1. StressPly® SA FR Mineral System

2. Why Self Adhering? Difficult Access Eliminates Odors
Limited Impact on Owner
Minimal Equipment
High Material Income
Lower Installation Costs

3. Product Improvements Wrinkling – New Scrim M-26
Initial Tack (Stickiness) – Improved (2011)
Selvage Edge Cleanliness – New Film

4. Advanced Compound Softer Compound Bond Maturation
Require Protection Boards
Walkways & Prep Areas
Bond Maturation
Will Not be at Full Strength Immediately
Require Some Time and Heat to Gain Full Bond Strength

5. Substrate Conditions Slope – ½:12 Recommended Approved Insulation:
Clean Surface & Highest Wind Uplift
Primer Recommended Due to Dusty Surface
Primer Recommended – Reduced Wind Uplift (1-90)

6. SA Primer™ Features Benefits Water-Based Primer Quick Drying Product
Cold Applied
Low VOC Product
Low Odor
Benefits
Quick Drying Product
Improved Adhesion & Initial Tack by as Much as Four Times
Meets VOC Regulations & Can Be Used in All Environmentally Sensitive Areas

7. Field Application Endlap Mastic T-Joints Heavy Weighted Rollers
GarlaFlex® or Flashing Bond®
T-Joints
Heavy Weighted Rollers
Hand Held Hot Air Welders for Side Laps

8. Flashing Design 24” Maximum Bends over 45˚ Should be Avoided
Proper Use of Mastic Over Field Plies
Termination Bars
Avoid Multiple Transitions
When in Doubt – Use Cold-Applied Flashings

9. Cold Temperatures 50ºF (10°C) & Rising
Substrate & Materials Temperature Critical
Materials Storage
Cool Night Time Temperatures
Warm and Relax Before Being Properly Installed

10. Warmer Temperatures
Much Softer than Conventional Modified Bitumen Systems
Walkway Areas & Prep Area Protection
Laps May Appear to Not Be Fully Adhered
Oil Migration May Temporarily Discolor Minerals – Bleaching Will Occur

11. Project Oversight Phasing is Not Permitted
Keep Products in the Original Boxes Until Installed
Heavy Weighted Roller
Hand Held Hot Air Weld Guns to Warm Laps
Quality Inspections – Application Sensitivity

12. Summary
The SA Primer is a Water-Based Primer Designed to Improve the Adhesion of Self-Adhering Membranes
The SA Primer Provides Improved Adhesion by Four Times Compared to not Using a Primer over Approved Roof Cover Boards
The StressPly SA FR Mineral System is VOC Compliant for All States and Countries
The StressPly SA FR Mineral System is Installer Friendly, Reducing the Installation Costs and Making the Entire Project More Budget Friendly