1. Motor Mounting MECH1200 Foot Mount: Simple and common Tabs or feet that are attached at the four corners of the motor and attaches to a bedplate. Sometimes welded

2. Motor Mounting MECH1200 C-Face Mount : Has a special face that has a flange and bolt holes. Motor is directly mounted to the component Common with turbine pumps and gearbox’s

3. Motor Mounting MECH1200 Adjustable Motor Base: It’s own bedplate that contains a screw that can adjust the level of the motor Used when changing the position of the motor to adjust tension on a belt or chain drive

4. Motor Mounting MECH1200 When mounting the Motor

5. Motor Mounting MECH1200 Diameter: The bolt size should be chosen to be as large as possible, with a little wiggle room. A 7/16” bolt could be used for a ½” hole.

6. Motor Mounting MECH1200 Grade: 5 or 8 (heavy) Grade is read based on raised lines

7. Motor Mounting MECH1200 Thread Type: Course thread type (UNC) is commonly used, it has fewer threads per inch than fine thread type (UNF). Course is easier to assemble and disassemble Length: Thickness of parts, washers and nuts. Next larges size, usually ¼ to ½

8. Motor Mounting MECH1200 Washer Thickness: Measuring them or catalog specification Lock Washer

9. Motor Mounting MECH1200 Nut thickness/Grade: Depends on bolt size Equal the root diameter of the bolt’s thread Same Grade as the bolt