Presentation is loading. Please wait.

Presentation is loading. Please wait.

ELECTRONICS Frost Alarm Frost Alarm. ELECTRONICS When the thermistor temp is high the resistance is low and the transistor is off.

Published by Modified over 8 years ago

Similar presentations

Presentation on theme: "ELECTRONICS Frost Alarm Frost Alarm. ELECTRONICS When the thermistor temp is high the resistance is low and the transistor is off."— Presentation transcript:

1 ELECTRONICS Frost Alarm Frost Alarm

2 ELECTRONICS When the thermistor temp is high the resistance is low and the transistor is off.

3 ELECTRONICS Frost Alarm Frost Alarm

4 ELECTRONICS When the thermistor temp is low, the resistance is high and the transistor switches on.

5 ELECTRONICS Fire Alarm Fire Alarm

6 ELECTRONICS When the temp is hot the thermistor resistance is low so it takes little voltage and so the resistor takes most of the voltage and so the transistor switches on.

7 ELECTRONICS Fire Alarm Fire Alarm

8 ELECTRONICS When the temp is cold the thermistor takes most voltage and so the resistor takes little and the transistor is off.

9 ELECTRONICS Burglar Alarm Burglar Alarm

10 ELECTRONICS When the L.D.R. is in the light,the resistance is low so the voltage is low and the transistor is off

11 ELECTRONICS Burglar Alarm Burglar Alarm

12 ELECTRONICS When the L.D.R. is in the dark its resistance is high and the transistor switches on.

13 ELECTRONICS Time Delay Circuit Time Delay Circuit

14 ELECTRONICS When the capacitor charges up to a certain voltage after a certain time, the transistor switches on.

15 ELECTRONICS

16 ELECTRONICS There are 3 process devices, The NOT gate The AND gate The OR gate

17

18

19

20

21

22

23

Download ppt "ELECTRONICS Frost Alarm Frost Alarm. ELECTRONICS When the thermistor temp is high the resistance is low and the transistor is off."

Similar presentations

David Smith1 S.G. Electronics Revision Lesson. David Smith2 Introduction Electronic systems have 3 parts Input Process Output There are 2 types of systems:

David Smith1 S.G. Electronics Revision Lesson. David Smith2 Introduction Electronic systems have 3 parts Input Process Output There are 2 types of systems:
AP Electricity Quiz Review

AP Electricity Quiz Review
Basic Circuits TEST YOUR BRAIN!.

Basic Circuits TEST YOUR BRAIN!.
Current-Voltage Characteristics of a bulb In this experiment you are going to investigate how the current through a bulb changes according to the.

Current-Voltage Characteristics of a bulb In this experiment you are going to investigate how the current through a bulb changes according to the.
P2.3.1 – Static Electricity. Objectives, to understand that: –When certain electrical insulators are rubbed together they become electrically charged.

P2.3.1 – Static Electricity. Objectives, to understand that: –When certain electrical insulators are rubbed together they become electrically charged.
Chapter 4 AC to AC Converters

Chapter 4 AC to AC Converters
TRANSISTORS Past Paper Questions and Answers. 2013 2EP01– Q11(b) The circuit below is a monostable timing circuit, When activated component C turns on.

TRANSISTORS Past Paper Questions and Answers EP01– Q11(b) The circuit below is a monostable timing circuit, When activated component C turns on.
The All IC’s are usually set up in a DIL (Dual In Line) configuration, this is where there are two sets of parallel connections (the pins). As you can.

The All IC’s are usually set up in a DIL (Dual In Line) configuration, this is where there are two sets of parallel connections (the pins). As you can.
Input Devices Microphone Symbol: Energy Change:soundelectrical Solar Cell Symbol: Energy Change:lightelectrical.

Input Devices Microphone Symbol: Energy Change:soundelectrical Solar Cell Symbol: Energy Change:lightelectrical.
Electronics Digital Processes Transistor as a Switch 1)(G) State that a transistor can be used as a switch. 2)(G) State that a transistor may be conducting.

Electronics Digital Processes Transistor as a Switch 1)(G) State that a transistor can be used as a switch. 2)(G) State that a transistor may be conducting.
Physics and Electronics. Electronic systems Electronic systems are made up of 3 parts: 1)An INPUT SENSOR – these detect changes in the environment Examples:

Physics and Electronics. Electronic systems Electronic systems are made up of 3 parts: 1)An INPUT SENSOR – these detect changes in the environment Examples:
Electronic Component Functions What is this component doing my in electronic device?

Electronic Component Functions What is this component doing my in electronic device?
Operational Amplifiers

Operational Amplifiers
Module 2 Bipolar Junction Transistor. Learning Outcomes 1.The 3 terminals or regions of a BJT. 2.Construction and symbol of NPN and PNP types 3.Low power.

Module 2 Bipolar Junction Transistor. Learning Outcomes 1.The 3 terminals or regions of a BJT. 2.Construction and symbol of NPN and PNP types 3.Low power.
Physics in Action W Richards Worthing High School.

Physics in Action W Richards Worthing High School.
gradually rises from 0 to 9V immediately drops from 9V to 0V

gradually rises from 0 to 9V immediately drops from 9V to 0V
The Transistor A transistor is an automatic switch. It can only be on or off. base emitter collector 0.7 V When the transistor is on, current flows from.

The Transistor A transistor is an automatic switch. It can only be on or off. base emitter collector 0.7 V When the transistor is on, current flows from.
1 Electronics 4.4: Digital Processes Transistors and Digital Electronics Electronics 4.4: Digital Processes.

1 Electronics 4.4: Digital Processes Transistors and Digital Electronics Electronics 4.4: Digital Processes.
1 D & T Design Lesson Sec 3B By: MdmLee Kah Gek Technological Areas - Electronics MacPherson Secondary School.

1 D & T Design Lesson Sec 3B By: MdmLee Kah Gek Technological Areas - Electronics MacPherson Secondary School.
Rd 3 - Electronics 1.Ohm’s Law 2.Potential Divider 3.Resistor in Series and Parallel - Application of Ohm’s Law 4. Operational Amplifier (Comparator and.

Rd 3 - Electronics 1.Ohm’s Law 2.Potential Divider 3.Resistor in Series and Parallel - Application of Ohm’s Law 4. Operational Amplifier (Comparator and.

Similar presentations

Ads by Google