Quality of Water Q litres Time to Collect Water secs Volume Flow Rate Q litres/min Pump 1 Inlet Pressure P 1 bar Pump 1 Outlet Pressure.

Slides:

Advertisements

Similar presentations

840 MW of Green Electric generated per Day in 10 Acres of land

Advertisements

CE 382, Hydraulic Systems Design (pipes, pumps and open channels) Principles of hydraulics 1.Conservation of energy 2.Continuity (conservation of mass)

PRESSURE TEST Hook tester up to tank inlet line. Pump tester up to 10psi (.7 bar) The line and carb should hold pressure for 1-min. Checks for leaks at.

PARKER BOILER PARKER BOILER HOT WATER PIPING SYSTEM 1. 3 way valve and O.S.A. reset. 2. Single boiler piping schematic. 3. Single boiler with 3 way valve.

Fluid Mechanics 07.

Service Delivery 3 Hydraulics. Aim To ensure students can explain the principles of obtaining and delivering water.

Thermodynamics Design of 4- stage Helium compressor L. Zhou MMAE, UCF.

Detention Basin Saw Tooth Outlet Structure. Detention Basin Water Flow In Saw Tooth Outlet Structure On Site Water Off Site Water.

Gambit Overview Ahmadi/Nazridoust ME 437/537/637.

Sand clay Hydraulic Capture clay piezometric surface.

Fluid Mechanics 06. Energy, Work and Power Work:- Work is force acting through a distance when the force is parallel to the direction of motion. Energy:-

Radial Pump Impeller Design (Example)

ESS 454 Hydrogeology Instructor: Michael Brown

Hydraulic Pumps and Cylinders

Assignment No. 1 [Grup 8] Figure below shows a portion of a hydraulic circuit. The pressure point B must be 200 psig when the volume flow rate is 60 gal/min.

HYDRAULICS_5 Design of Irrigation Systems by László Ormos.

Mounting Direction Water Cooler Best solution OK Risk of air bubbles in the system Heatsink Water channels Inlet Outlet.

Hydraulic Engineering

Components of Centrifugal pumps

Basic Principles of Hydraulics

1 ME421 Heat Exchanger Design Drain Water Heat Recovery System Project Presentation Group #5.

1 intake for the fuel-air mixture 2 supercharger (here: rotary vane pump; original: Centrix) 3 airbox to buffer and distribute the mixture 4 waste valve.

Comparison of water supply systems Water supply system for MRC-1000

Engineer Training Cooler TJ8300 / TJ8500 Cooler. Engineer Training Cooler TJ8300 / TJ8500 Confidential 2 Introduction.

Fluids, Work and Power: Student Success Criteria I can solve problems and conduct an investigation related to the relationships between force, area, pressure,

Hydraulic Kit (pump and tank) Pictures from prototype.

ENTC-303PROF. ALVARADO1 Fluid Mechanics Lab: Positive Displacement Pumps ENTC

Computational fluid dynamics Authors: A. Ghavrish, Ass. Prof. of NMU, M. Packer, President of LDI inc.

Modeling and Design Diaphragm Micropump

PRINCIPLE & CONSTRUCTION OF HYDRAULIC PUMPS

Available Water Flow Meter Size Typical flow depending on size

Surfaces Task Task 1Task 2Task 3Task 4 Task 5Task 6Task 7Task 8 Task 9 NC Level 6 to 8+

Introduction to Lobe Pumps

Page 1 Sapphire by pass line  Design Concept of Cooling Water System ： Funnel 10 line Tank 2 10 tones Chiller -20cm tilt - 5cm distance between growers.

Parul Institute of Technology

TURBOMACHINES Chapter 6 CENTRIFUGAL PUMPS

From ASABE definitions 2.13 manifold: The water delivery pipeline that supplies water from the submain or main to the laterals. Manifolds.

Submitted by Pradeep pataskar Roll no.11031M02034.

Salt Questions.

Groundwater movement Objective To be able to calculate the hydraulic conductivity of a sample given measurements from a permeameter To be able to evaluate.

Date of download: 6/23/2016 Copyright © ASME. All rights reserved. From: Heat Transfer and Pressure Drop Analysis of Chilled Water and Ice Slurry in a.

FLUID POWER CONTROL ME604C. FLUID POWER MODULE:02 ~ HYDRAULIC SYSTEM COMPONENTS.

BASICS OF HYDRAULICS. 1) 1)DEFINITIONS 1.1) HYDRAULICS 1.2) CLASSIFICATION 1.2.1) HYDROSTATICS 1.2.2) HYDRODYNAMICS 1.3) FORCE, PRESSURE, AREA 1.4) PASCAL’S.

Radial Flow to an Unconfined Aquifer From Mays, 2011, Ground and Surface Water Hydrology.

Date of download: 7/10/2016 Copyright © ASME. All rights reserved. From: Mechanical Efficiency of Hydraulic Air Compressors J. Energy Resour. Technol.

Hydraulic axial forces acting on a Francis runner.

Pumped Discharge. Brian Makin 14/

Date of download: 10/21/2017 Copyright © ASME. All rights reserved.

Technical data‘s of lubrication pumps of oil loaded gas compressors medium : lubrication oil with flare gas Low pressure compressors on oil platform 6.

Date of download: 11/8/2017 Copyright © ASME. All rights reserved.

Basic principles of hydraulic symbols

Groundwater-Surface Water Interactions

HIGH PERFORMANCE LEVEL CONTROL.

KFA45 Hydraulic System Overview

The Intervals pane sets the total duration of the simulation.

كار همراه با آسودگي و امنيت

Cavitation Demonstration Unit (Font: Arial Font Size: 32 )

Hydraulic axial forces acting on a Francis runner

1” inline filter with strainer cartridge

1” inline filter with water indicator cartridge

1A iAquaMax™ Kidney / water removal system

நீரே உயிர் நாம் செய்யும் அல்லது தினமும் பயன்படுத்தும் ஒவ்வொன்றிலும் நிச்சயமாக நீரின் பங்கு இருக்கும். இருப்பினும், நாம் அதற்குக் தகுந்த முக்கியத்துவம்

Groundwater vocabulary

Head Loss in storm water systems Check valves

All dimension in mm Set A

50 m EML3015C Thermal-Fluid I Fall 2000 Homework 4

Characteristic values

1 Traffic volumes at different T T = 5 sec T = 1 sec T = 10 msec.

Presentation transcript:

Quality of Water Q litres Time to Collect Water secs Volume Flow Rate Q litres/min Pump 1 Inlet Pressure P 1 bar Pump 1 Outlet Pressure P 2 bar Pump 1 Manometric Head H m metres Pump 1 Hydraulic Power W h Watts

Quality of Water Q litres Time to Collec Water t secs Volume Flow Rate Q litres/min Pump 1 Inlet Pressure P 1 bar Pump 1 Outlet Pressure P 2 bar Pump 1 Manometric Head H m metres Pump 1 Hydraulic Power W h Watts Pump 2 Inlet Pressure P1 bar Pump 2 Outlet Pressure P2 bar Pump 2 Manometric Head H m metres Pump 2 Hydraulic Power W h Watts Overall Manometric Head H m metres Overall Hydraulic Power W h Watts