Zultys Technologies 771 Vaqueros Avenue Sunnyvale CA 94085 USA Tel: +1-408-328-0450 Fax: +1-408-328-0451 www.zultys.com Device Management on the MX250.

Slides:



Advertisements
Similar presentations
Voice over Internet Protocol at Space Telescope Science Institute.
Advertisements

Managing Cisco IOS Software. Overview The router boot sequence Locating IOS software The configuration register Recovering Passwords Backing Up the Cisco.
Emergency Call Handling on the MX Page 2 Overview Many countries around the world –different emergency numbers –different emergency laws IP PBX equipment.
CCNA1 v3 Module 9 v3 CCNA 1 Module 9 JEOPARDY K. Martin Galo Valencia.
KX-NS Step by Step Guide KX-NT/UT Phone Registration
DSL-2730B, DSL-2740B, DSL-2750B.
MX25: Multifunction SIP Gateway Zultys Technologies.
CIM 2465 IP Addressing Scheme1 IP Addressing Scheme (Topic 4) Textbook: Networking Basics, CCNA 1 Companion Guide, Cisco Press Cisco Networking Academy.
Cisco S2 C7 Router Operation System IOS. Routers Boot From Flash memory TFTP server ROM (not full Cisco IOS software) –Default depends on platform –Order.
1 Dynamic DNS. 2 Module - Dynamic DNS ♦ Overview The domain names and IP addresses of hosts and the devices may change for many reasons. This module focuses.
1 ZIP 4x5 The world’s most functional telephone. 2 PSTN Internet Dallas, TX Sunnyvale, CA VPN Outside callers dial a single extension - phone at the office.
IP TERMINALS.
1 Basic Installation and GUI Tech Basic Installation and GUI : Objectives  Installing the Quadro  Configuring the Quadro  Installing IP phones.
KX-NS1000 Initial Set Up For step by step : 16 May,
DHCP Dynamic Host Configuration Part 7 NVCC Professional Development TCP/IP.
MCDST : Supporting Users and Troubleshooting a Microsoft Windows XP Operating System Chapter 13: Troubleshoot TCP/IP.
DHCP Dynamic Host Configuration Protocol by: Kirk Z. Moreno.
Chapter 23: ARP, ICMP, DHCP IS333 Spring 2015.
1 System Settings When this module is complete, you will be able to:  Navigate the admin-level web interface pages  Set a new name for your system 
1 Soft Phone Installation and Registration Step by Step Instructions By Prof. Valencia Community College.
What’s New in Fireware XTM v WatchGuard Training.
© 2007 Cisco Systems, Inc. All rights reserved.ICND1 v1.0—4-1 LAN Connections Using a Cisco Router as a DHCP Server.
© 2008 Cisco Systems, Inc. All rights reserved.CIPT1 v6.0—3-1 Enabling Single-Site On-Net Calling Understanding Endpoints in Cisco Unified Communications.
1 © 2003, Cisco Systems, Inc. All rights reserved. CCNA 2 Module 5 Managing Cisco IOS Software.
IP Momentum Confidential Polycom IP Phone Provisioning Guide—Sylantro- hosted Service Release /06/05.
17 th Jan 06 IP40 Sales Brief. 2Plantronics, Inc. Contact Center Desktop – The changes Infrastructure in the contact center is now following the trends.
Chabot College ELEC autoinstall and SLARP.
© 2007 NeoAccel, Inc. NeoAccel SGX Installation Guide Dear Customer: We are pleased to provide you with our training presentation for our SSL VPN-Plus.
1. 2 Move to PKG (SCME) Prepare the new SCME IP phone package and Upload package to SCME System by SCME Admin. CONFIGURATION  Phone Setting  File Upload.
Introduction to Networking Concepts. Introducing TCP/IP Addressing Network address – common portion of the IP address shared by all hosts on a subnet/network.
Starting the switch Configuring the Switch
UNIVERSITI UTARA MALAYSIA BPMN 6053 MANAGEMENT INFORMATION SYSTEM SEMESTER MARCH 2011 ASSIGNMENT TITLE: A SOHO Network Administration PREPARED FOR: DR.
Call Manager Basic Configuration Wael K. Valencia Community College.
Allocating IP Addressing by Using Dynamic Host Configuration Protocol (DHCP)
© 2007 Cisco Systems, Inc. All rights reserved.ICND1 v1.0—5-1 Module Summary  A WAN allows the transmission of data across broad geographic distances.
Scott Drucker, Systems Engineer Migrating to Microsoft Vista with WinINSTALL.
1 Version 3.0 Module 6 Switch Configuration. 2 Version 3.0 Switches Contain: –CPU –RAM –Operating System.
SERVER I SLIDE: 5. Objectie 4.2 The DHCP IP address assignment process.
Module 2: Allocating IP Addressing by Using Dynamic Host Configuration Protocol (DHCP)
TCP/IP (Transmission Control Protocol / Internet Protocol)
DataFlow Diagram – Level 0
Customer Requirement Survey
Network Addressing Tom Harper, Martell Maten, Robert Pohlman, Jarrod Rotolo.
Objectives Blue Color VLAN’s Should reach Message Server from all locations Red Color VLAN’s Should not Reach Message Server In Each L2 Switch Blue Color.
Allocating IP Addressing by Using Dynamic Host Configuration Protocol.
Unit 2 - Hardware Networking. What is a network? A computer network is essentially a connection between two or more computers. This connection can be.
Network Management CCNA 4 Chapter 7. Monitoring the Network Connection monitoring takes place every day when users log on Ping only shows that the connection.
195Eg Ethernet Wired LAN. 38,400,N,8,1 RJ-45 Connector (RS-232) Terminal Window (HyperTerminal, ESTeem Utility, Putty, TerrTerm, etc) Serial Port Access.
MICROSOFT TESTS /291/293 Fairfax County Adult Education Courses 1477/1478/1479.
Dynamic Host Configuration Protocol DHCP Every device that connects to a network needs a unique IP address. Network administrators assign static IP addresses.
Chapter 38 Initialization & Configuration. Bootstrapping occurs during boot up to obtain boot program which may then load operating system may use network.
(ITI310) By Eng. BASSEM ALSAID SESSIONS 9: Dynamic Host Configuration Protocol (DHCP)
DHCP Vrushali sonar. Outline DHCP DHCPv6 Comparison Security issues Summary.
System Optimization Networking
Open source IP Address Management Software Review
Administering Microsoft Response Point How to deploy and manage Microsoft Response Point hardware and software Joe Schurman Founder, Executive Director.
Unit 7: DHCP, APIPA and NTP. Static versus dynamic IP addressing Dynamic IP addresses can change each time you connect to the Internet, while static IP.
Pass4itsure Cisco Dumps
Advanced Configuration
Module 8: Networking Services
Cisco Exam CCNP Collaboration
Note: All Public IPs are from Same Range ISP Router
Chapter 9: IOS Images and Licensing
Network Models, Hardware, Protocols and number systems
تنظیم مودم Triz به حالت NAT
Allocating IP Addressing by Using Dynamic Host Configuration Protocol
How to install HP printer using IP address? How to install HP printer using IP address? Call
AbbottLink™ - IP Address Overview
KX-NS Step by Step Guide KX-NT/UT Phone Registration
Establish, configure and maintain a website/system
Presentation transcript:

Zultys Technologies 771 Vaqueros Avenue Sunnyvale CA USA Tel: Fax: Device Management on the MX250 A brief introduction

January 2004Device Management on the MX2502 Managed vs. Unmanaged Phones and soft phones are devices Managed devices –added to the MX by an administrator –configuration can be controlled from MX –software can be updated from MX Unmanaged devices –registered to a user’s SIP address or extension –not added by an administrator –configuration not controlled by MX –software not updated by MX

January 2004Device Management on the MX2503 Managed Devices — Mechanism Administrator adds device (phone) in Admin UI Admin UI automatically creates a configuration file –file is identified by MAC address of device File is saved on a TFTP server Device obtains its address using DHCP DHCP server provides address of TFTP server Device reads configuration file on boot up –downloads from TFTP server

January 2004Device Management on the MX2504 Deployment Possibilities DHCP server internal or external to MX250 –MX250 can supply IP addresses for PCs and phones TFTP server internal or external to the MX250 –holds configuration files and software

January 2004Device Management on the MX2505 Internal DHCP and TFTP Servers MX250 Switch 1) DHCP request 1 2 2) DHCP response (specifies address of TFTP server) 3 3) TFTP request 4) TFTP response (retrieve configuration file) 5) SIP Registration (identifies device to MX250) 4 5 Administrator selects TFTP and DHCP servers to be internal to MX250

January 2004Device Management on the MX2506 External DHCP and TFTP Servers MX250 Switch TFTP Server DHCP Server 5) TFTP request 5 4) DHCP response (specifies address of TFTP server) 4 6) TFTP response (configuration file) 6 7) SIP registration 7 1) Administrator selects TFTP and DHCP servers to be external to MX250 3) DHCP request 3 2) MX250 sends configuration files to external TFTP server 2

January 2004Device Management on the MX2507 Managing Devices at Remote Site Remote site may have its own DHCP server Site may also have a TFTP server DHCP server will provide invalid TFTP address –phone at remote site would not get its configuration –phone would be unmanaged by Admin UI Overcome by using TFTP override Fix address of TFTP server on phone –ignores address provided by DHCP server

January 2004Device Management on the MX2508 Main site Remote site Router ZIP 2 ZIP 4x4 MX250 DHCP Server TFTP Server ZIP 2ZIP 4x4 Router TFTP Override Switch TFTP Server DHCP Server Switch 1) DHCP request 2) DHCP response (specifies TFTP server) 3) TFTP request (uses server specified by admin) 4) TFTP response (configuration file) 5) SIP registration Phone at remote site uses TFTP override –phone ignores address of TFTP server received by DHCP –uses fixed IP address of TFTP server set by Admin UI Two sites with unique IP address ranges Full IP connectivity between sites using routers Each site has its own TFTP server