Holly Holevinski Cement + water = paste Aggregates: Coarse (>1/4”) Fine (<1/4”) Reinforcement (rebar) Fiberglass, plastic, steel Add mixtures: reduce weight.

Slides:



Advertisements
Similar presentations
By: Rick Roth. “High Early” Concrete is concrete that reaches its strength earlier then 28days! Any PSI concrete can be made to be High Early.
Advertisements

Portland Cement and Concrete
Reinforced Concrete Design
Concrete Man made stone. constituents u mixture of aggregate and paste u paste30 to 40% u portland cement7% to 15% by Vol. u water 14% to 21% by Vol.
Lecture 2 Design of Concrete Mixes and Properties of Fresh Concrete Dr Magnus Currie ENG-1010: Reinforced Concrete Design.
Curing and Protection of Concrete
FORMULATION OF MIX DESIGN TO INCORPORATE HYDROCARBON AFFECTED SOIL IN ASPHALT STABILIZED BASE Prepared by: Michael Ruckgaber Summer 2000 REU.
PC Cement Hydration PCC consists of binder and aggregates. Aggregates are typically used in two factions: fines and coarse. The binder phase normally.
POWER OF ADMIXTURES
L&M Construction Chemicals Concrete Basics
Chapter 7 Portland Cement Concrete
CONCRETE INGREDIENTS OF CONCRETE
Properties of Fresh Concrete
Jamar Adams Nina Brabham Anas Ghandorah Dan Holombo.
CONCRETE ACS-206 WEEK 5 UNIT 16 CE-ME-MECE-MSE. Concrete Mix Design Cement: It is the key material in construction. It is a fine, soft, powdery-type substance.
AGGREGATES There are two types of aggregates Coarse Aggregates
Masonry. Terms –F > 15-5 –Go thru all figures –Joints between brick = ¼ inch.
Concrete Condensed1 Cement Production, Composition & Types.
Cement Replacement Materials. Cement replacement materials or mineral admixtures are materials used to contribute to the properties of hardened concrete.
Break Down of Concrete Components. Mineral Admixtures: Pozzolans & Cementitious Fly Ash Slag Cement Silica Fume – Benefits Higher strengths at later age.
Chapter 3. Obtaining Silica-Fume Concrete  Specifying Silica Fume and SFC  Proportioning SFC  Producing SFC.
Egg Protection Device (EPD) - Structural Competition
Dr. Sophia Hassiotis.  Laboratory set up  Personal Protective equipment  Directions for mixing  Slump test  Cylinder casting  Cleaning up your station.
ADMIXTURES to CONCRETE In modern days Concrete without an Admixture Is an exception.
Joshua Murphy Sales Engineer Master Builders Technologies
Proportioning of Concrete Mixtures
Mix Design Review.
Ag.Mechanics Pd. 2,4,5,6.  Name what the two aggregates are in the cement mixture.  What 3 things make up the cement mixture.
Sub-Systems Design Review P14416 Concrete Arborloo Base October 29, 2013.
Unit 6 Concrete Construction
P14416: Concrete Arborloo Base System Design Review October 1, 2013.
Concrete Materials & Methods ARCH 330 Fall Concrete and Cement Concrete is a rocklike material produced by mixing coarse and fine aggregates, Portland.
“Properties of Concrete” Introduction
Concrete Unit 24 Carpentry and Building Construction.
The Cathedral of Our Lady of the Angels. Los Angeles, California Rafael Moneo.
Silver Oak College Of Engineering & Technology.
Sub-Systems Design Review P14416 Concrete Arborloo Base October 29, 2013.
ACI Concrete Mix Design
Concrete Slab Quality Requirements. Who Controls Concrete Quality Polishing contractors have to perform work on a concrete floor slab in which they had.
Design of Concrete Structure I Dr. Ali Tayeh First Semester 2009 Dr. Ali Tayeh First Semester 2009.
Done by: free Syria group Mohamed masry Mohamed abdulhamed Maayof kayed Hozayfa mohamed.
Mineral-based secondary binders, utilization, and considerations in mix design Exercise 5.
Mix design of self consolidating concretes Exercise 8.
Hot-Weather Concreting. Detrimental Hot Weather Conditions  High ambient temperature  High concrete temperature  Low relative humidity  High wind.
Mix design of high strength concrete, special cases in mix design Exercise 7.
Eng. Malek Abuwarda Lecture 12 P1P1 Construction Methods Lecture 12 Production of Aggregate and Concrete.
Drying of concrete Exercise 10. Evaporation of water from K30 concrete Evaporated water kg/m 3.
Introduction  Civil Engineering Materials -Concrete, Steel, Pavement  Construction Materials Timber, Glass, Aluminum, Paint, Plastic, Masonry, Ceramic.
PREPARED BY: MARCIA C. BELCHER CONSTRUCTION ENGINEERING TECHNOLOGY Concrete: Fundamentals.
University of Sydney – Structures CONCRETE Peter Smith 1998 Concrete Making and Testing l Unique material çMade specially for each job çHandling on job.
1.Initial setting time of cement:  40 to 60min  30 to 60min  15 to 60min  35 to 60min.
Supplementary Cementitious Materials Design and Control of Concrete Mixtures – Chapter 4.
Necessary Information Required compressive strength at 28days: 30 Mpa Type of structure: mass concrete, beam, column. Maximum size of aggregate: 20 mm.
ALL THINGS CONCRETE. WHAT IS CONCRETE Is a mixture or cement (usually Portland cement), aggregate (gravel, and sand), water and chemicals added to the.
Polymer Modified Steel Fiber Reinforced Concrete
CVL 2407 Faculty of Applied Engineering and Urban Planning Civil Engineering Department 2 nd Semester 2013/2014 Dr. Eng. Mustafa Maher Al-tayeb.
BCN 5905 –STRUCTURES I Dr. Larry Muszynski RNK 327.
Cement and Concrete Concrete is an artificial conglomerate,with the following constituents: Cement Aggregate Water Cement replacements and admixtures.
Physical Properties of Aggregates
Concrete Man made stone.
Chapter 16: Concrete Engineering Technical English
Ultra High Performance Concrete (UHPC)
A STUDY ON HIGH PERFORMANCE CONCRETE WITH FLY ASH AND SILICA POWDER
Objectives Identify various types of building materials and describe their uses. n. Describe the composition of concrete and explain how hydration occurs.
ADMIXTURES???? Materials added to the concrete besides cement, water and aggregate. To improve the properties of the concrete required. Admixtures can.
Written Summary Please write a ½ page summary on your experiences from laying out a foundation wall on Monday.
2018 Revisions to NYCDOB Code
Center for Transportation Research The University of Texas at Austin
Maximum Size of Aggregate
Table 1. The most important aspect applied in MIVES
Presentation transcript:

Holly Holevinski Cement + water = paste Aggregates: Coarse (>1/4”) Fine (<1/4”) Reinforcement (rebar) Fiberglass, plastic, steel Add mixtures: reduce weight Air-entrainment Foaming materials Accelerators and retarders

 5 types of cement  Types I – V  Type I- General use  Type IV- “High Early”  Reaches its maximum strength within 24 hours  Window when paste is moldable ~ minutes  3000 psi goal for slab

 Concrete Tips:  Concrete cannot go below 80% RH during cure process  Rebar should not touch any open areas  Use plastic to keep moisture in, spray concrete regularly if possible  Mix parts of Portland cement with cheap substitutes (fly ash, silica fume, rubber pellets)  Concrete must be at least 30% Portland cement

Feedback: Privacy Policy Feedback
Do Not Sell My Personal Information
About project: SlidePlayer Terms of Service

© 2024 SlidePlayer.com Inc. All rights reserved.