1. REPAIRING MOULDING PROTECTOR, TRANSFER/DECORATION, STICKER AND SPOILER
REPAIR MOULDING PROTECTOR, TRANSFER/DECORATION AND DECAL
BODY OTOMOTIF (F-022)
SK – KD 07

2. TARGET OF LEARNING ACTIVITY
Student can know way release moulding, transfer and decal
Student can know way installing moulding, transfer and decal
Teknologi dan Rekayasa

3. WAY OF INSTALLING PART INSTALLING SIDE PROTECTION MOULDING
SETTING UP TRANSFER
SETTING UP DECAL OR LIS
Teknologi dan Rekayasa

4. INSTALLING SIDE PROTECTION MOULDING
Clean the surface or moulding by cleaner.
Teknologi dan Rekayasa

5. INSTALLING SIDE PROTECTION OF MOULDING
Heat body surface 40-60oC (when installing moulding, surface temperature must 20oC or more).
Teknologi dan Rekayasa

6. INSTALLING SIDE PROTECTION OF MOULDING
Heat moulding will be installed at 20-30oC (don’t use high temperature, maximal 80oC).
Teknologi dan Rekayasa

7. INSTALLING SIDE PROTECTION OF MOULDING
Smear up adhesive to outside part of moulding, the shiny part and set it up 30 minutes after smearing up adhesive
Teknologi dan Rekayasa

8. INSTALLING SIDE PROTECTION OF MOULDING
Release moulding release sheet from moulding surface
Teknologi dan Rekayasa

9. INSTALLING SIDE PROTECTION OF MOULDING
Attach moulding by setting the cover on the hole on to the bodY and press the moulding evenly.
Teknologi dan Rekayasa

10. INSTALLING SIDE PROTECTION OF MOULDING
Clean up rest of adhesive by using plastic spatula and clean up the surface with dry cloth
After installing, don’t the vehicle in 24 hours
BACK
Teknologi dan Rekayasa

11. SETTING UP TRANSFER
Allocate the material of transfer on panel surface. Sign up the transfer size with pencil. Make sure that material is given more than ½ inchies
Drag the back part of paper from transfer material
Teknologi dan Rekayasa

12. SETTING UP TRANSFER
Use sponge, wet up the back part of transfer dan panel surface
Apply the transfer on the panel quickly
Teknologi dan Rekayasa

13. SETTING UP TRANSFER
Clean up transfer surface with rubber cleaner to release the bubble
Heat up if the transfer is difficult to be formatted wil the hollow on the car surface
Teknologi dan Rekayasa

14. SETTING UP TRANSFER Use knife to cut up the rest of transfer size
Set back the whole component of car being released
BACK
Teknologi dan Rekayasa

15. SETTING UP DECAL OR LIS
Allocate decal on the panel surface and sign it up with pencil
Teknologi dan Rekayasa

16. SETTING UP DECAL OR LIS
Take up the decal with the hanging position of masking tape
Teknologi dan Rekayasa

17. SETTING UP DECAL OR LIS Release the back part of the paper from decal
Teknologi dan Rekayasa

18. SETTING UP DECAL OR LIS Roll up the decal in straight position
Teknologi dan Rekayasa

19. SETTING UP DECAL OR LIS
Twist up point of decal till the point part or end part of panel, don’t let the air inside
BACK
Teknologi dan Rekayasa

20. END SEASION
BYE -BYE
Teknologi dan Rekayasa