1. Dr Simin Nasseri, SPSU Tutorial: Flange Chapter 1 Dr Simin Nasseri, SPSU Copyright of Howard and Musto, 2009

2. Dr Simin Nasseri, SPSU Tutorial Learning Objectives Become familiar with the SolidWorks part modeling environment Use these features: extruded boss/base, extruded cut, circular pattern, fillet, and chamfer Learn how to create a new plane Learn to consider the design intent when planning a model INTRODUCTION TO SOLID MODELING USING SOLIDWORKS 2009

3. Dr Simin Nasseri, SPSU Geometry of Flange INTRODUCTION TO SOLID MODELING USING SOLIDWORKS 2009

4. Dr Simin Nasseri, SPSU Feature 1 – Extruded Base INTRODUCTION TO SOLID MODELING USING SOLIDWORKS 2009

5. Dr Simin Nasseri, SPSU Feature 2 – Construction Plane INTRODUCTION TO SOLID MODELING USING SOLIDWORKS 2009

6. Dr Simin Nasseri, SPSU Feature 3 – Extruded Boss INTRODUCTION TO SOLID MODELING USING SOLIDWORKS 2009

7. Dr Simin Nasseri, SPSU Feature 4 – Extruded Cut INTRODUCTION TO SOLID MODELING USING SOLIDWORKS 2009

8. Dr Simin Nasseri, SPSU Feature 5 – First Bolt Hole INTRODUCTION TO SOLID MODELING USING SOLIDWORKS 2009

9. Dr Simin Nasseri, SPSU Feature 6 – Circular Hole Pattern INTRODUCTION TO SOLID MODELING USING SOLIDWORKS 2009

10. Dr Simin Nasseri, SPSU Feature 7 - Fillets INTRODUCTION TO SOLID MODELING USING SOLIDWORKS 2009

11. Dr Simin Nasseri, SPSU Feature 8 - Chamfer INTRODUCTION TO SOLID MODELING USING SOLIDWORKS 2009

12. Dr Simin Nasseri, SPSU Design Intent – Planning the Model Example: Creation of the construction plane to allow draft on the extruded base Design intent is the consideration of the end use of a part, and possible changes to the part, when creating a solid model. INTRODUCTION TO SOLID MODELING USING SOLIDWORKS 2009

13. Dr Simin Nasseri, SPSU Design Intent – Selecting a Modeling Technique When adding the fillets, they can be added in one step or in three separate steps If you want to be able to change all three simultaneously, use the first method If you want to be able to change each fillet individually, use the second method Always keep in mind the intended use and possible modifications when considering how to create the model INTRODUCTION TO SOLID MODELING USING SOLIDWORKS 2009