can be either way around

7. The LEDs need to be attached using the height jig
The LEDs need to be attached using the height jig. Make sure you place them correctly, with the positive and negative legs in the right holes
Flat edge _ +

8. Add power lead
3 V
0 V