Rates of Change and Limits

Slides:



Advertisements
Similar presentations
Limit and Continuity.
Advertisements

2.4 RATES OF CHANGE & TANGENT LINES. Average Rate of Change  The average rate of change of a quantity over a period of time is the slope on that interval.
Limits and Continuity Definition Evaluation of Limits Continuity
Objective: To define and use the concepts of Rates of Change and Limits Average Speed; During an interval is found by dividing the distance covered by.
Rates of Change and Tangent Lines Section 2.4. Average Rates of Change The average rate of change of a quantity over a period of time is the amount of.
1.3 The limit of a function. A rock falls from a high cliff. The position of the rock is given by: After 2 seconds: average speed: What is the instantaneous.
2.1 Rates of Change and Limits Average and Instantaneous Speed –A moving body’s average speed during an interval of time is found by dividing the distance.
1.2:Rates of Change & Limits Learning Goals: © 2009 Mark Pickering Calculate average & instantaneous speed Define, calculate & apply properties of limits.
Rates of Change and Limits
Copyright © 2007 Pearson Education, Inc. Publishing as Pearson Prentice Hall Slide 2- 1.
EVALUATING LIMITS ANALYTICALLY (1.3) September 20th, 2012.
Rates of Change and Limits
Section 1.6 Calculating Limits Using the Limit Laws.
Copyright © 2007 Pearson Education, Inc. Publishing as Pearson Prentice Hall Slide 2- 1.
Chapter 1 Limit and their Properties. Section 1.2 Finding Limits Graphically and Numerically I. Different Approaches A. Numerical Approach 1. Construct.
Average Speed Example: Suppose you drive 200 miles in 4 hours. What is your average speed? Since d = rt, = 50 mph.
In previous sections we have been using calculators and graphs to guess the values of limits. Sometimes, these methods do not work! In this section we.
Section 2.1 INTRODUCTION TO LIMITS. Definition of a Limit  Limits allow us to describe how the outputs of a function (usually the y or f(x) values) behave.
2-1: RATES OF CHANGE AND LIMITS Objectives: To evaluate limits numerically, graphically, and analytically. To use properties of limits.
Lesson 2-1: Rates of Change and Limits Day #1 AP Calculus Mrs. Mongold.
2.1- Rates of Change and Limits Warm-up: “Quick Review” Page 65 #1- 4 Homework: Page 66 #3-30 multiples of 3,
Basic Differentiation Rules
Math 1304 Calculus I 2.3 – Rules for Limits.
Sullivan Algebra and Trigonometry: Section 4.5 Solving Polynomial and Rational Inequalities Objectives Solve Polynomial Inequalities Solve Rational Inequalities.
What you’ll learn about
Section 5.3(d) Synthetic Substitution. Long division Synthetic Division can be used to find the value of a function. This process is called Synthetic.
Example 3 Solving an Equation Using Addition The solution is ANSWER Original equation 13=4.5c– Add 4.5 to each side. (Addition property of equality)
2.1RATES OF CHANGE AND LIMITS LIMITS. AVERAGE SPEED=DISTANCE/TIME A rock breaks loose from the top of a tall cliff. What is the average speed during the.
Section 11.1 Limits.
Definition of Limit, Properties of Limits Section 2.1a.
3/18/2016Mr. Santowski - Calculus1 Lesson 31 (Day 2) - Limits Calculus - Mr Santowski.
Sullivan PreCalculus Section 3.5 Solving Polynomial and Rational Inequalities Objectives Solve Polynomial Inequalities Solve Rational Inequalities.
Algebra 1 Section 6.1 Solve and graph linear inequalities Inequalities Verbal Algebraically Graphically Inequality signs > greater than < less than > greater.
2.1 Rates of Change & Limits 2.2 Limits involving Infinity Intuitive Discussion of Limit Properties Behavior of Infinite Limits Infinite Limits & Graphs.
CHAPTER 1 : Introduction Limits and Continuity. What is Calculus? Mathematics of motion and change Whenever there is motion or growth, whenever there.
Calculus - Mr Santowski
2.1 Rates of Change and Limits
2-1: rates of change and limits
Sullivan Algebra and Trigonometry: Section 5
Sullivan Algebra and Trigonometry: Section 4.5
Evaluating Limits Analytically
Sec. 1.3: Evaluating Limits Analytically
2.4 Rates of Change & Tangent Lines
Rates of Change and Limits
2.1 Rates of Change and Limits Day 1
Rates of Change and Limits
Rates of Change and Limits
Chapter 2 – Limits and Continuity
Limits An Introduction To: Changing Rates Secant and Tangent Lines &
3.1 Section 2.2 Average and Instantaneous Rate of Change
Test 1: Limit of a Function
10.3 – More on Limits Take a few minutes to review your last test!!
1.2/1.3 Limits Grand Teton National Park, Wyoming.
1.3 Evaluating Limits Analytically
Continuity and Intermediate Value Theorem
Continuity and One-Sided Limits
Packet #4 Definition of the Derivative
Functions, Limits, and the Derivative
Drill: Find the limit of each of the following.
2.4 Rates of Change & Tangent Lines
2.4 Rates of Change and Tangent Lines
2.1 Rates of Change and Limits
Lesson 2.1 Rates of Change & Limits
Drill: Find the limit of each of the following.
Consider the function Note that for 1 from the right from the left
Evaluating Limits Analytically
Rates of Change and Limits
Section 3.2 Day 1 Mean Value Theorem
11.1 Introduction to Limits
2.1 Introduction to Limits
Presentation transcript:

Rates of Change and Limits Section 2.1 Rates of Change and Limits

Average and Instantaneous Speed Definition 1: A moving body’s average speed during an interval of time is found by dividing the distance covered by the elapsed time.

Example 1: Finding an average speed A rock breaks loose from the top of a tall cliff. What is its average speed during the first 2 seconds of fall?

Example 2: Finding an instantaneous speed Find the speed of the rock in Example 1 at the instant t = 2.

Definition of Limit Definition 2: Let c and L be real numbers. The function f has a limit L as x approaches c if, given any positive number ____, there is a positive number ____such that for all x,

TOTD An object dropped from rest from the top of a tall building falls y = 16t² feet for the first t seconds. Find the average speed during the first 4 seconds of fall.

Properties of Limits

Example 3

Example 4

Theorem 2: Polynomial and Rational Functions If any polynomial function and c is any real number, then   If f(x) and g(x) are polynomials and c is any real number, then

Example 5: Determine the limit by substitution

Example 6: Determine the limit by substitution

Example 7: Determine the limit by substitution

Example 8: Using the Product Rule:

Example 9: Explain why you cannot use substitution to determine the limit. Find the limit if it exists.

Example 10: Explain why you cannot use substitution to determine the limit. Find the limit if it exists.

TOTD Determine the limit by substitution. lim 𝑥→−1/2 3 𝑥 2 (2𝑥−1)

Example 11: Determine the limit graphically. Confirm algebraically.

Example 12: Determine the limit graphically. Confirm algebraically.

One-sided and Two-sided Limits Right-hand: Left-hand:

Example 13: Function values approach two numbers

Theorem 3: One-sided and Two-sided Limits A function f(x) has a limit as x approaches c if and only if the right-hand and left-hand limits at c exist and are equal. In symbols,

Example 14: Exploring right- and left-handed limits

TOTD Determine the limit algebraically. lim 𝑥→2 𝑥 2 −3𝑥+2 𝑥 2 −4

Assignment!!!! Page 66 #4 – 10, 15, 16, 18 – 21, 29, 37