1. Installation of the Hook & Go II onto the Colorado Belts
Fire Innovations
Installation of the Hook & Go II onto the Colorado Belts

2. Installation of the Hook & Go II on Colorado Belts
All Hook & Go Lumbar rope storage bags are worn in the lumbar area, just below where the SCBA would rest.
The descent device is stored in a small pouch in the front of the belt or harness.
The Hook & Go II is made of fire resistant material.

3. Installation of the Hook & Go II
Lumbar Bag & Single Pouch Shown on Cheyenne II.

4. Installation of the Hook & Go II
Flip the belt over and then slide
the lumbar bag strap under the belt.

5. Installation of the Hook & Go II
Bend the straps around the belt and
connect the Pull the Dot Snaps.

6. Installation of the Hook & Go II
Important:
Pull the Dot Snap are directional snaps and
can only be snapped and pulled in one direction.

7. Installation of the Hook & Go II
Slide the plastic insert into the front gear loop.

8. Installation of the Hook & Go II
Wrap and secure the Velcro around the belt

9. Installation of the Hook & Go II
Place NFPA Positioning Ring
under the lumbar bag.

10. Installation of the Hook & Go II
Connect your descent device of
Your choice to the D-Ring