2. Option A - Wave Phenomena Standing Waves, Resonance, Doppler Effect, Diffraction, Resolution, Polarization

3. Standing Waves Standing Waves are produced when interference occurs - the waves that meet: Have the same amplitude Have the same frequency Are traveling in opposite directions

4. Standing Waves Nodes - points at rest Antinodes - points where maximum movement takes place Wave pattern remains fixed in space

5. Sketches:

7. Stationary WaveNormal (Traveling) Wave Amplitude Frequency Wavelength Phase Energy All points reach the same amplitude Amplitude reached varies from 0 to A All points oscillate with same frequency Energy stays within wave Energy is transmitted All points between nodes are moving in phase Points have different phases Twice the distance between nodes Shortest distance between two points in phase All points oscillate with same frequency

8. Resonance A system can be forced to vibrate at any frequency System has its own natural frequency of vibration. Resonance occurs when system is forced to vibrate at its natural frequency - amplitude of oscillation grows and energy reaches a maximum

9. Boundary Conditions Boundary conditions at the edges of standing wave define the resonant mode of the system

10. Transverse waves on a string String is fixed at both ends, ends are nodes and cannot oscillate Both ends reflect, creating a standing wave

11. Resonance mode with lowest frequency is called the fundamental frequency or first harmonic Higher resonant modes are harmonics Example - stringed musical instruments

13. Longitudinal Sound waves in a Pipe Column of air enclosed in a pipe Boundary conditions define system Closed end is node, open end is antinode Pressure is maximum at antinodes, minimum at nodes Musical instruments - flute, trumpet, organ pipes

14. Air column closed at one end

15. Air column open at both ends

16. Closed at one end - can only produce odd harmonics Open at both ends -can produce all harmonics

17. Example: An organ pipe (open at one end) is 1.2 meters long. Calculate the fundamental frequency. The speed of sound is 330 ms -1.

18. Solution:

19. The Doppler Effect Apparent change in frequency Results from relative movement between source and observer

20. Doppler Effect

21. Red Shift/Blue Shift

22. Equations: Where v is relative speed between source and observer, and c is speed of light

23. moving source moving observer

24. Example: The frequency of a car’s horn is measured by a stationary observer as 200 Hz when the car is at rest. What frequency will be heard if the car is approaching the observer at 30 ms -1 ? (Speed of sound in air is 330 ms -1 )

25. Solution:

26. Diffraction Waves pass through narrow apertures (openings) and spread out Extent of spreading depends on size of aperture compared to wavelength Narrow aperture behaves like a point source

29. For a single slit - the angle at the first minimum depends on wavelength and width of slit, b

30. Huygens’ Principle and Diffraction Each point on a wave acts as a source of a new wave

31. Huygens’ Principle and Diffraction Since the angle is small:

32. Circular Aperture b is diameter of aperture (opening) Angle of first minimum

33. Rayleigh Criterion Two sources close together are seen as one single source of light If the eye can tell the sources apart, they are resolved Appearance of light sources depends on diffraction If two sources are just resolved, the first minimum of one diffraction pattern is on top of the first maximum of the other.

34. Rayleigh Criteria Diagrams

35. Just Resolved: If two sources are just resolved, the first minimum of one diffraction pattern is on top of the first maximum of the other.

38. Example Late one night, a student was approaching from a long distance away. She noticed that when she first observed the headlights of the car, they appeared to be one point of light. Later, when the car was closer, she was able to see two separate points of light. If the wavelength of the light is 500 nm and the diameter of her pupil is 4mm, calculate how far away the car was when she could first distinguish two points of light. The distance between the headlights is 1.8 m.

39. Solution: Since angle is small:

40. Polarization Polarized light - oscillating electric and magnetic fields at right angles to each other Transverse waves are vibrating in a “plane of vibration” Waves are oriented in an infinite number of ways

43. Unpolarized light - planes vary randomly Polarized light - fixed plane of vibration Light can be partially polarized, or can be circularly polarized (rotates uniformly) Most sources of light are unpolarized Radio waves, radar, microwaves are polarized

44. “Head on” view of polarization

45. Brewster’s Law Light is reflected and refracted Reflected ray can be partially polarized If reflected ray is completely polarized, it is perpendicular to the refracted ray The angle of incidence is called the polarizing angle when reflected and refracted ray are perpendicular

46. Brewster’s Law Diagram

47. Brewster’s Law Equation When incident medium is air: When incident medium isn’t air:

48. Malus’ Law Measures the reduction in intensity of light due to polarization Light is polarized by an analyzer Intensity of light is proportional to amplitude

49. Malus’ Law Equation

50. Uses of polarization Polarized sunglasses - reduced light intensity due to partial horizontal polarization (axis oriented 90° to plane of reflected light), reduce glare by absorbing some reflected light Determining concentration of solutions - plane of polarization rotates depending on concentration of solution

51. Stress analyses - polarized white light passes through plastics and glass, regions of maximum stress identified by brightly colored lines Liquid-crystal displays (LCD’s) - calculator displays and computer monitors - can be made to appear brighter or darker depending on degree of polarization