Spring 2007EE130 Lecture 27, Slide 1 Lecture #27 OUTLINE BJT small signal model BJT cutoff frequency BJT transient (switching) response Reading: Finish.

Slides:

Advertisements

Similar presentations

Transistors and transistor circuits

Advertisements

Bipolar Junction Transistor Circuit Analysis

Bipolar Junction Transistors ECE Three Terminal Device Terminals ▫Emitter  The dominant carriers are emitted from the region (equivalent to the.

BIJUNCTION TRANSISTOR

ECE 442 Power Electronics1 Bipolar Junction Transistors (BJT) NPNPNP.

Announcements Assignment 2 due now Assignment 3 posted, due Thursday Oct 6 th First mid-term Thursday October 27 th.

Spring 2007EE130 Lecture 20, Slide 1 Lecture #20 OUTLINE pn Junctions (cont’d) – small-signal model – transient response turn-off Reading: Chapters 7,

Spring 2007EE130 Lecture 24, Slide 1 Lecture #24 HW#8 ANNOUNCEMENTS Start Problem 4 early! Note that Problem 3f has been revised OUTLINE The Bipolar Junction.

Spring 2007EE130 Lecture 26, Slide 1 Lecture #26 OUTLINE Modern BJT Structures –Poly-Si emitter –Heterojunction bipolar transistor (HBT) Charge control.

Spring 2007EE130 Lecture 23, Slide 1 Lecture #23 QUIZ #3 Results (undergraduate scores only, N = 39) Mean = 22.1; Median = 22; Std. Dev. = High =

Bipolar Junction Transistors (BJT) NPNPNP. BJT Cross-Sections NPN PNP Emitter Collector.

EE105 Fall 2007Lecture 6, Slide 1Prof. Liu, UC Berkeley Lecture 6 OUTLINE BJT (cont’d) – PNP transistor (structure, operation, models) BJT Amplifiers –

Spring 2007EE130 Lecture 22, Slide 1 Lecture #22 OUTLINE The Bipolar Junction Transistor – Introduction Reading: Chapter 10.

EE105 Fall 2007Lecture 5, Slide 1Prof. Liu, UC Berkeley Lecture 5 OUTLINE BJT (cont’d) – Transconductance – Small-signal model – The Early effect – BJT.

EE105 Fall 2011Lecture 6, Slide 1Prof. Salahuddin, UC Berkeley Lecture 6 OUTLINE PN Junction Diodes – Reverse Breakdown – Large and Small signal models.

Current Components inside Bipolar Junction Transistor (BJT) NPN BJT.

Slide 8-1 Chapter 8 Bipolar Junction Transistors Since 1970, the high density and low-power advantage of the MOS technology steadily eroded the BJT’s early.

EE105 Fall 2007Lecture 4, Slide 1Prof. Liu, UC Berkeley Lecture 4 OUTLINE Bipolar Junction Transistor (BJT) – General considerations – Structure – Operation.

Spring 2007EE130 Lecture 19, Slide 1 Lecture #19 OUTLINE pn junctions (cont’d) – Charge control model Reading: Finish Chapter 6.3.

Lecture #25 OUTLINE BJT: Deviations from the Ideal

Lecture #12 OUTLINE Metal-semiconductor contacts (cont.)

Department of EECS University of California, Berkeley EECS 105 Fall 2003, Lecture 14 Lecture 14: Bipolar Junction Transistors Prof. Niknejad.

Chapter 13 Small-Signal Modeling and Linear Amplification

Dr. Nasim Zafar Electronics 1 EEE 231 – BS Electrical Engineering Fall Semester – 2012 COMSATS Institute of Information Technology Virtual campus Islamabad.

ECE 342 – Jose Schutt-Aine 1 ECE 342 Solid-State Devices & Circuits 6. Bipolar Transistors Jose E. Schutt-Aine Electrical & Computer Engineering University.

BJT structure note: this is a current of electrons (npn case) and so the conventional current flows from collector to emitter. heavily doped ~ 10^15 provides.

Spencer/Ghausi, Introduction to Electronic Circuit Design, 1e, ©2003, Pearson Education, Inc. Chapter 7, slide 1 Introduction to Electronic Circuit Design.

ECA1212 Introduction to Electrical & Electronics Engineering Chapter 5: Bipolar Junction Transistor by Muhazam Mustapha, October 2011.

© 2000 Prentice Hall Inc. Figure 4.1 The npn BJT..

ENE 311 Lecture 10.

EE130/230M Review Session 1.Small Signal Models for MOSFET/BJT 2.MOS Electrostatics.

Chapter (3) Transistors and Integrated Circuits B I P O L A R J U N C T I O N T R A N S I S T O R BJT in contrast to the "unipolar" FET Both minority and.

Lecture 13 OUTLINE pn Junction Diodes (cont’d) Charge control model

EE130/230A Discussion 7 Peng Zheng.

Recall Lecture 8 Clipper – Step 1: Find the clip value by doing KVL at the output branch – Step 2: Set the conditions to know whether diode is on or off.

EXAMPLE 10.1 OBJECTIVE Solution

EE130/230A Discussion 15 Peng Zheng 1. Early Voltage, V A Output resistance: A large V A (i.e. a large r o ) is desirable IB3IB3 ICIC V EC 0 IB2IB2 IB1IB1.

Lecture 26 OUTLINE The BJT (cont’d) Breakdown mechanisms Non-ideal effects Gummel plot & Gummel numbers Modern BJT structures Base transit time Reading:

BJT (cont’d). OUTLINE – Transconductance – Small-signal model – The Early effect – BJT operation in saturation mode Reading: Chapter

Bipolar Junction Transistors (BJTs)

1 Tai-Cheng Lee Spring 2006 Bipolar Junction Transistors (BJT) Tai-Cheng Lee Electrical Engineering/GIEE, NTU.

EE130/230A Discussion 14 Peng Zheng.

Bipolar Transistors Two PN junctions joined together Two types available – NPN and PNP The regions (from top to bottom) are called the collector (C), the.

President UniversityErwin SitompulSDP 8/1 Lecture 8 Semiconductor Device Physics Dr.-Ing. Erwin Sitompul President University

Bipolar Junction Transistor (BJT). OUTLINE – General considerations – Structure – Operation in active mode – Large-signal model and I-V characteristics.

Chapter3:Bipolar Junction Transistors (BJTs)

Microelectronic Circuit Design, 3E McGraw-Hill Chapter 13 Small-Signal Modeling and Linear Amplification Microelectronic Circuit Design Richard C. Jaeger.

Lecture 24 OUTLINE The Bipolar Junction Transistor Introduction BJT Fundamentals Reading: Pierret 10; Hu 8.1.

TRANSISTOR - Introduction BIPOLAR JUNCTION TRANSISTOR (BJT)

Semiconductor Device Physics

Lecture 27 OUTLINE The BJT (cont’d) Small-signal model Cutoff frequency Transient (switching) response Reading: Pierret 12; Hu

LARGE-SIGNAL BEHAVIOR OF BJTS Large-signal models in the forward-active region Effects of collector voltage in the forward-active region Ohmic and inverse.

1 Concepts of electrons and holes in semiconductors.

COURSE NAME: SEMICONDUCTORS Course Code: PHYS 473 Week No. 5.

BJT transistors Summary of DC problem 2 Bias transistors so that they operate in the linear region B-E junction forward biased, C-E junction reversed.

Chapter 4 Bipolar junction transistor Ir. Dr. Rosemizi Abd Rahim 1 Ref: Electronic Devices and Circuit Theory, 10/e, Robert L. Boylestad and Louis Nashelsky.

Reading: Finish Chapter 12

Bipolar Junction Transistor (BJT) Chapter and 25 March 2016

BJT Static Characteristics

Chapter 8 Bipolar Junction Transistors

Lecture 27 OUTLINE The BJT (cont’d) Small-signal model

Lecture 24 OUTLINE The Bipolar Junction Transistor Introduction

Lecture 28 OUTLINE The BJT (cont’d) Small-signal model

Lecture 25 OUTLINE The BJT (cont’d) Ideal transistor analysis

Lecture 25 OUTLINE The BJT (cont’d) Ideal transistor analysis

Lecture 4 OUTLINE Bipolar Junction Transistor (BJT)

BJT Static Characteristics

Bipolar Junction Transistor (BJT) Chapter and 17 March 2017

Review & Problems.

Bipolar Junction Transistor (BJT) Chapter and 27 March 2019

Presentation transcript:

Spring 2007EE130 Lecture 27, Slide 1 Lecture #27 OUTLINE BJT small signal model BJT cutoff frequency BJT transient (switching) response Reading: Finish Chapter 12

Spring 2007EE130 Lecture 27, Slide 2 Transconductance: Small-Signal Model Common-emitter configuration, forward-active mode: “hybrid-pi” BJT small signal model:

Spring 2007EE130 Lecture 27, Slide 3 Small-Signal Model (cont.) where Q F is the magnitude of minority-carrier charge stored in the base and emitter regions forward transit time

Spring 2007EE130 Lecture 27, Slide 4 A BJT is biased at I C = 1 mA and V CE = 3 V.  dc =90,  F =5 ps, and T = 300 K. Find (a) g m, (b) r , (c) C . Solution: (a) (b) r  =  dc / g m = 90/0.039 = 2.3 k  c) Example: Small-Signal Model Parameters

Spring 2007EE130 Lecture 27, Slide 5 The cutoff frequency is defined to be the frequency (f =  /2  ) at which the short-circuit a.c. current gain equals 1: Cutoff Frequency, f T

Spring 2007EE130 Lecture 27, Slide 6 f T is commonly used as a metric for the speed of a BJT. SiGe HBT by IBM For the full BJT equivalent circuit: To maximize f T : –increase I C –minimize C J,BE, C J,BC –minimize r e, r c –minimize  F

Spring 2007EE130 Lecture 27, Slide 7 At very high current densities (>0.5mA/  m 2 ), base widening occurs, so Q B increases.  F increases, f T decreases. Top to bottom : V CE = 0.5V, 0.8V, 1.5V, 3V. Base Widening at High I C : the Kirk Effect Consider an npn BJT: At high current levels, the density of electrons (n  I C /qAv sat ) in the collector depletion region is significant, resulting in widening of the quasi-neutral base region. As W increases, the depletion width in the collector also increases, since the charge density decreases: At very high current densities, the excess hole concentration in the collector is so high that it effectively extends the p-type base.

Spring 2007EE130 Lecture 27, Slide 8 Summary: BJT Small Signal Model Hybrid-pi model for the common-emitter configuration, forward-active mode:

Spring 2007EE130 Lecture 27, Slide 9 BJT Switching - Qualitative

Spring 2007EE130 Lecture 27, Slide 10 Turn-on transient We know: The general solution is: Initial condition: Q B (0)=0. since transistor is in cutoff where I BB =V S /R S

Spring 2007EE130 Lecture 27, Slide 11 Turn-off transient We know: The general solution is: Initial condition: Q B (0)=I BB  B

Spring 2007EE130 Lecture 27, Slide 12 Reducing  B for Faster Turn-Off The speed at which a BJT is turned off is dependent on the amount of excess minority-carrier charge stored in the base, and also the recombination lifetime  B –By reducing  B, the carrier removal rate is increased Example: Add recombination centers (Au atoms) in the base

Spring 2007EE130 Lecture 27, Slide 13 Schottky-Clamped BJT When the BJT enters the saturation mode, the Schottky diode begins to conduct and “clamps” the C-B junction voltage at a relatively low positive value.  reduced stored charge in quasi-neutral base