1 Other Transistor Topologies 30 March and 1 April 2015 The two gate terminals are tied together to form single gate connection; the source terminal is.

Slides:

Advertisements

Similar presentations

MICROWAVE FET Microwave FET : operates in the microwave frequencies

Advertisements

ECA1212 Introduction to Electrical & Electronics Engineering Chapter 6: Field Effect Transistor by Muhazam Mustapha, October 2011.

Justin Chow Jacob Huang Daniel Soledad ME 4447/6405 Student Lecture.

Chapter 6 The Field Effect Transistor

J-FET (Junction Field Effect Transistor) Introduction The field-effect transistor (FET) controls the current between two points but does so differently.

Transistors These are three terminal devices, where the current or voltage at one terminal, the input terminal, controls the flow of current between the.

MOSFETs Monday 19 th September. MOSFETs Monday 19 th September In this presentation we will look at the following: State the main differences between.

FET ( Field Effect Transistor)

NAME OF FACULTY : MR. Harekrushna Avaiya DEPARTMENT: E.C. (PPI-1ST) BASIC ELECTRONICS.

Lecture 11: MOS Transistor

1 CMOS Digital System Design MOS Transistor DC Operation.

Field-effect transistors ( FETs) EBB424E Dr. Sabar D. Hutagalung School of Materials & Mineral Resources Engineering, Universiti Sains Malaysia.

Metal Semiconductor Field Effect Transistors

10/8/2004EE 42 fall 2004 lecture 171 Lecture #17 MOS transistors MIDTERM coming up a week from Monday (October 18 th ) Next Week: Review, examples, circuits.

Lecture #16 OUTLINE Diode analysis and applications continued

The metal-oxide field-effect transistor (MOSFET)

Week 8b OUTLINE Using pn-diodes to isolate transistors in an IC

Chap. 5 Field-effect transistors (FET) Importance for LSI/VLSI –Low fabrication cost –Small size –Low power consumption Applications –Microprocessors –Memories.

EE314 IBM/Motorola Power PC620 IBM Power PC 601 Motorola MC68020 Field Effect Transistors.

Metal-Oxide-Semiconductor Field Effect Transistors

Lecture 19 OUTLINE The MOSFET: Structure and operation

Chapter 28 Basic Transistor Theory. 2 Transistor Construction Bipolar Junction Transistor (BJT) –3 layers of doped semiconductor –2 p-n junctions –Layers.

Introduction to FET’s Current Controlled vs Voltage Controlled Devices.

Transistors Three-terminal devices with three doped silicon regions and two P-N junctions versus a diode with two doped regions and one P-N junction Two.

Field-Effect Transistor

Module 2 Bipolar Junction Transistor. Learning Outcomes 1.The 3 terminals or regions of a BJT. 2.Construction and symbol of NPN and PNP types 3.Low power.

Bipolar Junction Transistor (BJT) Chapter March and 2 April 2014 Operation involves both electrons and holes, so is called “bipolar” Junction E-B.

FET ( Field Effect Transistor)

EEE1012 Introduction to Electrical & Electronics Engineering Chapter 7: Field Effect Transistor by Muhazam Mustapha, October 2010.

Digital Integrated Circuits© Prentice Hall 1995 Introduction The Devices.

Principles & Applications

Intro to Mechatronics 18 February 2005 Student Lecture: Transistors

Field Effect Transistors Next to the bipolar device that has been studied thus far the Field Effect Transistor is very common in electronic circuitry,

Chapter 5: Field Effect Transistor

© 2013 The McGraw-Hill Companies, Inc. All rights reserved. McGraw-Hill 5-1 Electronics Principles & Applications Eighth Edition Chapter 5 Transistors.

1 Metal-Oxide-Semicondutor FET (MOSFET) Copyright  2004 by Oxford University Press, Inc. 2 Figure 4.1 Physical structure of the enhancement-type NMOS.

BJTs. Transistor The transistor is the main building block “element” of electronics. A transistor is a semiconductor device used to amplify and switch.

Field Effect Transistor. What is FET FET is abbreviation of Field Effect Transistor. This is a transistor in which current is controlled by voltage only.

Filed Effect Transistor.  In 1945, Shockley had an idea for making a solid state device out of semiconductors.  He reasoned that a strong electrical.

NOTES 27 March 2013 Chapter 10 MOSFETS CONTINUED.

ECE340 ELECTRONICS I MOSFET TRANSISTORS AND AMPLIFIERS.

Chapter 2 – Transistors – Part 2 Field Effect Transistors (Unipolar Transistors) (Charge carriers: either electrons or holes)

UNIT I MOS TRANSISTOR THEORY AND PROCESS TECHNOLOGY

Structure and Operation of MOS Transistor

ISAT 436 Micro-/Nanofabrication and Applications Transistors David J. Lawrence Spring 2004.

MOSFET Placing an insulating layer between the gate and the channel allows for a wider range of control (gate) voltages and further decreases the gate.

McGraw-Hill 5-1 © 2013 The McGraw-Hill Companies, Inc. All rights reserved. Electronics Principles & Applications Eighth Edition Chapter 5 Transistors.

TRANSISTOR - Introduction BIPOLAR JUNCTION TRANSISTOR (BJT)

Junction Field Effect Transistor

1 DMT 121 – ELECTRONIC DEVICES CHAPTER 5: FIELD-EFFECT TRANSISTOR (FET)

Spencer/Ghausi, Introduction to Electronic Circuit Design, 1e, ©2003, Pearson Education, Inc. Chapter 2, slide 1 Introduction to Electronic Circuit Design.

Field Effect Transistor (FET)

Farzana R. ZakiCSE 177/ EEE 1771 Lecture – 19. Farzana R. ZakiCSE 177/ EEE 1772 MOSFET Construction & operation of Depletion type MOSFET Plotting transfer.

Introduction Semiconductors are materials whose electrical properties lie between Conductors and Insulators. Ex : Silicon and Germanium.

Field Effect Transistors

MOSFET V-I Characteristics Vijaylakshmi.B Lecturer, Dept of Instrumentation Tech Basaveswar Engg. College Bagalkot, Karnataka IUCEE-VLSI Design, Infosys,

course Name: Semiconductors

COURSE NAME: SEMICONDUCTORS Course Code: PHYS 473 Week No. 9.

SILVER OAK COLLEGE OF ENGG. & TECHNOLOGY  SUB – Electronics devices & Circuits  Topic- JFET  Student name – Kirmani Sehrish  Enroll. No

BJT transistors FET ( Field Effect Transistor) 1. Unipolar device i. e. operation depends on only one type of charge carriers (h or e) 2. Voltage controlled.

Transistors Different types and sizes BJT (PNP) Electrical Diagram First Transistor Modern Electronics FET and BJT Transistor.

Regions of a Transistor A Bipolar Junction Transistor is a three terminal device containing 3 regions: Emitter, Base and Collector.

J-FET (Junction Field Effect Transistor)

Other Transistor Topologies

Bipolar Junction Transistor (BJT) Chapter and 25 March 2016

TRANSISTOR - Introduction

Bipolar Junction Transistor (BJT) Chapter and 17 March 2017

Other Transistor Topologies

Bipolar Junction Transistor (BJT) Chapter and 27 March 2019

Other Transistor Topologies

Presentation transcript:

1 Other Transistor Topologies 30 March and 1 April 2015 The two gate terminals are tied together to form single gate connection; the source terminal is grounded The flow of electric charge through a PN JFET is controlled by constricting the current-carrying channel; the width of the channel is controlled by the gate voltage through varying the depletion region at the PN junction at the interface between the gate and the channel The current also depends on the electric field between source and drain JFET Junction Field Effect Transistor

2 Structure of JFET a long channel of n-type (N-channel) or p-type (p-channel) semiconductor. Two ohmic contacts with each at one end of the channel: the source and the drain The gate (control) terminal has doping opposite to that of the channel, so there is a PN junction at the interface between the junction and the channel. The contact from gate to outside is also ohmic. N-channel JFET

3

4

5 I-V relationship of PN JFET Nonsaturation region (linear region) Saturation region

6 Other Features of PN JFET Symbols of JFET (arrow represents the polarity of the PN junction) JFET is unipolar device since only majority carriers transport in the channel The source and drain region are interchangeable N-channel devices have greater conductivity than p-channel types, since electrons have higher mobility than holes The gate current is approximately zero since the PN junction is reverse biased

7 Comparisons of Transistors BJTMOSFETJFET Structure NPN: n ++ p + n PNP: p ++ n + p n(p)-type inversion layer structure as channel from S to D Inversed biased PN junction between the gate and channel from S to D Current transport Diffusion Drift Carriers involved in current transport Bipolar: electrons and holes Unipolar NMOS: electrons PMOS: holes Unipolar: N-channel: electrons P-channel: holes Current at terminals I C =βI B = (1/α) I E (Forward active mode) I C =f(V BE, V BC ) I G =0 I D =f(V GS, V DS ) I G ≈0 I D =f(V GS, V DS )

Comparisons of Transistors (Cont’d) BJTMOSFETJFET Symbols Applications Current-controlled current amplifier Switch for digital signal Discrete circuits Voltage-controlled current amplifier Switch for digital signal IC circuits Voltage-controlled current amplifier Switch for digital signal IC circuits MESFET can be used in higher- frequency than PN-JFET due to higher electron mobility in GaAs NPN PNP NMOSPMOS N-channel P-channel 8

9

10

11

12