Front Tracker: main technical solutions 40x50 cm 2 module Front Tracker Chamber: 40x150 cm 2  Use COMPASS approach: 3xGEM, 2D readout - one significant.

Slides:

Advertisements

Similar presentations

20/Oct./2000 CF IEEE NSS 2000 at Lyon,France 1 An MWPC Readout Chip for High Rate Environment Introduction ASIC Structure & Fabrication ASIC Evaluation.

Advertisements

GEM Detectors for AnDY Nilanga Liyanage University of Virginia 1 Outline GEM chamber concept Large area GEM chamber projects Proposed GEM configuration.

The LHCb Inner Tracker LHCb: is a single-arm forward spectrometer dedicated to B-physics acceptance: (250)mrad: The Outer Tracker: covers the large.

Nilanga Liyanage University of Virginia UVa GEM Team Dr. Kondo Gnanvo, Dr. Vladimir Nelyubin, Kiadtisak Saenboonruang, Chao Gu, Xinzhan Bai, Jie Liu, Seth.

INFN GEM Front Tracker 2012 Oct 18 / SBS Coll. / JLabE. Cisbani1 V. Bellini, M. Capogni, E. Cisbani, S. Colilli, F. Giuliani, M. Gricia, F. Librizzi, M.

Outline Experiments Setup and DAQ configuration Fastbus for SBS: performance and status GEn/GMn - trigger and DAQ GEp - trigger and DAQ GEM readout Outline.

1 SBS Spectrometer / GEP5 Conf.. 2 Tracking Requirements Requirements Tracking Technology DriftMPGDSilicon High Rate: MHz/cm 2 (Front Tracker)

12/Dec/2012SBS-Meeting1 of 24 Status of the Front Tracker GEM and INFN Electronics 2013 – Feb – 20 SBS Weekly Meeting GEM Assembling SRS – INFN Electronics.

SPHENIX GEM Tracker R&D at BNL Craig Woody BNL sPHENIX Design Study Meeting September 7, 2011.

SBS Coll. Meeting - Front Tracker GEM

SuperB igbite Spectrometer in Hall A Background: photon ( MHz/cm 2 ) charged ( kHz/cm 2 ) 1 Large luminosity Moderate acceptance Forward.

25/05/2010 RD51 Collaboration Meeting Cisbani-Musico-Minutoli / Status JLab Electronics 1 Status of the APV25 electronics for the GEM tracker at JLab Evaristo.

Updates on GEMs characterization with APV electronics K. Gnanvo, N. Liyanage, K. Saenboonruang.

Gif++ CR tracker setup G. Aielli for the RPC collaboration.

VC Feb 2010Slide 1 EMR Construction Status o General Design o Electronics o Cosmics test Jean-Sebastien Graulich, Geneva.

CM26 March 2010Slide 1 EMR Status o Intro o Construction o Magnetic shielding o Electronics o Prototype Cosmics test o Schedule Jean-Sebastien Graulich,

GEM chambers for SoLID Nilanga Liyanage University of Virginia

1 Tracking system based on GEM chambers Evaristo Cisbani Italian National Institute of Health and INFN Rome – Sanità Group PAVI – 09 / September.

25/05/2010 RD51 Collaboration Meeting Cisbani-Musico-Minutoli / Status JLab Electronics 1 Status of the APV25 electronics for the GEM tracker at JLab Evaristo.

M. Alfonsi LNF/INFN Cagliari 5 May 2006 M1R1 mechanical requirements  Space constraint Frame and pannel Pads readout and trigger sectors Gas inlet and.

John LeRose March 12, A Program of three “projects” to assemble the Super BigBite Spectrometer for a series of experiments in Hall A There is a.

Tariq J. Solaija, NCP Forward RPC EDR, Tariq Solaija Forward RPC EDR The Standard RPC for low  regions Tariq J. Solaija National Centre for.

Installation and operation of the LHCb Silicon Tracker detector Daniel Esperante (Universidade de Santiago de Compostela) on behalf of the Silicon Tracker.

The Bigbite second GEM tracker. SBS GEM Trackers Front Tracker Geometry x6 18 modules In Italy  50 cm x 40 cm Modules are assembled to form larger chambers.

12/Dec/2012SBS-Meeting1 of 24 Status of the Front Tracker GEM and INFN Electronics 2012 – Dec – 12 SBS Weekly Meeting GEM Assembling SRS – INFN Electronics.

HallA/SBS – Front Tracker PARAMETERDESIGN VALUE Microstrip Silicon Detector Number of tiles/plane and size2 Number of planes2 Size of the single

14/6/2000 End Cap Muon Trigger Review at CERN 1 Muon Track Trigger Processing on Slave and Hi-pT Boards C.Fukunaga/Tokyo Metropolitan University TGC electronics.

GEM chambers for SoLID Nilanga Liyanage University of Virginia.

GEM chambers for SoLID Nilanga Liyanage University of Virginia.

Super-Belle Vertexing Talk at Super B Factory Workshop Jan T. Tsuboyama (KEK) Super B factory Vertex group Please visit

Chamber construction Construction Tools Production sites Assembly Sequence (“travelers”) Manpower P. Campana LNF – LHCb Muon EDR Cern April 16 th, 2003.

Update on SBS Back Tracker UVa K. Gnanvo, N. Liyanage, V Nelyubin, K. Saenboonruang, Seth Saher, Nikolai Pillip (visiting from Univ. Tel Aviv, Israel)

GEM R&D Update Kondo Gnanvo. Outline  GEM R&D and assembly facilities at UVa  Cosmic test results  Update on the 40 × 50 cm 2 GEM prototype  Plans.

JLab 22/Jan/2010 SBS - Review E. Cisbani / SBS Trackers 1 Concepts and Status of the GEM trackers Evaristo Cisbani / INFN-Rome Sanità Group SBS - Review.

GEM Trackers for Super BigBite Spectrometer (SBS) in Hall JLab The Super Big Bite Spectrometer (SBS) is one of the major new equipment in hall A in.

Front GEM Chambers Design concepts –Foils –Mechanics Electronics and DAQ Performance Current activity and plan Evaristo Cisbani / INFN-Rome Sanità group.

Update on the Triple GEM Detectors for Muon Tomography K. Gnanvo, M. Hohlmann, L. Grasso, A. Quintero Florida Institute of Technology, Melbourne, FL.

1 TPC R&D proposal from the WIS group I. Ravinovich WIS I. Ravinovich12/15/2015.

Total Cross Section, Elastic Scattering and Diffraction Dissociation at the LHC January 17, 2003TOTEM plenary meeting -Marco Bozzo1 CSC detectors for T1.

APV25 Electronics for GEMs at UVa and for the 12 GeV Upgrade Program in HallA at JLab RD51 Electronic School, February 3-5, 2014 Kondo Gnanvo University.

GEM Detector R&D at Florida Tech – “Get to know each other” –

Front End Board (16 channels) Superlayer Cross Section Frontend Enclosure HV cap board HV cap Board Signals from chamber wires go to HV cap board to be.

SoLiD/PVDIS DAQ Alexandre Camsonne. DAQ limitations Electronics Data transfer.

Jefferson Laboratory Hall A SuperBigBite Spectrometer Data Acquisition System Alexandre Camsonne APS DNP 2013 October 24 th 2013 Hall A Jefferson Laboratory.

Calibration of the gain and measurement of the noise for the apv25 electronics K. Gnanvo, N. Liyanage, C.Gu, K. Saenboonruang From INFN Italy: E. Cisbani,

The BoNuS Detector Concept Design Status Howard Fenker March 11, 2005.

Test of the GEM Front Tracker for the SBS Spectrometer at Jefferson Lab F. Mammoliti, V. Bellini, M. Capogni, E. Cisbani, E. Jensen, P. Musico, F. Noto,

Large-Area GEM Detector Development at CMS, RD51, and Fl. Tech – A brief overview – Marcus Hohlmann Florida Institute of Technology, Melbourne, FL PHENIX.

09/10/2010 RD51 Collaboration Meeting Cisbani-Musico-Minutoli / Status JLab Electronics 1 Status of the APV25 electronics for the GEM tracker at JLab Evaristo.

Abstract Beam Test of a Large-area GEM Detector Prototype for the Upgrade of the CMS Muon Endcap System V. Bhopatkar, M. Hohlmann, M. Phipps, J. Twigger,

Application of Large Scale GEM for Digital Hadron Calorimetry Jae Yu For GEM DHCAL Group June 11, 2011 TIPP 2011 The Goals 30cmx30cm 2D readout with KPiX.

The 12 GeV equipment Hall D – Hall D – GLUEx detector for photoproduction experiments Hall B – Large acceptance detector CLAS12 for high luminosity measurements.

MPD HW & firmware status UVa Back Tracker parts status SBS JLAB 1 16 December 2015 Paolo Musico and Evaristo Cisbani GEM Readout Update.

RD51 GEM Telescope: results from June 2010 test beam and work in progress Matteo Alfonsi on behalf of CERN GDD group and Siena/PISA INFN group.

1- Handling The Olympus GEMs at MIT-BATES between June 6th-August 8th Manufacturing The GEMs at HU-GEM LAB since Sep 2010 OZGUR ATES HAMPTON UNIVERSITY.

Uva GEM R&D Update –Part I Kondo Gnanvo, Nilanga Liyanage, Vladimir Nelyubin, Kiadtisak Saenboonruang, Taylor Scholz and Adarsh Ramakrishnan In Collaboration.

Juin 1st 2010 Christophe Beigbeder PID meeting1 PID meeting Electronics Integration.

T2 GEM Production in Helsinki Kari Kurvinen TOTEM T2 EDR meeting Radiation Detector Laboratory of Helsinki Institute of Physics (HIP) and Department.

PID meeting SNATS to SCATS New front end design

Application of VATAGP7 ASICs in the Silicon detectors for the central tracker (forward part) S. Khabarov, A. Makankin, N. Zamiatin, ,

CMS EMU TRIGGER ELECTRONICS

Status of the Front Tracker GEM

Example of DAQ Trigger issues for the SoLID experiment

Concepts and Status of the GEM trackers

SBS Front Tracker GEM short update on inefficient sectors

L H C A T L A S International Collaboration on the LHC Project

Physics program in Hall A for the CEBAF 12 GeV era

PID meeting Mechanical implementation Electronics architecture

DAQ for SBS GEM SBS collaboration meeting August 6th 2019

A DLC μRWELL with 2-D Readout

Presentation transcript:

Front Tracker: main technical solutions 40x50 cm 2 module Front Tracker Chamber: 40x150 cm 2  Use COMPASS approach: 3xGEM, 2D readout - one significant difference: new single mask GEM foil (instead of double mask) – cheaper and faster production  Modular design: chambers consists of 3 independent GEM modules (40x50 cm 2 ) with thin dead area  Electronics around the module, direct connection; 90 degree bending between modules  External support frame in carbon fiber (long bars) to minimize thermal deformation SBS Front Tracker1 Requirements: Hit spatial resolution ~ 70  m Stand large background (  ~ 250 MHz/cm 2, e/  160 kHz/cm 2 ) Transverse area > 40x120 cm 2 Event rate ~ 20 kevents/s Reuse: SBS/GEp5, BigBite/Gen, BigBite/A1n …

Gluing Finalization (solder resistor, check HV) Stretching Electronics integration Test and characterization by rad. source and cosmics Permaglas Frames Visual Inspection Ultrasound bath cleaning GEM Foils HV curing and quality test Put together (align on reference pins) Glue Curing in vacuum (>24 h) Assembling gas lines Electronics Test SBS Front Tracker2 Clean room Module production fully established in Catania Module characterization in Rome Production speed 1 module/month FT: GEM Module construction process

Front Tracker: Readout Systems Based on APV25 chip (from CMS) Topology: Chamber Strips  FE (APV25)  Backplane  MPD (VME)  DAQ Custom design, compliant to JLab DAQ environment; reviewed October/2012 by fast electronics and DAQ experts; First version succesfully used in the OLYMPUS experiment in SBS Front Tracker3 VME crate 128 analog ch / ASIC 3.4  s trigger latency (analog pipeline) Capable of sampling signal at 40 MHz Radiation tolerant Multiplexed analog output Configurable / Calibration circuit

Real Experiment: Olympus, 2012 From Jürgen Diefenbach The APV electronics has been installed on the Olympus 3xGEM tracker made of 6 10x10 chambers with 2D readout (pad/strip – about 2500 chs), operating in a magnetic field at the level of few kG. Two events with opposite magnet polarity; particles bend left o right in the x-histogram (Red triangles show hit candidates) SBS Front Tracker Use of the INFN readout electronics 4