1. 1 MOMENTUM 3800 RC ASSEMBLY INSTRUCTIONS PART NUMBER 27697

2. 2 ASSEMBLY INSTRUCTIONS TOOLS REQUIRED: CLAW HAMMER KNIFE 1. USE KNIFE TO CUT AND REMOVE PLASTIC STRAPS. PLASTIC STRAPS 2. USE CLAW HAMMER TO REMOVE STAPLES AT BOTTOM AND BOTH SIDES OF CARTON. REMOVE AND DISCARD CARTON. STAPLE LOCATIONS

3. 3 ASSEMBLY INSTRUCTIONS 3. REMOVE PLASTIC COVER FROM BIKE AND PALLET, DISCARD PLASTIC COVER. PLASTIC COVER 4. REMOVE BUBBLE PACK FROM SEAT OF BIKE. BUBBLE PACK

4. 4 ASSEMBLY INSTRUCTIONS 5. REMOVE BUBBLE PACK TO EXPOSE CONTENTS. CONSOLE CONSOLE KNOBS CHARGER CARTON HARDWARE BAG MAGAZINE RACK 6. REMOVE CONTENTS OF HARDWARE BAG. HARD WARE BAG

5. 5 ASSEMBLY INSTRUCTIONS 7. THE BAG CONTAINS TWO LEVELING PADS AND INSTRUCTIONS FOR INSTALLATION OF LEVELING PADS. INSTALLATION INSTRUCTIONS LEVELING PADS 8. OPEN CARTON IDENTIFIED AS “CHARGER”. IT CONTAINS CHARGER, BAG OF SPARE PUSH RIVETS, RIVET REMOVAL TOOL, AND OWNER’S MANUAL. CARTON CHARGER OWNER’S MANUAL BAG OF SPARE PUSH RIVETS RIVET REMOVAL TOOL

6. 6 ASSEMBLY INSTRUCTIONS 9. REMOVE BUBBLE PACK FROM CONSOLE BRACKET. BUBBLE PACK 10. GET CONSOLE AND MAGAZINE RACK, POSITION RACK IN GROOVES IN REAR OF CONSOLE. CONSOLE MAGAZINE RACK

7. 7 ASSEMBLY INSTRUCTIONS 11. LOOSEN THE TOP TWO KNOBS IN CONSOLE. REMOVE THE BOTTOM TWO KNOBS FROM CONSOLE. HOLD THE MAGAZINE RACK INTO GROOVES IN THE REAR OF THE CONSOLE. ATTACH TWO FEMALE CONNECTORS LOCATED IN CONSOLE HANDLE ASSEMBLY TO THE CORRESPONDING MALE CONNECTORS AT THE REAR OF CONSOLE. BE SURE TO POSITION THE CONNECTORS CORRECTLY WITH THE ALIGNING TAB ON THE FEMALE CONNECTOR WITH THE ALIGNING SLOT ON THE MALE CONNECTOR. CONSOLE TOP KNOB MAGAZINE RACK BOTTOM KNOB LOCATION CABLES 12. SLIDE TOP TWO KNOBS INTO SLOTS LOCATED IN THE CONSOLE BRACKET WHILE HOLDING MAGAZINE RACK AGAINST THE CONSOLE. CAUTION-DO NOT PINCH CABLES BETWEEN CONSOLE AND CONSOLE ASSEMBLY HANDLE. CONSOLE SLOT IN CONSOLE BRACKET TOP KNOB CONSOLE BRACKET

8. 8 ASSEMBLY INSTRUCTIONS 13. INSTALL TWO KNOBS IN THE CONSOLE’S BOTTOM TWO HOLES TO SECURE THE CONSOLE TO THE CONSOLE HANDLE ASSEMBLY. TIGHTEN ALL KNOBS FINGER TIGHT. REMOVE PROTECTIVE STRETCH WRAP FROM CONSOLE. BOTTOM KNOB 14. USE CLAW HAMMER TO REMOVE WOODEN BLOCKS SECURING BIKE TO PALLET. REMOVE BIKE FROM PALLET. REMOVE ANY REMAINING PACKING MATERIAL FROM BIKE. SEE OWNER’S MANUAL FOR SET UP AND OPERATING INSTRUCTIONS. WOODEN BLOCKS 15. REFER TO THE INSTRUCTIONS THAT WERE IN THE HARDWARE BAG AND INSTALL THE TWO LEVELING PADS.