Points, Lines, and Planes

Slides:



Advertisements
Similar presentations
1.2 Points, Lines, and Planes
Advertisements

1.2 Points, Lines, and Planes 9/10/12
Lesson 1.2 Intro to Geometry.
Warm-Up 2/1/13 Describe any points, lines and planes you see in this picture.
Points, Lines, and Planes
Section 1.3: Points, Lines, and Planes
Chapter 1 Lesson 2 Objective: To understand basic terms and postulates in Geometry.
1-2 Points, Lines and Planes M11.B B
Points, Lines, and Planes Geometry Mrs. King Unit 1, Lesson 2.
Lesson 1: (1.3) Points, Lines, and Planes “Dogs have owners. Cats have staff.” “Dogs feel very strongly that they should always go with you in the car,
Geometry 1-3. Vocabulary A point is an exact location on a plane surface. Workbook – page 6 It has no size. It is represented by a small dot and is named.
1-2 Objective: Today you will learn some basic terms and symbols in geometry so that you will be able to use and name basic shapes and terms. Today is.
Lesson (1.3) Points, Lines, and Planes Students will… understand basic terms. understand basic postulates of geometry. Evidence Outcome: Students will.
Lesson 1.2 Intro to Geometry. Learning Target I can understand basic geometric terms and postulates.
Holt Geometry 1-1 Understanding Points, Lines, and Planes 1-1 Identify Points, Lines, and Planes Holt Geometry Warm Up Warm Up Lesson Presentation Lesson.
Vocabulary Review. Space Set of all points. Postulate An accepted statement of fact.
Geometry 1-2 Points, Lines, and Planes. Vocabulary Point – No size, only location. Represented with a dot. Symbol = Capital Letter Line – Continuous arrangement.
1.2 Points, Lines and Planes Postulate or axiom – an accepted statement of fact. These are the basic building blocks of Geometry.
 TEKS Focus:  (4)(A) Distinguish between undefined terms, definitions, postulates, conjectures, and theorems.  (1)(D) Communicate mathematical ideas,
Points, Lines and Planes Objective: To learn to identify, classify and name points, space, line, collinear points, plane, coplanar, postulate and axiom.
Section 1.2 Points, Lines, and Planes. Objective: Students will be able to: Understand basic terms and postulates of geometry.
Chapter 1 Section 1.
Understanding Points, 1-1 Lines, and Planes Warm Up
1-3: Points, Lines, and Planes
Objectives Identify, name, and draw points, lines, segments, rays, and planes. Apply basic facts about points, lines, and planes.
Understanding Points, 1-2 Lines, and Planes Warm Up
Pre-AP Bellwork Describe what the slope of the line is and how you can calculate it. Use complete sentences.
Questions to Ponder 1-1 & 1-2
Understanding Points, 1-1 Lines, and Planes Warm Up
Understanding Points, 1-1 Lines, and Planes Warm Up
1-2: Points, Lines, and Planes
Points, Lines, and Planes
1.2 Points, Lines, and Planes
WARM UP 1. x ≥ ≤ x ≤ 6 3. x < 1 OR x > 0
Points, lines and planes
Understanding Points, 1-1 Lines, and Planes Warm Up
1-2: Points, Lines, and Planes
Understanding Points, 1-1 Lines, and Planes Warm Up
Understanding Points, 1-1 Lines, and Planes Warm Up
Chapter 1-2 Points, Lines, and Planes
Points, Lines, and Planes
Warm-Up: Common Words What are “common words” we use in everyday conversation? Do you have to think about their meaning? What if you didn’t know these.
Understanding Points, 1-1 Lines, and Planes Warm Up
Understanding Points, 1-1 Lines, and Planes Warm Up
1-1 Understanding Points, Lines, and Planes Holt Geometry.
Understanding Points, 1-1 Lines, and Planes Warm Up
Understanding Points, 1-1 Lines, and Planes Warm Up
Understanding Points, 1-1 Lines, and Planes Warm Up
Objectives Identify, name, and draw points, lines, segments, rays, and planes. Apply basic facts about points, lines, and planes.
Understanding Points, 1-1 Lines, and Planes Warm Up
1-2 Points, Lines, and Planes
Point Line Plane Collinear Coplanar Segment Ray Opposite Rays
Lesson 1-1 Point, Line, Plane
Understanding Points, 1-1 Lines, and Planes Warm Up
Understanding Points, 1-1 Lines, and Planes Warm Up
Lesson 1-1 Point, Line, Plane
Lesson 1-1 Point, Line, Plane
1-1 Vocabulary undefined term point line plane collinear coplanar
Objectives Identify, name, and draw points, lines, segments, rays, and planes. Apply basic facts about points, lines, and planes.
Understanding Points, 1-1 Lines, and Planes Warm Up
Understanding Points, 1-1 Lines, and Planes Warm Up
G1 Point, Line, Plane Point, Line, Plane.
1.1 Identify Points, Lines, and Planes
Warm-up Spend 5 minutes studying for your rules quiz along with looking over your notes from Section 1.1 Objective 1: Check for understanding of rules.
Understanding Points, 1-1 Lines, and Planes Warm Up
Points, lines and planes
Objectives Identify, name, and draw points, lines, segments, rays, and planes. Apply basic facts about points, lines, and planes.
1.1 Identify Points, Lines, and Planes
Chapter 1 Basics of Geometry.
Understanding Points, 1-1 Lines, and Planes Warm Up
Presentation transcript:

Points, Lines, and Planes To understand basic terms of geometry. To understand basic postulates of geometry.

Definitions Point – It is a location in space. A point is represented by a small dot and is named by a capital letter. Space – The set of all points. Line – A series of points that extends in two opposite directions. Collinear points – Points that lie on the same line.

Segment – the part of a line consisting of two end points and all points between them. Ray – the part of a line consisting of one endpoint and all the points of the line on one side of the endpoint. Opposite Rays – two collinear rays with the same endpoint. Opposite rays always form a line.

Example 1 Are points E, F, and C collinear? If so, name the line of which they lie. Are points E, F, and D collinear? If so, name the line of which they lie. n C F m E P D l

Answers Points E, F, and C are collinear. They lie on line m. Points E, F, and D are not collinear. C F m E P D l

Example 1: Naming Segments and Rays Name the segments and rays in the figure at the right. The three segments are LP, PQ, and LQ. The four rays are LP or LQ, PQ, PL, and QP or QL.

Check Understanding Are points F, P, and C collinear? Name line m in 3 other ways.’ Why do you think arrowheads are used when drawing a line or naming a line such as EF? n C F m E P D l

Answers No, not on the same line EF, FC, or CE Arrowheads are used to show that the line extends in opposite directions without end.

More Definitions Plane – It is a flat surface that has no thickness. It contains many lines and extends without end in the direction of all its lines. You can name a plane by either a single capital letter or by at least 3 of its noncollinear points. Coplanar – Points and lines in the same plane are coplanar.

Example 2 Each surface of the ice cube represents part of a plane. Name the plane represented by the front of the ice cube. The front plane can be named by any 3 of these four letters ABFE.

Check Understanding HEF, HEFG, EFG, FGH, and GHE to name a few. List three different names for the plane represented by the top of the ice cube. HEF, HEFG, EFG, FGH, and GHE to name a few.

Basic Postulates of Geometry A postulate or axiom is an accepted statement of fact. You have used some of the following geometry postulates in algebra. For example, you used Postulate 1-1 when you graphed an equation such as y = -2x + 8.You plotted two points and then drew the line through those two points.

Postulate 1-1 Through any two points there is exactly one line. Line t is the only line that passes through points A and B. TWO POINTS DETERMINE A LINE.

Postulate 1-2 If two lines intersect, then they intersect in exactly one point. AE and BD intersect at C. TWO LINES INTERSECT IN A POINT.

Postulate 1-3 If two planes intersect, then they intersect in exactly one line. Plane RST and plane STW intersect in ST. TWO PLANES INTERSECT IN A LINE.

Example 3 They intersect in GF ABFE and BCGF What is the intersection of plane HGFE and plane BCGF? They intersect in GF Check understanding: Name two planes that intersect in BF. ABFE and BCGF

TRIPOD A three-legged stand will always be stable. As long as the feet of the stand don’t lie in one line, the feet of the three legs will lie exactly in one plane

Postulate 1-4 Through any three noncollinear points there is exactly one plane. THREE POINTS DETERMINE A PLANE.

Example 4 Shade the plane that contains A, B, and C. Shade the plane that contains E, H, and C.

Check Understanding a. D b. B Name another point that is in the same plane as points A, B, and C. Name another point that is coplanar with points E, H, and C. a. D b. B

1-2 Quiz The following questions are a review of what we went over today in class. They are designed to help you assess for yourself whether or not you understood today’s lesson. If you do not do well and miss several of the questions it might be a good idea to come in and get some help!

1. Are O, N, and P collinear? If so, name the line on which they lie. Yes, they lie on the line MP. Yes, they lie on the line NP. Yes, they lie on the line MO. No, the three points are not collinear. Non-Response Grid

2. Name the line and plane shown in the diagram. RS and plane RSU Line R and plane RSU RS and plane UR SR and plane UT Non-Response Grid

3. What is the intersection of plane TUYX and plane VUYZ? TX SW UY VZ Non-Response Grid

4. Name a fourth point in plane TUW. Y Z W X Non-Response Grid

5. Plane ABC and plane BCE ____ be the same plane. must may cannot Non-Response Grid

Assignment 1-2 # 1 - 26 all