Presentation is loading. Please wait.

Presentation is loading. Please wait.

Serial Data Link on Advanced TCA Back Plane M. Nomachi and S. Ajimura Osaka University, Japan CAMAC – FASTBUS – VME / Compact PCI What ’ s next?

Similar presentations


Presentation on theme: "Serial Data Link on Advanced TCA Back Plane M. Nomachi and S. Ajimura Osaka University, Japan CAMAC – FASTBUS – VME / Compact PCI What ’ s next?"— Presentation transcript:

1 Serial Data Link on Advanced TCA Back Plane M. Nomachi and S. Ajimura Osaka University, Japan CAMAC – FASTBUS – VME / Compact PCI What ’ s next?

2 RT2005 Nomachi, M.2 CAMAC crate Downsizing (Rack-Crate-Module-Chip-) CPU BUS module

3 RT2005 Nomachi, M.3 Module Downsizing (Rack-Crate-Module-Chip-) Is CPU at right place? Should we have parallel BUS on board? Do we still need crate? CPU BUS FPGA Network Interface Questions

4 RT2005 Nomachi, M.4 Functionality of a CPU Data readout –Register/memory access –Block transfer Data processing –Application dependent Network protocol –TCP/IP etc. –It is indispensable function for network DAQ. CPU sits at the boundary between memory mapped I/O and network

5 RT2005 Nomachi, M.5 Rack Crate Module Chip Memory Mapped I/O CPU Network DAQ architecture Memory Mapped I/O CPU Network CPU Network

6 RT2005 Nomachi, M.6 Rack Crate Module Chip Memory Mapped I/O CPU Network DAQ architecture We choose memory mapped I/O in a crate. It makes easy to maintain CPU. There were many bad experiences on embedded CPUs.

7 RT2005 Nomachi, M.7 Downsizing the interconnections Parallel bus on board –Occupy large area –Need many pins Serial data link will be a solution –It can be low noise/low power Less number of drivers –It may have longer latency 1 ns – 100 ns. Memory mapped I/O over serial data link.

8 RT2005 Nomachi, M.8 SpaceWire Remote Memory Access Protocol (RMAP) SpaceWire was presented by S. Parkes. –RMAP is a protocol on the SpaceWire standard. –Register access has large overhead. –Block transfer works almost full speed. –It meets the requirements. Good enough. –PCI express and the other protocol may also meet the requirements. However, they may use too much logic (x10) for front-end FPGAs.

9 RT2005 Nomachi, M.9 Do we need crate? Serial data link is very flexible. –System with no crate is possible. Functionality of crates: 1.Mechanical Housing / Shielding 2.Power supply 3.Cooling –We need a crate. VME –6U is too small –Power is a problem on VME. -5.2V etc.

10 RT2005 Nomachi, M.10 Advanced TCA Features (ATCA was presented by B. Martin and S. Dhawan) –-48V DC power supply and on board DC converter for any voltages required. –8U x 280 mm –Dual Star point to point differential connection –No definite protocol. VME back plane is for VME protocol. While, ATCA back plane is only defined as 100 ohm differential. Any protocol can use ATCA back plane. ( for example, ATCA for physics instrumentation)

11 RT2005 Nomachi, M.11 Read out module Trigger module Front-end module DAQ system Front-end Pipe-line buffer readout buffer Trigger logic Trigger control Global trigger Readout control network Second level trigger CPU To event builder

12 RT2005 Nomachi, M.12 Dual star connection Trigger module Read out module Front-end module Front-end module Front-end module Front-end module Front-end module Asynchronous signals (4 links) Trigger/Reset Local trigger/Busy SpaceWire link (4 links) CPU (T-kernel)

13 RT2005 Nomachi, M.13 There are 4 ports for one channel. One port has one output and one input. In order to make signal extraction easy, 2 ports are used. (SpW uses 2 ports) The other 2 ports are to extend band width. It makes possible to use 4-layers PCBs.

14 RT2005 Nomachi, M.14 Trigger module 16 LVDS in 16 LVDS out 8 NIM in 8 NIM out Power consumption is about 10W Cyclone EP1C12 for trigger logic Cyclone EP1C6 for SpW 100Mbps SpW

15 RT2005 Nomachi, M.15 500 MHz FADC Cyclone EP1C6 (cheaper than 40 Euro) Cyclone EP1C12 for router 100Mbps SpW (8~9 MB/s from the module) Readout buffer with 128Mb SDRAM waiting second level trigger 8 ch analog input FADC mezzanine card is developed at KEK (FINESSE format) Power consumption is About 20W

16 RT2005 Nomachi, M.16 ATCA crate One crate holds 96ch of 500MHz FADCs. Total power is expected to be 260 W.

17 RT2005 Nomachi, M.17 Summary SpaceWire Remote Memory Access Protocol provides compact and flexible interconnection in a module and inter- module connection. Advanced TCA provide dual star LVDS connections. They are good to be applied for DAQ system Downsizing may continue. –We might have another solution in the future.


Download ppt "Serial Data Link on Advanced TCA Back Plane M. Nomachi and S. Ajimura Osaka University, Japan CAMAC – FASTBUS – VME / Compact PCI What ’ s next?"

Similar presentations


Ads by Google