1. Steps To Configure One Sensor Gary Tipton

2. The Hardware: Retro-reflective Photo Sensor

3. Actual Sensor

4. Device Box

5. To Configure the sensor: Open up RS Logix software and select Device Net. Perform a scan of the system to see if the system recognizes any items in it’s network. After the device has been observed by the master, than a new address could be assigned to the device.

6. A better look:

7. Screen shot

8. A New Address: Right click on the device that you want to give a new address to. Select properties The device information can be manipulated from there. Re-scan to ensure the new address takes

9. Properties

10. Name and Address

11. Re-Scan