PCB Traces CK Cheng CSE Dept. UCSD 1. PCB Traces 2.

Slides:



Advertisements
Similar presentations
Suspended Substrates and Their Applications in High Speed Communications By Ron Miller, Consultant, Signal Integrity Design, GHz Data, Newark California.
Advertisements

1 Designing for DVI General Applications Considerations.
Intermediate Course (5) Antennas and Feeders Karl Davies East Kent Radio Society EKRS 1.
CS 140 Lecture 16 System Designs Professor CK Cheng CSE Dept. UC San Diego 1.
ENE 428 Microwave Engineering
ENE 428 Microwave Engineering
1 Chelmsford Amateur Radio Society Intermediate Licence Course Carl Thomson G3PEM Slide Set 9: v1.2, 31-May-2009 Antennas & Feeders Chelmsford Amateur.
Lecture 6. Chapter 3 Microwave Network Analysis 3.1 Impedance and Equivalent Voltages and Currents 3.2 Impedance and Admittance Matrices 3.3 The Scattering.
EKT 441 MICROWAVE Communications
USC Signal Integrity Lab Course 2 Ansoft High Frequency Structure Simulator (HFSS) ELCT 762 USC.
SQUARE PAD PCB DESIGN Elizabeth Starling, Jerry Collins Florida Institute of Technology High Energy Physics Lab A January 26 th, 2015.
Performance Regions CK Cheng CSE Dept. UCSD. Attenuation Curves.
MAXWELL’S EQUATIONS AND TRANSMISSION MEDIA CHARACTERISTICS
® WPD WORKSTATION PRODUCTS DIVISION 1 Page 1 IEEE EPEP2000 Via and Return Path Discontinuity Impact on High Speed Digital Signal Qinglun Chen, Intel WPD.
Here’s a partial schematic we’ll use to illustrate the advantage of a ground plane. The idea is that an output pin on the microprocessor is driving an.
Performance Regions CK Cheng CSE Dept. UCSD. Spectral Content (0,f knee ) f knee = 0.5/t r Hz fedge= 0.35/t r Hz t r = T bit width.
ELCT564 Spring /2/20151ELCT564 Chapter 4: Microwave Network Analysis.
MB4 New compared with MB3: Digital drivers / transformer drivers options 14 OPAMPS instead of 4 Thinner coaxial cables Shorter umbilical Heater coil integrated.
Technician License Course Chapter 2 Radio and Electronics Fundamentals
Link A/D converters and Microcontrollers using Long Transmission Lines John WU Precision Analog - Data Converter Applications Engineer
Differential Signals EECS 713 Project by Jay Fuller :) What are they? When to use them Traces, connectors, terminations, etc.
VELO upgrade electronics – HYBRIDS Tony Smith University of Liverpool.
Various Topics Related to FEB Liang Han, Ge Jin University of Science and Technology of China Dec.21,2013.
Revised: Aug 1, EE4390 Microprocessors Lessons 29, 30 Welcome to the Real World!
Microwave Engineering, 3rd Edition by David M. Pozar
PROFIBUS wiring/installation can be done with:
ECE 546 – Jose Schutt-Aine 1 ECE 546 Lecture -04 Transmission Lines Spring 2014 Jose E. Schutt-Aine Electrical & Computer Engineering University of Illinois.
Penn ESE370 Fall DeHon 1 ESE370: Circuit-Level Modeling, Design, and Optimization for Digital Systems Day 35: December 5, 2012 Transmission Lines.
Section 3.1: Wires, Cables, and Connectors Scott Glogovsky and Jonathon Sturm Scott Glogovsky and Jonathon Sturm.
Transmission Lines No. 1  Seattle Pacific University Transmission Lines Kevin Bolding Electrical Engineering Seattle Pacific University.
Microwave Network Analysis
IPC Power Distribution Considerations A predominately important factor that should be considered in the design of a printed board is power distribution.
High Speed Interconnect Solutions HIROSE ELECTRIC IT3-32mm SI Report Three-Piece Mezzanine Connector for 20+ Gbps Applications October 29, 2009.
Yi HUANG Department of Electrical Engineering & Electronics
11/22/2004EE 42 fall 2004 lecture 351 Lecture #35: data transfer Last lecture: –Communications synchronous / asynchronous –Buses This lecture –Transmission.
Penn ESE370 Fall DeHon 1 ESE370: Circuit-Level Modeling, Design, and Optimization for Digital Systems Day 36: December 6, 2010 Transmission Lines.
Example Snapshots From Some Of The Signal Integrity Interactive Software Modules The following slides highlight some of the output graphs/plots from the.
Global Circuit Page 1  Basic Design Rule for Advanced PCB (1) 1. High speed current path Load Driving gate Current trace At low frequency current, follows.
1 Evaluation and Analysis of Connector Performance for the Spacewire Back Plane Koji Shibuya Keitaro Yamagishi Hideyuki Oh-hashi Seiichi Saito Masaharu.
ENE 428 Microwave Engineering
Getting faster bandwidth HervéGrabas Getting faster bandwidth - Hervé Grabas1.
1 Chelmsford Amateur Radio Society Intermediate Licence Course Carl Thomson G3PEM Slide Set 9 Antennas & Feeders Chelmsford Amateur Radio Society Intermediate.
Chapter 2 Transmission Line Theory (2.1 ~ 2.5) 전자파연구실 1.
Performance Regions CK Cheng CSE Dept. UCSD 1. Attenuation Curves 2.
The Different Types of Inductors and Their Affecting Factors
Grounding & Shielding Ved Prakash Sandlas Director General
Transmission Line Studies Need to understand data transmission at 640 Mbps along bus tape. Analytic formulae FEA calculations from Roy. Network analyser.
TERMINATIONS Copyright F. Canavero, R. Fantino Licensed to HDT - High Design Technology.
HDT, 1998: Resistance, Inductance, Capacitance, Conductance per Unit Length Lossless case.
Piero Belforte, HDT 1998: Advanced Simulation and Modeling for Electronic System Hardware Design Part3
Smith Chart & Matching Anurag Nigam.
High-Speed Serial Link Layout Recommendations –
ENE 428 Microwave Engineering
How to debug PMP systems A guideline for Application Engineers
Electromagnetic Compatibility BHUKYA RAMESH NAIK 1.
ENE 325 Electromagnetic Fields and Waves
High-Speed Serial Link Layout Recommendations –
ENE 429 Antenna and Transmission lines Theory
ENE 429 Antenna and Transmission lines Theory
Band Pass Filter Design & Simulation
Impedance & Bandwidth Measurements of '2-strip anode test plate'
Impedance & Bandwidth Measurements of '2-strip anode test plate'
Impedance & Bandwidth Measurements of '2-strip anode test plate'
Subject Name: Microwave and Radar Subject Code: 10EC54
Two-Plate Waveguide
Applied Electromagnetic Waves
ENE 428 Microwave Engineering
Bernard Lim et al. JACEP 2016;2:
plane waves in lossy material
Transmission Lines Chris Allen
Presentation transcript:

PCB Traces CK Cheng CSE Dept. UCSD 1

PCB Traces 2

AC Resistance and Skin Effect at 1GHz 3

Magnetic Field of Strip Line 4

Trace loss from C to 67 0 C 5

Non-TEM Modes 6

DC Handling 7

Signal Reflection 8

Trace Compensation 9

Source Termination 10

End Termination 11

Fly-by Termination 12

Impedance Matching 13

Impedance Matching 14

Cross Talks 15

Cross Talks 16

Ground Plane 17

Connector 18

Surface Mount Connector 19

Coaxial Connector 20

Vias: Measurement 21

Vias: Dangling 22

Vias: Pads Stripped 23

Vias: Return Paths 24

Vias: Return Paths 25

Via Arrangement 26

Via: Cross Talks 27

Vias: Cross Talks 28

Vias: Configurations 29

Vias: Configurations 30

Feedback: Privacy Policy Feedback
Do Not Sell My Personal Information
About project: SlidePlayer Terms of Service

© 2024 SlidePlayer.com Inc. All rights reserved.