Functionality Calibrates Bump Tests Charges Prints certificates 2-button operation

Standard Configurations M40 only version M40/SP40 pump version 6 unit versions All configurations

Calibrations Initiated by pushing and holding CAL button Approximately 2 minutes Real time readings on M40 Display Pass/Fail LED Cal certificate automatically generated Stores up to 150 records before over-write

Bump Tests Initiated by pushing BUMP button Performs a true “Found As” test 90 seconds of gas, 85% of span reading Pass/fail (LED) Bump certificate automatically generated

Calibration/Bump Certificates Generated after each bump or calibration Stored in onboard non-volatile memory Contains serial number, time, date, sensor information, pass/fail, span values, bump values (for bump tests).

Optional Printer Automatically prints reports Serial interface Bump reports Calibration reports Prints memory

Six unit versions Available in any configuration Calibrates one “deck” at a time One calibration per connect

M40 Support Software version 4.0 and higher A hardware upgrade is required Service will be offering an upgrade service - $125.00

Pricing and Availability Single unit versions – September 1 Six unit versions – October Single unit = $795.00 Six unit = $1595.00 Kits available October