1. Square Tube Shaft Connecting Both Gear Drives.
Make Adjustments from Hydraulic Shaft End ONLY

2. End Opposite From Hydraulic Shaft. Leave this Bolt and Nut in Place.

3. Slide at the Opposite End Should Move In Toward Cabin.
Remove Bolt and With a Crescent Wrench, Rotate Square Tube Shaft 90 Degrees (1/4 Turn for 1” of Movement at Opposite End). Observe the Direction of Rotation and Make Sure Slide Moves the Slide IN Toward Cabin.
Slide at the Opposite End Should Move In Toward Cabin.
Drill “New” Holes in Square Tube Shaft ONLY. Do NOT Drill Gear Drive Shaft.
Reinsert Bolt and Tighten Nut.

4. Rotate Shaft Forcing the Opposite End to Move Inward Toward the Cabin
Square Tube Shaft Connecting Both Gear Drives.
Make Adjustments from Hydraulic Shaft End ONLY