Download presentation
Presentation is loading. Please wait.
1
Casting Quiz
2
Cope What is the correct name for this tool? Rapping Iron Rammer Striking Off Rod Sprue Pin Draw Pin Vent Spike Gate Cutter
3
2. Which of the above pictures shows the pattern with the correct taper?
4
3) On the diagram above indicate the Runner
5
4. Which metal is most suited to casting in the school workshop?
Steel Copper Aluminium Brass
6
Cope 5. What is the correct name for this tool? Rapping Iron Rammer Striking Off Rod Sprue Pin Draw Pin Vent Spike Gate Cutter
7
Because it has a low melting point Because it melts quickly
6. Why is aluminium the most suitable material for casting in the school workshop? Because it has a low melting point Because it melts quickly Because it is lightweight Because it is Non Ferrous
8
7) On the diagram above indicate the In Gate
9
Cope 8. What is the correct name for this tool? Rapping Iron Rammer Striking Off Rod Sprue Pin Draw Pin Vent Spike Gate Cutter
10
9. What is parting powder used for?
It keeps the sand dry It helps remove impurities from the aluminium It helps stop the sand sticking to the pattern It helps the sand stick together
11
10) On the diagram above indicate the Drag
12
11. Why are a patterns internal edges often curved ?
To make the casting look better To strengthen the casting To make finishing the casting easier
13
Because Cast Iron will rust
12. Why is cast Iron not generally used for casting in a school workshop? Because Cast Iron will rust It has too low a melting point It has too high a melting point
14
10) On the diagram above indicate the Vent holes
15
Cope 14. What is the correct name for this tool? Rapping Iron Rammer Striking Off Rod Sprue Pin Draw Pin Vent Spike Gate Cutter
16
Use a rammer to pack the sand Cut the in and out gates
15. Which of the following stages comes after placing the pattern in the drag Use a rammer to pack the sand Cut the in and out gates Fill the drag with sand Form a pouring cup Coat with parting powder Pour the molten metal into the casting Place the sprue pins Fill the cope with sand
17
16) On the diagram above indicate the Riser
18
17. Which of the following products was mostly made using the process of casting?
A Window Frame A Toolbox A Bench A set of Kitchen Scales
19
Quiz Completed Well Done
20
Wrong Click here to try again
Similar presentations
