1 Channelization and Turn Bays. 2 Island Channelization flush, paved, and delineated with markings – or unpaved and delineated with pavement edge and.

Slides:



Advertisements
Similar presentations
Revisions to Chapter 2B – Regulatory Signs, Barricades, and Gates.
Advertisements

Chapter 5 Signs, Signals, and Roadway Markings
Negotiating Intersections
Right and Left Turns.
Traffic Signals, Signs and Pavement Markings  are used for traffic control to provide a smooth, orderly flow of traffic Remember: Obey all signs and signals.
Signals o Steady lights o Flashing lights o Signal/Sign combinations T – 1.22 Signals by traffic lights indicate the following: Steady red – moving traffic.
Road Signs and Markings Recognition Quiz Each sign will appear for 0.3 seconds…
“ Pavement markings can enhance safety since centerlines have been shown to cut crash frequency by 29% compared to roads without them ” Wisconsin Transportation.
US Highway 17 (Center Street) Sidewalk Feasibility Study Town of Pierson, Florida.
INTRODUCTION This chapter presents guidance on the application of geometric design criteria to facilities functionally classified as collector roads and.
Lecture 1 Introduction to Transport B3 Lecturers: Prof. Margaret O’Mahony Dr. Bidisha Ghosh Dr. Brian Caulfield.
Chap 4 Cross Section Elements (pp.4-1 – 4-66 ) The following topics (pages) are covered in this lecture: Pavement (p.4-1 – 4-7) Pavement (p.4-1 – 4-7)
Florida Department of Transportation, November 2009
Chapter 4.
2009 MUTCD (Final Rule) Revisions Incorporated into the 2009 MUTCD Revisions to Chapter 2B – Regulatory Signs, Barricades, and Gates.
Freeway Signing Plan Design April 29, 2008
Chapter 5 Signs, Signals, and Markings
Lec 26, Ch.7, pp : Islands and turning roadways (Objectives) Know the functions of islands Know the functions of islands Be familiar with minimum.
Understanding the Purpose of Pavement Markings
HERO UNIT Training Module Work Zone Traffic Control And Incident Management Operations.
At-Grade Intersection
TYPES OF INTERSECTIONS OF ROAD AND DESIGN PARAMETERS OF INTERSECTION
INTRODUCTION TO TRANSPORT Lecture 4 Introduction to Transport Lecture 4: Signal Timing.
Lec 14, Ch. 15: Introduction to intersection control (Objectives) Understand why some sort of control is essential to allocate ROW at intersections Understand.
Lec 25, Ch.7, pp : Intersection types and design principles (Objectives) Become familiar with the typical intersection types (See figures 7-1 thorugh.
Lec 14, Ch.8, pp : Intersection control and warrants (objectives) Know the purpose of traffic control Know what MUTCD is and what’s in it Know what.
1 Channelization and Turn Bays CE 453 Lecture 31.
Access Management: Why And How? An Introduction To Access Management Problems, Principles and Treatments.
Module 5 Displaced Left Turn (DLT) Intersections
CHAPTER 3 SIGNS, SIGNALS AND PAVEMENT MARKINGS
Signals,Road Markings, Intersections, Sharing the Road
Chapter 5: Intersections & Turns
DRIVER SAFETY.
Signs, signals, and pavements markings
1 Section III Day 2 DMV Manual p. 5-6, Write a scenario about how the driver of the white truck managed to keep his truck on the edge of the.
PAVEMENT MARKINGS, TRAFFIC SIGNS, LIGHTS,
Rules and Regulations for Safe Driving
Chapter 4. Your number one priority as a driver is to drive your vehicle carefully and safely. Your speed and manner of driving must create a safe environment.
 Cross section elements consist of the following:  1.Traffic lanes (carriage ways);  2.Shoulders;  3.Medians;  4.Curbs;  5.Side slopes.
INTERSECTION SAFETY PERFORMANCE AND AUDIT Andy Loonan Basak Aldemir-Bektas Intersection: Welch Avenue & Lincoln Way.
Intersection Design Spring 2015.
Project Development – High Priority Segments -- ATP 2 10/29/2012 Road Surface? Paved Gravel Segment received Stars for Lane Departure Crash Density & Critical.
INTRODUCTION An intersection is the general area where two or more highways join or cross, including the roadway and roadside facilities for traffic movements.
1 At-Grade Intersection Design. 2 Objectives Define general intersection design objectives Describe factors that influence curb return design For a nice.
Signals,Road Markings, Intersections, Sharing the Road.
1 Urban Intersections Slides prepared by Dale S. Harrington, P.E.
Design of Parking Facilities Chapter 16 Dr. TALEB M. AL-ROUSAN.
1 Intersection Design. 2 Intersection Design – Operational Requirements Provide adequate sight distance – for approach and departure maneuvers Minimize.
Unit 4 Chapters 7, 9, 10 and 11.
Information Processing: Complex Risk Environments Topic 1 -- Characteristics of Expressways Topic 2 (through Lesson 1)-- Entering, Changing Lanes, and.
Fall  Many elderly live in poverty, ill health, and inadequate housing  Increasingly, many of those over age 65 will be very old—over age 80–85.
Intersection Design Chapter 7 Dr. TALEB AL-ROUSAN.
Intersections.
Expressway Driving Legacy High School Drivers Education.
Safety Audit Planned Project - Preliminary Design zGeneral Project Data yProject layout xRoad function Determine the road function. What kind of traffic.
Chapter 191 Chapter 19: Elements of Intersection Design and Layout Make an initial sizing of the intersection Make an initial sizing of the intersection.
At-Grade Intersection Design
Intersection Control Chapter 8 Dr. TALEB AL-ROUSAN.
Chapter 6: Intersections
1 Intersection Design CE 453 Lecture Intersections More complicated area for drivers Main function is to provide for change of direction Source.
Signal timing CTC-340. Key Elements Development of safe and effective phase plan and sequence Determination of vehicle signal needs –Timing of yellow.
1 Modern Roundabouts – The Safer Intersection Choice Mark Doctor, PE FHWA Resource Center Safety & Design Technical Service Team Proven Safety Measures.
 Every sign’s shape and color have special meaning  Regulatory Signs: Signs that set limits, or give commands.  Example: stop sign, Yield, One Way,
Lesson Plan For Day Two Power point presentation 30 min Video– AAA- signs, signals, etc. 20 min Quiz- Signs Etc 10 min Correct 10 min H/O- Signs 10 min.
9.6 Turning Roadways and Channelization, Types of Turning Roadways p.9-55 ~ 9-92 Lean how to determine minimum edge-of-traveled- way radii for the.
Intersections.
Intersection Design Spring 2017.
Signs Power Point Assignment
Drive Right Chapter 2 Unit 1
From Channelization, Islands and Turning Roadways (p ~ p
Presentation transcript:

1 Channelization and Turn Bays

2 Island Channelization flush, paved, and delineated with markings – or unpaved and delineated with pavement edge and markings raised … use lighting raised rural … also delineate and slope curbs Size: large enough to command attention Must delineate a path that is natural and convenient for the driver

3 Island Channelization Must have sufficient approach sight distance to islands Curb radii – appropriate for necessary island size (25 m or 75 feet at least) see exhibits 9-41 and 9-42 if used at series of rural intersections, keep geometry consistent see exhibit 9-35 for common use

4

5

6 Consider left turn lane if advancing volume/percent left combination exceeds these values. For left turn volume > 300 VPH, consider dual left turn lane.

7 Channelization – Functional Objectives Limit Conflict Points (i.e., prohibit certain movements, non-overlap of opposing LTs), esp. in vicinity of intersection functional area (see figures) Limit Conflict Area Complexity (i.e., eliminate legs, add turn lanes, islands) Limit Conflict Frequency (i.e., add turn lanes, use right angles) Limit Conflict Severity (i.e., small angles, adequate turn bay length/curb radii for speed differential issues)

8 Principles of Channelization 1. Undesirable/wrong-way movements should be discouraged 2. Vehicle paths clearly defined 3. Desirable/safe speeds encouraged 4. Separation of conflict points if possible 5. Cross at right angles, merge at flat angles 6. High priority traffic facilitated 7. Desired traffic control schemes facilitated 8. Remove slow, stopped, or decelerating vehicles from traffic stream 9. Provide safe refuge for peds and others

9 Intersection Islands Definition – “a defined area between traffic lanes for control of vehicle movements or pedestrian refuge” Types/functions: Directional – “to control and direct movement” and “to guide motorists into the proper channel for their intended route”

10 Divisional – “to divide opposing traffic flow”, and “to alert the driver to the crossroad ahead and regular traffic through the intersection” Refuge – “to aid and protect pedestrians and bicyclists crossing the roadway”

11 Intersection Turn Bays New Construction Warrants (functional approach): all unstopped approaches on primary, high speed rural highway intersections with other primary roadways, see fig Other approaches where through, left, and opposing volumes justify “Where space permits, left-turn lanes should be considered when left-turn volumes exceed 100 vph…” (Green Book)

12

13 Rehabilitation Warrants: Typically installed where there is a safety issues with vehicles turning left Guides for need – See figure 4-12 and Exhibit 9-75 Lane width: 12 ft. (new) and 11 ft. or greater for rehab, see figure 4-5

14 40mph

15 50mph

16 Length required

17 Design

18 Design

19 Design

20 1. Left Turn Bay Length: a) PRT & 10 MPH reduction occurs upstream of bay (more in congested, urban conditions) see fig b) accommodate deceleration from D.S. – 10 mph to stop, see table 5-8 c) Unsignalized, accommodate 2 minutes of demand, at least 2 cars (or 1 car and 1 truck if truck% > 10), see figure 5-15 or 4-18 d) Signalized, accommodate twice the expected average storage needed – depends on cycle and phasing, see figure 5-14 e) Right turn bay length depends on corner radius, see fig. 4-24

21

22

23

24

25

26

27 Turn Bay Components (see fig 4-14) 1. Approach taper 2. Bay Taper 3. Full lane Length 4. Departure Taper 5. Shadow width

28 Some Turn Lane Details 1. Transitions are often symmetrical reverse curves or straight line (see Exhibit 9-95) – curves at each end are desirable - Lengths and radii given in the same figure 2. For tapers: see figure Green Book: 8:1 to 15:1 tapers for high speed highways … urban use 100’ for single and 150’ for dual left turn lane

29

30

31 Striping through Intersection: Difficult to See

32 Curb Radius Parking Lot

33 Island for No Left Turn

34 Right Turn Bay Curve

35 Left Turn Bay Taper

36 Left Turn Separated

37 Left Turn Bay (No Transition)

38 Left Turn Bay Pavement Markings

39 Curb Radius Curb Cut

40 Turn Lane Pedestrian Refuge

41 Curb Cut

42 RR Crossing

43 RR Crossing Raised Median

44 Right Turn Island

45 Island Pedestrian Refuge

46 Median End Treatment

47 Left Turn Bay Curve, Right Turn Bay Taper

48 Left Turn Bay Circular Transition

49 Median to Discourage U-Turns

50 3 Leg Intersection

51 Median End (Keep Right)

52 Median End Delineation

53 Median in front of Lowes

54 Intersection Approach Lincoln Way at Elwood

55 Intersection Approach 4 th at Elwood Drive

56 Median: Elwood Dr. at Airport Rd.

57 Points of Conflict Traffic conflicts occur where the path of traffic movement crosses.

58 T-Intersection or Driveway Side Street Two Lane Undivided Street

59 T-Intersection or Driveway Side Street Two Lane Undivided Street

60 4-Way Intersection or Driveway 2 lane streets Note: Add 4 conflicts to each for four lane roadways 40 conflicts with Four Lane on major street

61 Limit Conflicts - Objectives Limit Conflict points Limit Conflict Area Complexity Limit Conflict Frequency Limit Conflict Severity

62

63

64

65 T-Intersection or Driveway After #1 Two lane roadway with raised median closed, no left-turn

66 4-Way Intersection or Driveway After #1 Added median close eliminates left-turn conflicts

67 T-Intersection or Driveway After #2 Two lane roadway with raised median (left turn egress only from intersection or driveway)

68 4-Way Intersection or Driveway After #2 Two lane roadway with raised median (left turn egress only from intersection or driveway)

69 T-Intersection or Driveway After #3 Two lane roadway with raised median (left turn ingress only into driveway)

70 4-Way Intersection or Driveway After #3 Two lane roadway with raised median (left turn ingress only into intersection or driveway)

71 Two Way Left Turn Lanes at Intersection or Driveway: Two way left turn lanes (TWLTL) (3 lane roadway) Reduces rear-end accidents and allows merging traffic to store in TWLTL

72 Pedestrian Refuge Island at Intersection for TWLTL

73 Urban Intersection

74 Urban Channelized Intersection-

75 Raised Median: Clive

76