Injection direction This area is OK , because the pin into the tube have a supporting point in this area . The injection force push the pin to the other side and out of middle position , so the part was not fulfilled over here. See next page for details .

left This area have defect middle This area have defect right This area is OK

The pin have not a supporting point in this area . We are changing the gate location now , And we will try to inject again in the afternoon . Injection direction TUBE The injection force push the pin to the other side and out of middle position , so the part was not fulfilled over here. The pin have not a supporting point in this area .

assembly Have a few gap

Inner diameter is 1.46119 inch outer diameter is 1.445 inch The gap of assembly from your drawing is 0.41 mm