0Quit Connecting to a Projector via Video Cable (1/2) 1.Turn on Epson projector remote control by sliding slider switch to right of red Power button toward front of remote 2.Point remote at projector & push the red Power button –The projector will beep –The status light on the projector will begin to flash green –The projector will display auto-setup on the screen 3.Wait for the projector to finish focusing before connecting the cable. (See next slide.) 4.Push the Comp1 source button on projector remote 5.Locate the cable with the Video plug & Audio plug:
1Quit 6.Connect the Video connector to the monitor port Use the Mini HDMI to VGA adapter if needed 7.Connect the Audio plug to the headphone or speaker jack Use the audio plug on the VGA adapter if using one 8.As needed, hold Windows ( ) + P to cycle through 4 output options: 9.As needed, adjust the Tablet PC & ceiling speaker volume. Connecting to a Projector via Video Cable (2/2) Ceiling speaker remote control
2Quit The End! Document Control VersionDate CompleteAuthorDescription Cooper, BradInitial Draft Gillette, KeithEdited to 2 pages Cooper, BradCorrected layout and animatoins Gillette, KeithUpdated for HP EliteBook 2740p Panagos, MichaelUpdated for YOGAs Still have a question? Contact the IT Department for further assistance: Call: x222