AME 513 Principles of Combustion Lecture 7 Conservation equations.

Slides:



Advertisements
Similar presentations
FEA Course Lecture V – Outline
Advertisements

Lecture 20: Laminar Non-premixed Flames – Introduction, Non-reacting Jets, Simplified Description of Laminar Non- premixed Flames Yi versus f Experimental.
AME 436 Energy and Propulsion Lecture 3 Chemical thermodynamics concluded: Equilibrium thermochemistry.
Chapter 2 Introduction to Heat Transfer
MAE 5310: COMBUSTION FUNDAMENTALS
Laminar Premixed Flames and Diffusion Flames
AME 513 Principles of Combustion Lecture 8 Premixed flames I: Propagation rates.
AME 513 Principles of Combustion
AOSS 321, Winter 2009 Earth System Dynamics Lecture 10 2/10/2008 Christiane Jablonowski Eric Hetland
Mass and energy analysis of control volumes undergoing unsteady processes.
1 Open Systems -- Part 2 Physics 313 Professor Lee Carkner Lecture 24.
Development of Dynamic Models Illustrative Example: A Blending Process
Energy Thermodynamics Professor Lee Carkner Lecture 3.
For next time: Outline: Important points: Read: § 5-2 to 5-3
Lecture 1: Energy and Enthalpy Reading: Zumdahl 9.1 and 9.2 Outline –Energy: Kinetic and Potential –System vs. Surroundings –Heat, Work, and Energy –Enthalpy.
Energy Transfer By Heat, Work, and Mass
Numerical Hydraulics Wolfgang Kinzelbach with Marc Wolf and Cornel Beffa Lecture 1: The equations.
EGR 334 Thermodynamics Chapter 6: Sections 11-13
Instructor: André Bakker
Flow and Thermal Considerations
St Venant Equations Reading: Sections 9.1 – 9.2.
Deduction of Fundamental Laws for Heat Exchangers P M V Subbarao Professor Mechanical Engineering Department I I T Delhi Modification of Basic Laws for.
Winter Jordanian German Academy Feb Governing Equations for Combustion Processes Prepared By: Rasha Odetallah & Fatima Abbadi.
Chap. 3 (Sec. 3-5 to End of Chapter) Mass Flow Rate =  A V (kg/s) Volume Flow Rate = A V (m 3 /s) V = velocity.
BASIC EQUATIONS IN INTEGRAL FORM FOR A CONTROL VOLUME – CH 4
Dr. R. Nagarajan Professor Dept of Chemical Engineering IIT Madras Advanced Transport Phenomena Module 2 Lecture 4 Conservation Principles: Mass Conservation.
5. MASS AND ENERGY ANALYSIS OF CONTROL VOLUMES
Fluid Mechanics and Applications MECN 3110
Energy Balance Equation
The First Law of Thermodynamics
Control Volume Analysis Using Energy
Louisiana Tech University Ruston, LA Momentum Balance Steven A. Jones BIEN 501/CMEN 513 Monday, March 19, 2007.
Thermodynamics I Chapter 4 First Law of Thermodynamics Open Systems Mohsin Mohd Sies Fakulti Kejuruteraan Mekanikal, Universiti Teknologi Malaysia.
Conservation of mass If we imagine a volume of fluid in a basin, we can make a statement about the change in mass that might occur if we add or remove.
Lesson 22 BERNOULLI’S EQUATION
Mathematical Equations of CFD
Basic Fluid Properties and Governing Equations
THERMOCHEMISTRY Courtesy of lab-initio.com. Definitions #1 Energy: The capacity to do work or produce heat. Potential Energy: Energy due to position or.
Reynolds Transport Theorem We need to relate time derivative of a property of a system to rate of change of that property within a certain region (C.V.)
DYNAMIC BEHAVIOR OF PROCESSES :
CE 1501 CE 150 Fluid Mechanics G.A. Kallio Dept. of Mechanical Engineering, Mechatronic Engineering & Manufacturing Technology California State University,
Dr. Jason Roney Mechanical and Aerospace Engineering
MAE 5310: COMBUSTION FUNDAMENTALS Detonation Mechanical and Aerospace Engineering Department Florida Institute of Technology D. R. Kirk.
Abj1 1.System, Surroundings, and Their Interaction 2.Classification of Systems: Identified Volume, Identified Mass, and Isolated System Questions of Interest:
Review -1 School of Aerospace Engineering Copyright © by Jerry M. Seitzman. All rights reserved. AE/ME 6766 Combustion AE/ME 6766 Combustion:
STAAR Ladder to Success Rung 9. Energy Defined as the ability to do work or produce heat Many forms – Light energy – Nuclear energy – Electrical energy.
MAE 5360: Hypersonic Airbreathing Engines
INTRODUCTION TO CONVECTION
Dr. R. Nagarajan Professor Dept of Chemical Engineering IIT Madras
Work Readings: Chapter 11.
CHAPTER 4 The First Law of Thermodynamics for Control Volumes.
Thermodynamic Processes Chapter First Law of Thermodynamics Imagine a roller coaster that operates without friction. The car is raised against.
Unit 61: Engineering Thermodynamics
AME 436 Energy and Propulsion
ENZO ZANCHINI Università di Bologna AVAILABILITY FUNCTIONS AND THERMODYNAMIC EFFICIENCY 3. Availability functions.
1 Chapter 5 Mass and Energy Analysis of Control Volumes.
ME 475/675 Introduction to Combustion
General form of conservation equations
Mass and Energy Analysis of Control Volumes
COMBUSTION TA : Donggi Lee PROF. SEUNG WOOK BAEK
ME 475/675 Introduction to Combustion
Fluid kinematics Chapter 3
COMBUSTION TA : Donggi Lee PROF. SEUNG WOOK BAEK
MAE 4261: AIR-BREATHING ENGINES
MAE 4262: Rockets and Mission Analysis
COMBUSTION TA : Donggi Lee PROF. SEUNG WOOK BAEK
COMBUSTION TA : Donggi Lee PROF. SEUNG WOOK BAEK
Chapter 4 Energy Balances without reaction.
Basic concepts of heat transfer: Heat Conduction
Chemical Equilibrium Mass transfer takes place from higher chemical potential to lower chemical potential. If the chemical potential of reactants are.
Presentation transcript:

AME 513 Principles of Combustion Lecture 7 Conservation equations

2 AME Fall Lecture 7 - Conservation equations Outline  Conservation equations  Mass  Energy  Chemical species  Momentum

3 AME Fall Lecture 7 - Conservation equations Conservation of mass  Cubic control volume with sides dx, dy, dz  u, v, w = velocity components in x, y and z directions  Mass flow into left side & mass flow out of right side  Net mass flow in x direction = sum of these 2 terms

4 AME Fall Lecture 7 - Conservation equations Conservation of mass  Similarly for y and z directions  Rate of mass accumulation within control volume  Sum of all mass flows = rate of change of mass within control volume

5 AME Fall Lecture 7 - Conservation equations Conservation of energy – control volume  1st Law of Thermodynamics for a control volume, a fixed volume in space that may have mass flowing in or out (opposite of control mass, which has fixed mass but possibly changing volume):  E = energy within control volume = U + KE + PE as before  = rates of heat & work transfer in or out (Watts)  Subscript “in” refers to conditions at inlet(s) of mass, “out” to outlet(s) of mass  = mass flow rate in or out of the control volume  h  u + Pv = enthalpy  Note h, u & v are lower case, i.e. per unit mass; h = H/M, u = U/M, V = v/M, etc.; upper case means total for all the mass (not per unit mass)  v = velocity, thus v 2 /2 is the KE term  g = acceleration of gravity, z = elevation at inlet or outlet, thus gz is the PE term

6 AME Fall Lecture 7 - Conservation equations Conservation of energy  Same cubic control volume with sides dx, dy, dz  Several forms of energy flow  Convection  Conduction  Sources and sinks within control volume, e.g. via chemical reaction & radiative transfer = q’’’ (units power per unit volume)  Neglect potential (gz) and kinetic energy (u 2 /2) for now  Energy flow in from left side of CV  Energy flow out from right side of CV  Can neglect higher order (dx) 2 term

7 AME Fall Lecture 7 - Conservation equations Conservation of energy  Net energy flux (E x ) in x direction = E left – E right  Similarly for y and z directions (only y shown for brevity)  Combining E x + E y  dE CV /dt term

8 AME Fall Lecture 7 - Conservation equations Conservation of energy  dE CV /dt = E x + E y + heat sources/sinks within CV  First term = 0 (mass conservation!) thus (finally!)  Combined effects of unsteadiness, convection, conduction and enthalpy sources  Special case: 1D, steady (∂/∂t = 0), constant C P (thus ∂h/∂T = C P ∂T/∂t) & constant k:

9 AME Fall Lecture 7 - Conservation equations Conservation of species  Similar to energy conservation but  Key property is mass fraction of species i (Y i ), not T  Mass diffusion  D instead of conduction – units of D are m 2 /s  Mass source/sink due to chemical reaction = M i  i (units kg/m 3 s) which leads to which leads to  Special case: 1D, steady (∂/∂t = 0), constant  D  Note if  D = constant and  D = k/C P and there is only a single reactant with heating value Q R, then q’’’ = -Q R M i  i and the equations for T and Y i are exactly the same!  k/  C P D is dimensionless, called the Lewis number (Le) – generally for gases D ≈ k/  C P ≈, where k/  C P =  = thermal diffusivity, = kinematic viscosity (“viscous diffusivity”)

10 AME Fall Lecture 7 - Conservation equations Conservation equations  Combine energy and species equations  is constant, i.e. doesn’t vary with reaction but  If Le is not exactly 1, small deviations in Le (thus T) will have large impact on  due to high activation energy  Energy equation may have heat loss in q’’’ term, not present in species conservation equation

11 AME Fall Lecture 7 - Conservation equations Conservation equations - comments  Outside of a thin reaction zone at x = 0  Temperature profile is exponential in this convection- diffusion zone (x ≥ 0); constant downstream (x ≤ 0)  u = -S L (S L > 0) at x = +∞ (flow in from right to left); in premixed flames, S L is called the burning velocity   has units of length: flame thickness in premixed flames  Within reaction zone – temperature does not increase despite heat release – temperature acts to change slope of temperature profile, not temperature itself

12 AME Fall Lecture 7 - Conservation equations Schematic of deflagration (from Lecture 1)   Temperature increases in convection-diffusion zone or preheat zone ahead of reaction zone, even though no heat release occurs there, due to balance between convection & diffusion   Temperature constant downstream (if adiabatic)   Reactant concentration decreases in convection-diffusion zone, even though no chemical reaction occurs there, for the same reason

13 AME Fall Lecture 7 - Conservation equations Conservation equations - comments  In limit of infinitely thin reaction zone, T does not change but dT/dx does; integrating across reaction zone  Note also that from temperature profile:  Thus, change in slope of temperature profile is a measure of the total amount of reaction – but only when the reaction zone is thin enough that convection term can be neglected compared to diffusion term

14 AME Fall Lecture 7 - Conservation equations Conservation of momentum  Apply conservation of momentum to our control volume results in Navier-Stokes equations: or written out as individual components  This is just Newton’s 2 nd Law, rate of change of momentum = d(mu)/dt =  (Forces)  Left side is just d(mu)/dt = m(du/dt) + u(dm/dt)  Right side is just  (Forces): pressure, gravity, viscosity