1. Under the Guidance of Submitted by
Project Title
CYCLO CONVERTER FOR FUNDAMENTAL, F/2, F/3 USING GATE CONTROLEED THYRISTORS
Under the Guidance of
Submitted by

2. ABSTRACT
A.C. motors have the great advantages of being relatively inexpensive and very reliable.
Induction motors in particular are very robust and therefore used in many domestic appliances such as washing machines, vacuum cleaners, water pumps, and others.
The induction motor may be regarded as practically a constant-speed machine, the difficulty of varying its speed economically constitutes one of its main disadvantages.
This drawback is overcome by using a thyristor controlled cycloconverter that enables the speed to be lowered in steps by Microcontroller triggering a SCR bank of 8nos in F/2 & F/3.

3. PROJECT BLOCK DIAGRAM

4. HARDWARE REQUIREMENTS
POWER SUPPLY BLOCK
MICROCONTROLLER (AT89S52/AT89C51)
OPTOISOLATOR (MOC3021)
 SINGLE PHASE INDUCTION MOTOR
PUSHBUTTON
SCR
LM358
LED
DIODE (IN4007)
RESISTORS
CAPACITORS

5. POWER SUPPLY Bridge rectifier 5v Regulator 230 V AC 50 Hz 5V DC
Filter(470µf)
12V step down
transformer

6. It is a smaller computer Has on-chip RAM, ROM, I/O ports...
MICROCONTROLLER
It is a smaller computer
Has on-chip RAM, ROM, I/O ports...
RAM
ROM
I/O Port
Timer
Serial COM Port
Microcontroller
CPU
A single chip

7. INTERNAL STRUCTURE OF A MICRO CONTROLLER-AT89S52/51
CPU
On-chip RAM
On-chip ROM for program code
4 I/O Ports
Timer 0
Serial Port
OSC
Interrupt Control
External interrupts
Timer 1
Timer/Counter
Bus Control
TxD RxD
P0 P1 P2 P3
Address/Data
Counter Inputs

8. Features of AT89S51/52 Compatible with MCS®-51 Products
8K Bytes of In-System Programmable (ISP) Flash Memory
Endurance: 10,000 Write/Erase Cycles
4.0V to 5.5V Operating Range
Fully Static Operation: 0 Hz to 33 MHz
256 x 8-bit Internal RAM
32 Programmable I/O Lines
Three 16-bit Timer/Counters
Eight Interrupt Sources
Full Duplex UART Serial Channel
Interrupt Recovery from Power-down Mode
Watchdog Timer
Dual Data Pointer

9. Pin Description

10. Optocoupler
Opto coupler is a 6 pin IC. It is a combination of 1 LED and a diac. Pin 5 is not generally used and when light falls on the diac then it switches ON the diac.

11. Contd..
When logic zero is given as input to the LED then the light doesn’t fall on diac so the diac is off means the current does not flow through the diac.
When logic 1 is given as input to the LED then light emitted by LED falls on diac so it starts conducting i.e., now there will be current flowing through the diac.

12. Three Phase Induction Motor
It consists of the fixed stator or frame, a three-phase winding supplied from the three-phase mains and a turning rotor
There is no electrical connection between the stator and the rotor
Stator and rotor are made of highly magnetizable core sheet providing low eddy current and hysteresis losses

13. Stator & Rotor
The stator winding consists of three individual windings which overlap one another and are offset by an electrical angle of 120°
Synchronous Speed (Ns)= 60*f/p
Ns= Synchronous Speed/ minute;
F= frequency;
P=Pole pair Number;
Rotor in induction machines with squirrel-cage rotors consists of a slotted cylindrical rotor core sheet package with aluminum bars which are joined at the front by rings to form a closed cage

14. SCR
A Silicon Controlled Rectifier (or Semiconductor Controlled Rectifier) is a four layer solid state device that controls current flow
An SCR can be seen as a conventional rectifier controlled by a gate signal
It is a 4-layered 3-terminal device
When the gate to cathode voltage exceeds a certain threshold, the device turns 'on' and conducts current

15. Contd..
The operation of a SCR can be understood in terms of a pair of tightly coupled Bipolar Junction Transistors
SCR has three states:
Reverse blocking mode, forward blocking mode, and forward conducting mode

16. LM358
The LM358 series consists of two independent, high gain; internally frequency compensated operational amplifiers which were designed specifically to operate from a single power supply over a wide range of voltages.
Operation from split power supplies is also possible and the low power supply current drain is independent of the magnitude of the power supply voltage.
Features
Available in 8-Bump micro SMD chip sized package.
Large dc voltage gain: 100 Db.
Wide power supply range:
Single supply: 3V to 32V
or dual supplies: ±1.5V to ±16V
Very low supply current drain (500 µA)-essentially independent of supply voltage.

17. WORKING OF PROJECT
The project uses zero voltage reference ,8 Opto isolators(MOC3021) are used for driving 8 SCR’s. Triggering pulses so generated by the MC as per the program written provides input condition to the Opto isolator that drive the respective SCR to get conducting for 20ms from 1st bridge and next 20ms from the 2nd bridge to get the output, total time period of one AC cycle of 40ms which is 25 Hz.
Thus F/2 is delivered to the load while switch 1 is closed. Similarly for F/3 the conduction takes place for 30ms in the 1st bridge and next 30ms from the next bridge, such that a total time period of 1 cycle comes to 60ms which in turn in F/3 while switch -2 is operated. Fundamental frequency of 50Hz is available by triggering on pair from the 1st bridge for 1st 10ms and for the next 10msfrom the next bridge while both the switches are kept in “OFF” condition. Reverse current flowing in the gates of the SCR’s are Opto – isolator output.

18. Software Requirements
Keil an ARM Company makes C compilers, macro assemblers, real-time kernels, debuggers, simulators, integrated environments, evaluation boards, and emulators for ARM7/ARM9/Cortex-M3, XC16x/C16x/ST10, 251, and 8051 MCU families.
Compilers are programs used to convert a High Level Language to object code. Desktop compilers produce an output object code for the underlying microprocessor, but not for other microprocessors.

19. i.e the programs written in one of the HLL like ‘C’ will compile the code to run on the system for a particular processor like x86 (underlying microprocessor in the computer).
For example compilers for Dos platform is different from the Compilers for Unix platform  So if one wants to define a compiler then compiler is a program that translates source code into object code.

20. BIBILOGRAPHY
“The Microcontroller and Embedded systems” by Muhammad Ali Mazidi and Janice Gillispie Mazidi , Pearson Education.
ATMEL 89S52 Data Sheets.

21. THANKYOU