1. UniBond™ ST Polyester-Faced Adhesive Tape

2. UniBond ST
High-Performance, Fatigue Resistant, 100% Solids Polyester-Faced Adhesive Tape
Designed to Seal and Reinforce Seams and Penetrations on a Variety of Metal and Single-Ply Roof Systems
Compatible With:
CPR™ White
Revitalizer™ Metal
White-Knight®/Stallion®
White-Knight/Stallion Plus Cold-Applied

3. Benefits Seals and Reinforces Seams Long-Term Movement Compatibility
Reduces Labor and Application Time
Advanced Micro-Sealant Technology
User Friendly
Low-Temperature Flexibility

4. Uses Seals Metal and Single-Ply Roofs Joints Seams Tears Flashings
Copings
Skylights
Gutters

5. Materials and Equipment
Non-Residue, Solvent-Based Cleaner
Rags or Cloth
Abrasive Cleaning Pad
Wire Brush
Steel Weighted Roller (Optional)
Scissors
UniBond ST Roll

6. Surface Preparation Surface Must be Clean and Dry
Use Non-Residue, Solvent-Based Cleaner
Power Wash the Surface, Including Flashings
Remove Rust and Flaking Paint
Scrape, Sand, Wire Brush or Proper Media Blasting
Remove All Silicone Materials
Score the Surface of Single-Ply Roofs

7. Application Steps Locate the Area to be Sealed or Repaired
Clean the Surface
Remove Release Liner
Apply UniBond ST
Apply Pressure
Inspect the Tape
Apply Approved Garland Cold Process Roof Coating

8. 1. Locate Area to be Sealed/Repaired

9. 2. Clean the Surface Surface Must Be Clean and Dry
Remove Oil, Grease, and Silicone Materials
Remove Rust and Flaking Paint

10. 3. Remove Release Liner Grab Edges with Thumb and
Forefinger Then Push Fingers
Together, Bunching the Tape
in the Middle
Quickly Snap the Tape Back
and Forth 7-10 Times
Push Fingers Together Again,
Allowing Liner to “Pop” From the Tape
Peel Liner From Tape in Short,
Workable Sections

11. 4. Apply UniBond ST
Apply Tape Uniformly to the Surface to Prevent Wrinkles and Other Discrepancies
Do Not Stretch
Material

12. 5. Apply Pressure Use Steel Roller or Hands to Apply Pressure
Pressure Will Activate the Bonding Process & Removes Minor Discrepancies
For Best Results, Use a Steel Weighted Roller

13. 6. Inspect The Tape Ensure that UniBond ST is Uniformly Adhered
Use Steel Roller to Remove Remaining Discrepancies

14. 7. Apply Coating System
UniBond ST Must Be Coated On the Day of Application
Approved Cold Process Coatings Include:
CPR™ White
Revitalizer™ Metal
White-Knight®/
White-Stallion®
White-Knight/
White-Stallion Plus