Unit Standard credits 7 weeks

Slides:

Advertisements

Similar presentations

Notebook Check Tsjellum van der Stok. State Diagram This page shows the proposed State diagram that will be implemented. Hysteresis is shown.

Advertisements

ELECTRONICS Frost Alarm Frost Alarm. ELECTRONICS When the thermistor temp is high the resistance is low and the transistor is off.

TRANSISTORS Past Paper Questions and Answers EP01– Q11(b) The circuit below is a monostable timing circuit, When activated component C turns on.

Use Ohm’s Law to solve the following equations.

Current, Resistance, and Simple Circuits.  A capacitor is a device used to store electrical energy.  There are two different ways to arrange circuit.

gradually rises from 0 to 9V immediately drops from 9V to 0V

Electricity Define Electricity: Electrons: Short Circuit: Current: Battery: Voltage:

Rd 3 - Electronics 1.Ohm’s Law 2.Potential Divider 3.Resistor in Series and Parallel - Application of Ohm’s Law 4. Operational Amplifier (Comparator and.

Twenty Questions Electronics. Twenty Questions

Beath High School - Int 1 Physics1 Intermediate 1 Physics Electronics Input, Process and Output Digital Logic Gates.

RESISTORS Always remember…… V = IR (V= voltage in volts; I = current in amps; R = resistance in ohms)

The energy change in a thermocouple is : 1.E E to E H 2.E S to E E 3.E L to E E 4.E H to E E :20.

The 3 parts of an electronic system are :

05/11/2015 Activity 29 Transistors Aim To investigate the switching action of an npn transistor. Method – Follow the instructions on Activity 29. Result.

Resistive Transducers Sensors Used in Electronics.

STARTER They all detect something and then respond But how?

Unit 6 in four lessons Resistors.

Electronic Schematics How we can draw electronic circuits.

Beath High School - Int 1 Physics1 Intermediate 1 Physics Electronics Glossary AND gate to device digital signals to inverter LDR to logic circuit logic.

© Oxford University Press 2011 IP Images Images.

Twenty Questions Electronics. Twenty Questions

18240 Element two - Components INPUTS OUTPUTS PURPOSE TYPICAL USE.

Objective: 1.You will build a simple circuit - two transistor audio oscillator that will generate an audio tone in a speaker.

Resistance – Learning Outcomes  Define resistance and give its unit.  Solve problems about resistance.  State Ohm’s Law.  HL: Derive the formulas for.

ELECTRONICS – Input Transducers Engineering Science – National 5.

Bell Ringer From yesterday’s lab… …Do you believe holiday decoration lights are wired in series or in parallel?

6.2 ELECTRONICS. CAPACITOR An electrical device used to store electrical charge.

Analogue Electronics Higher Physics Unit 2 Electricity And Electronics Monitoring & Control Circuits.

Set up your circuit board 2 batteries, bulb, switch, and variable resister.

Electricity Definitions

Starter: use Pg to complete the table

Edexcel IGCSE Physics pages 74 to 81

Connect 4 Change the terms in the following template to customize Connect 4 for any topic. You will need to copy one copy of one of the two templates.

Unit 1 Electricity, energy and waves

Raspberry pi controlled greenhouse

P2 Topic 2: Controlling and using electric currents

Demonstrate and apply knowledge of basic semiconductor devices

Series Circuit.

Electronic Components

Light Dependent Resistor

Potential Divider Aims What is a potential divider

LDRs and Thermistors.

Task 4 – Report (individual work)

AQA GCSE 6 Systems approach to designing Design and Technology 8552

Twenty Questions Electronics.

Electronics – Learning Outcomes

Basic Electronics Year 10.

Transistor & Voltage Divider

RESISTORS A resistor is used to reduce the flow of electricity in an electric circuit. Resistorscome in fixed or variable types.

Be able to describe how the resistance of LDRs and Thermistors varies.

Components and Schematics

Match the circuit symbols How many of these can you name?

P6 – Electricity for Gadgets

The resistance of a thermistor changes from 30k to 12k when the temperature changes from 20C to 70 C Calculate the sensitivity if resistance is taken.

How a 555 Timer Works Objectives:

Resistance Year 9 Science.

Ohms Law required Practical

Potential Dividers Electric Circuits ☞.

Resistance WALT: Describe the relationship between resistance and current and explain how different components can change resistance Starter: Draw the.

Designing Electric Circuits

P2 Topic 2: Controlling and using electric currents

P2 Topic 2: Controlling and using electric currents

Resistance components & Power

Draw the symbols for the below components: Cell: Battery:

P2 - Physics Circuits.

Describe the action of thermistors and light- dependent resistors and show understanding of their use as input transducers Thermistor A transducer is an.

Passive Transducers Elliott.

Presentation transcript:

Unit Standard 26119 4 credits 7 weeks Construct and report on the performance of a simple electronic programmable circuit 4 credits 7 weeks (wk 3 ~ wk 9)

Work in pairs Assessed individually All students work on the same project – greenhouse control system Part One – basic knowledge & skill testing Part Two – project work LOG BOOK – sketches, diagrams, schematics, photos, etc.

Greenhouse Controller The system is required to monitor two variables to ensure that the tomato crop thrives in the best possible conditions of temperature, light level or humidity. It will respond to critical values and initiate a reaction using a suitable transducer (eg LED, motor, sound, etc.)

IN5404 .01uF 330 BC547 BD139

The LED turns on when the resistance of the LDR is below 7k ohms. The fan (motor) turns on when the resistance of the thermistor is below 4800 ohms. Calculate the size of resistor #2 and #7 that will allow the LED and the fan to be turned on at the desired switch point. Resistor #4 = 330 ohms Capacitor = 0.01 uF