1. 7. Test operation

4. 2) MUF*, RVMC060GAM0 Outdoor Address Setting Each Outdoor has its
own address (Never Use “0”)
Tracking Number
Display
Enrolled
Indoor
Address
Remark
KEY 1
KEY 2
KEY 3
KEY4
1st Input
20min-Pump Down
60min-Charging
Reset
24hr-Test Running
2nd Input
Stop -

5. Data Display (View Mode)
3) RVMH*
Communication Error
Mode Display
Data Display (View Mode)
Remark
KEY 1
KEY 2
KEY 3
KEY4
1st Input
Heating Mode
Charging
Cooling Mode
Reset
View Mode
(1st ~ 12th)
Pressure
Temperature
Valve Step
2nd Input
Test-run -
3rd Input
Finish
Pump Down
4th Input

6. (cooling capacity up))
4) RVMH* Function Key
Data Display (View Mode)
Communication Error
Mode Display
Push Type : K1, K2, K3, K4
Slide Type 3 : K13, K14, K15
Slide Type 1 : K5, K6, K7, K8
Slide Type 2 : K9, K10 ,K11,K12
Key Type
Category
Push Type
K1 (Heating Mode)
K2 (Cooling Mode)
K3 (Reset)
K4 (Data Display)
Slide Type 1 K5
(operating Mode) K6
(operating Mode)) K7
(cooling capacity up) K8
(cooling capacity up))
Slide Type 2 K9
(Heating capacity up)
K10
K11
(Defrost UP)
K12
(Defrost Down)
Slide Type 3
K13 (3Φ, 1Φ )
K14
(comp capacity fix)
K15 (Capacity)
opition
(R22 / R407C)

7. 6) Indoor PCB of Cooling Only
SWO1
Wired Remote Controller Address
& Centralized Controller Address
SWO2 Indoor Unit Address
SW03 : Dip Switch
Key 1 : Wired Remote Controller
Key 2 : Interface Module (Including S_net)
Key 3 : Fan Speed Control (Normal -> Up)
Key 4 : Drain Pump Option(Off -> On)

8. 7) Indoor PCB of Heat Pump
Receiver Wire
Connection
※1WAY : Having No Function on K3, K4, K7, K8
4WAY : Having No Function on K4,K7,K8
SW01,SW02 & SW03 function equally to Cooling Only PCB
SW04
K5 : Temperature compensation
at Heating Mode (2 -> 5℃)
K6 : Filter Duration Time
(1000HR -> 2000HR)
K7 : Water Coil (Off -> On)

16. Thanks !