Dual Power Supply Design Industrial Attachment Training-2017

Slides:



Advertisements
Similar presentations
TUTORIAL 3 Q1 Draw and label a block diagram the elements of a DC power supply which receives an input from the 240 V; 50 Hz mains and produces an output.
Advertisements

Regulated Linear Power Supply
Diode.
Module 1: Part 2 Diode Circuits. Learning Objectives After studying this module, the reader should have the ability to: n In general, apply the diode.
Electronic Circuits POWER SUPPLIES.
Harmonic Reduction in the Utility Interface SCR Rectifier
POWER SUPPILES LECTURE 20.
By S K Rai Electronics Engineering Department BKBIET, CEERI Road Pilani (Raj.)
CHAPTER 6 VOLTAGE REGULATOR POWER SUPPLIES (VOLTAGE REGULATORS) Fig. 6.1 Block diagram showing parts of a power supply. Power supply Power supply: a.
CHAPTER 18 Power Supplies. Objectives Describe and Analyze: Power Supply Systems Regulation Buck & Boost Regulators Flyback Regulators Off-Line Power.
Dc regulated power supply SKN. Introduction All electronic circuits need DC power supply either from battery or power pack units. Many electronic equipment.
James Mackey Fundamentals of Power Supplies. James Mackey RectifierFilterRegulator AC Input AC Rectified (Pulsating DC) Smoothed DC Smoothed & Regulated.
Parul Institute of Engineering & Technology Name of Unit : Diode And Its Applications___________ Topic : BRIDGE RECTIFIER_________________________ Name.
Rectification. AC to DC Electricity distribution –Power stations –Transformers –Transmission lines AC Electronics DC –Smooth –Stable.
2-1 McGraw-Hill Copyright © 2001 by the McGraw-Hill Companies, Inc. All rights reserved. Chapter 2 Diode Circuits.
Half wave rectification By:Engr.Irshad Raheem Memon.
Bridge full wave rectification. By:Engr.Irshad Rahim Memon
PRACTICAL # 05 Full wave rectification using center tapped transformer. By:Engr.Irshad Raheem Memon.
1 ELCT Class performance (Quizzes 1&2 and Midterm)
EMT212 Analog Electronic II
Regulated Power Supplies
Power Supply The basic function of power supply is to convert the AC supplies available at wall socket, that which is unusable by the computer. The SMPS.
Full-wave rectification
1.0 LINEAR DC POWER SUPPLY The importance of DC Power Supply Circuit For electronic circuits made up of transistors and/or ICs, this power source.
Basic Equipment and Schematic Reading. Objectives Learn the basic equipment that will be used in the Lab. Learn some of the basic symbols used on electrical.
Zener Diode Circuits for Power Supply Designs Section 4.4.
1 Electrical Fundamentals We need some understanding of electrical fundamentals to do the lab exercises. Electric Circuit Consists of: –Power Source: Battery,
Diode Rectifier Circuits Section 4.5. In this Lecture, we will:  Determine the operation and characteristics of diode rectifier circuits, which is the.
Self Switching Power Supply. Introduction Self Switching Power Supply  Embedded system requires a regulated power supply.
Single Phase Induction Motor Speed Control. Introduction Single Phase Induction Motor Speed Control  Induction motors are.
Amateur Radio Licensure Week 5: Advanced Electronics Seth Price, N3MRA New Mexico Institute of Mining and Technology February 28, 2016.
Chapter 1 Common Diode Applications Basic Power Supply Circuits.
Bridge Rectifier Circuit with Working Operation and Their Types.
Chapter 3 – Diode Circuits – Part 3
Basic Electricity END Alternators. 2 WHAT DOES AN ALTERNATOR DO? -IT GENERATES ELECTRICAL CURRENT -IT CONVERTS ALTERNATING CURRENT TO DIRECT CURRENT -IT.
RAIN ALARM WITH AIR FLOW DETECTOR
Chapter 6: Voltage Regulator
Presented by Under the esteemed guidance of D.GANGADHAR REDDY, M. Tech. Asst. Prof., EEE Department UNIVERSAL COLLEGE OF ENGINEERING & TECHNOLOGY AUTO.
SINGLE PHASE INDUCTION MOTOR SOFT START BY STEPPED DELAY OF REDUCING FIRING ANGLE Submitted by:
Single Phase Induction Motor Speed Control
Center tap Full-Wave Rectifier.
Presentation 3: Detailed Design and DFM considerations
LOW VOLTAGE DC TOHIGHER VOLTAGE DC UP 6 VOLT DC TO 10 VOLT DC USING 555 TIMER SUBMITTED BY.
Rectifiers, Filters and Regulator
Power Supply Design Industrial Attachment Training-2017 Presented By:
CHAPTER 6 VOLTAGE REGULATOR Tulus Ikhsan Nasution.
Circuit Simulation Training
Chapter 27 Power Supplies.
INDUCTION MOTOR PROTECTION FOR SINGLE PHASING, OVERVOLTAGE AND OVER TEMPERATURE Submitted by:
SOFT START OF SINGLE PHASE PUMP MOTOR
Prepared By: Talar Upendra ( ) Sodha Akram ( )
AC Inlet & AC Input Filter
Fault detection Lecture (3).
OER creation M.Deeparani and K.Faisal MCET
PC CONTROL USING TV REMOTE
Rectification and Diodes
CHAPTER 10 Power Supplies.
Power Supplies AIM: To understand the simple power supply in terms of the transformer, rectification, smoothing and regulation. PRIOR KNOWLEDGE: A.C.
PHASE SEQUENCE CHECKER
Prepared by: Engr. Qurban Ali Memon Incharge of Final project Lab.
Lecture No# 8 Prepared by: Engr. Qurban Ali Memon
Single-Phase Uncontrolled Rectifiers Chp#5
Dr. Unnikrishnan P.C. Professor, EEE
Lecture No# 3 Prepared by: Engr. Qurban Ali Memon
Figure 2.43 Full-wave voltage doubler.
Lecture No# 4 Prepared by: Engr. Qurban Ali Memon
PN Junction Diode as Rectifier
Radhabai Kale mahila mahavidyalaya,ahmednagar Department of Physics
Rectifiers.
Presentation transcript:

Dual Power Supply Design Industrial Attachment Training-2017 Presented By: Engr. Shah Mim Obydulla B.Sc in EEE (DUET) Director of Rainbow Automation Rainbow Automation Industrial Attachment Training-2017

Industrial Attachment Training-2017 Circuit Diagram I/P 220V AC O/P 12V*2 , 3000mA Bridge Rectifier Pulse sating dc ac + dc Pure dc IC1 1 3 7812 +12V + _ 2 C1 1000uf 50V Pulse sating dc ac + dc 0V Transformer + _ C2 1000uf 50V IC2 7912 2 1 3 -12V Pure dc Fig: Circuit Diagram Of Dual Power Supply Rainbow Automation Industrial Attachment Training-2017

Industrial Attachment Training-2017 I/P 220V AC O/P 12V*2 , 3000mA Bridge Rectifier IC1 1 3 7812 +12V + 2 C1 1000uf 50V _ 0V + C2 _ 1000uf 50V 1 Transformer 2 3 7912 -12V IC2 Necessary Equipment Transformer (12V x2 ,3000mA)------01pcs Soldering Stand-----------------01pcs Diode (IN4007)-------------------------04pcs Soldering Lead (as per requirement) Capacitor (1000µF/50V)-------------02pcs Soldering Rosin (as per requirement) Regulator (IC 7812 & 7912)---------02pcs Safety Goggle ------------------01 pcs DC Load (Fan-12V)--------------------01pcs Connecting Wire (as per requirement) Multimeter ----------------------------- 01pcs Wire Stripper (as per requirement) Soldering Iron---------------------------01pcs Masking Tape (as per requirement) Rainbow Automation Industrial Attachment Training-2017

Industrial Attachment Training-2016 Transformer A.C Input 220V A.C O/P 12V A.C Input 220V 0V A.C O/P 12V A.C Output Fig: Transformer Fig: Transformer Symbol Rainbow Automation Industrial Attachment Training-2016

Anode Cathode Diode Industrial Attachment Training-2017 Fig: Diode Fig: Diode Symbol Rainbow Automation Industrial Attachment Training-2017

Industrial Attachment Training-2017 Bride Rectifier 1st Step 2nd Step 3rd Step Fig: Bridge Rectifier Making Process Rainbow Automation Industrial Attachment Training-2017

- - Capacitor + + Industrial Attachment Training-2017 Fig: Capacitor Fig: Capacitor Symbol Rainbow Automation Industrial Attachment Training-2017

Voltage Regulator IC 780XX 1 2 3 Input GND Output Fig: Voltage Regulator IC 7812 Fig: Voltage Regulator IC Chart Rainbow Automation Industrial Attachment Training-2017

Voltage Regulator IC 79XX L7912 CV 1 2 3 GND INPUT OUTPUT Fig: Voltage Regulator IC Fig: Voltage Regulator IC Symbol Rainbow Automation Industrial Attachment Training-2017

Industrial Attachment Training-2017 DC Load Fig: Cooling Fan & Lamp e.t.c Rainbow Automation Industrial Attachment Training-2017

Industrial Attachment Training-2017 Wiring Diagram Input AC 220 V L7912 CV Fig: Wiring Diagram of Dual Power Supply Rainbow Automation Industrial Attachment Training-2017

Industrial Attachment Training-2017 Rainbow Automation Industrial Attachment Training-2017