CASSETE RECORDER REPAIRING Competency : Repairing of Compact Cassete Recorder

OBJECTIVE Teknologi dan Rekayasa Can be understood and to understand how to improve cassette recorder

Doing Damage Inspection Teknologi dan Rekayasa Forward and Rewind is rotating slowly or with varying speed before recording / playback. This occurs because the battery general weakening

Teknologi dan Rekayasa Unable to record. Note the position of the recording protection (protection records) at the bottom of the tape that can be removed to prevent the tape from the recording process of elimination, or excessive. If the hole is removed, we can not record on tape

Teknologi dan Rekayasa Only the recorded noise during recording. Check the LINE IN jack located on the side VersaCorder, and make sure that the source of the sound with low levels have been linked.

Teknologi dan Rekayasa Playbcak voice become disabled. If the sound defects arise during playback, so make sure that the voices of the recipients are on a low level

Teknologi dan Rekayasa There is a beep tone on the tape. Check the switch below player beeps and be sure to be in the off position

Teknologi dan Rekayasa Often heard the sound of "click" of the tape. Check whether the counter has shown a count of If this happens, then do not play but simply by pressing the reset button in order to counter back to the starting position

Teknologi dan Rekayasa Player (VersaCorder) damage to tape cassettes. Use tape that is not more than 110 minutes to prevent damage. Let me rewind and forward buttons to test the tape rotation. If the player sustained congestion, it is necessary to repair or even replacement of mechanical RewindForward

Teknologi dan Rekayasa Sound levels produced when playback is too weak and a voice hissed. Possible recording made of the sound source is set too weak. For that, make sure that VersaCorder really connected to the sound source. The next step is to increase the volume and make the recording and re-tested with the change in volume for this new recording. If the sound level from the source (input) is too weak, then only the hiss sound from the motor rotation will be recorded and the voice signal becomes disabled

THE END Teknologi dan Rekayasa By. Setyo Harmadi,ST SMK Muhammadiyah 3 Yogyakarta